Inhaltszusammenfassung zur Seite Nr. 1
SET UP
MENU
Filename [DR-MV1SEK_01Cov1.fm]
DR-MV1SEK_01Cov1.fm Page 1 Friday, April 23, 2004 10:14 AM
DVD VIDEO RECORDER &
VIDEO CASSETTE RECORDER
DR-MV1S/
DR-MV1B
CABLE/DBS TV DVD
TV/CBL/DBS
VCR DVD VCR
TIMER TIMER /DVD /DVD
NUMBER NUMBER / / T TV CH V CH // D DVD CH VD CH
1 2 3
ABC DEF
4 5 6
GHI JKL MNO
7 8 9
PQRS TUV WXYZ
0
CANCEL AUX MEMO/MARK
PROG/CHECK DISPLAY ON SCREEN
VCR PLUS+ PROGRESSIVE
SCAN
ENTER
PREVIOUS NEXT
SLOW PLAY/SELECT SLOW
STOP/ CLEAR PAUS
Inhaltszusammenfassung zur Seite Nr. 2
Filename [DR-MV1SEK_02Safety.fm] Masterpage:Left0 DR-MV1SEK_00.book Page 2 Thursday, April 15, 2004 3:30 PM SAFETY FIRST 2 EN IMPORTANT: Safety Precautions 8 Please read the various precautions on pages 2 − 4 before installing or operating the unit. The rating plate and the safety caution are on the rear of the unit. 8 It should be noted that it may be unlawful to re-record pre- WARNING: DANGEROUS VOLTAGE INSIDE recorded tapes, DVDs, or discs without the consent of the WARNING: TO PREVENT F
Inhaltszusammenfassung zur Seite Nr. 3
Filename [DR-MV1SEK_02Safety.fm] Masterpage:Right+ DR-MV1SEK_00.book Page 3 Thursday, April 15, 2004 3:30 PM SAFETY FIRST EN 3 MOISTURE CONDENSATION The STANDBY/ON 1 button does not completely shut off Moisture in the air will condense on the unit when you move it from mains power from the unit, but switches operating current on and a cold place to a warm place, or under extremely humid off. “`” shows electrical power standby and “!” shows ON. conditions—just as water droplets form on the
Inhaltszusammenfassung zur Seite Nr. 4
Filename [DR-MV1SEK_02Safety.fm] Masterpage:Left+ DR-MV1SEK_00.book Page 4 Thursday, April 15, 2004 3:30 PM SAFETY FIRST 4 EN Some Do’s And Don’ts On The Safe Use Of Equipment This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. DO read the operating instructions before you attempt to use the equipment. DO ensure that all electrical con
Inhaltszusammenfassung zur Seite Nr. 5
Filename [DR-MV1SEK_02Safety.fm] Masterpage:Right0 DR-MV1SEK_00.book Page 5 Thursday, April 15, 2004 3:30 PM EN 5 Features of this unit This unit allows you various types of playback and recording because this unit has two tuners. Record programmes on both DVD deck and VCR deck Operate the DVD deck while recording on the VCR deck simultaneously 1 Start recording on the VCR deck. ( pg. 54) 1 Start recording on the DVD deck. ( pg. 42) 2 Press VCR/DVD. 2 Start recording on the VCR deck. ( pg
Inhaltszusammenfassung zur Seite Nr. 6
Filename [DR-MV1SEK_02Safety.fm] Masterpage:Left0 DR-MV1SEK_00.book Page 6 Thursday, April 15, 2004 3:30 PM CONTENTS 6 EN DISC INFORMATION 7 SUBSIDIARY SETTINGS 80 About Discs ...................................................................................7 Mode Set (DVD Deck) ................................................................ 80 Mode Set (VCR Deck) ................................................................ 82 ® INDEX 12 VIDEO Plus+ System Setup ........................
Inhaltszusammenfassung zur Seite Nr. 7
Filename [DR-MV1SEK_03DiscInfo.fm] Masterpage:Right0 DR-MV1SEK_00.book Page 7 Thursday, April 15, 2004 3:30 PM DISC INFORMATION EN 7 DVD-R/RW Discs About Discs It is only possible to use DVD-R discs which conform with DVD-R standard Version 2.0. When a DVD-R/RW disc (Video mode) is finalised ( pg. 88), it Recordable/playable Discs can be played back on a standard DVD player as a DVD VIDEO You can use discs with the following logos for recording and disc. playback. When a DVD-RW disc (VR
Inhaltszusammenfassung zur Seite Nr. 8
Filename [DR-MV1SEK_03DiscInfo.fm] Masterpage:Left+ DR-MV1SEK_00.book Page 8 Thursday, April 15, 2004 3:30 PM DISC INFORMATION 8 EN Discs For Playback Only Unplayable Discs You can use discs with the following logos for playback only. The following types of discs cannot be played using this unit. Do not attempt to play back any kind of disc that is damaged DVD VIDEO Video CD/Super Video CD (cracked, warped, or repaired with adhesive tape) or discs in unusual shapes (heart-shaped, octagonal,
Inhaltszusammenfassung zur Seite Nr. 9
Filename [DR-MV1SEK_03DiscInfo.fm] Masterpage:Right+ DR-MV1SEK_00.book Page 9 Thursday, April 15, 2004 3:30 PM DISC INFORMATION EN 9 Audio CD/Video CD/SVCD Recording Medium And Format Typically, Audio CD discs are divided into separate tracks each DVD-RAM containing one song. Each track is assigned a number. For ● Recording and erasing can be performed as many times as possible example, the third track is Track 3. The same is true for Video CD/ on a disc. SVCD discs. ● Editing can be perfo
Inhaltszusammenfassung zur Seite Nr. 10
Filename [DR-MV1SEK_03DiscInfo.fm] Masterpage:Left+ DR-MV1SEK_00.book Page 10 Thursday, April 15, 2004 3:30 PM DISC INFORMATION 10 EN DVD VIDEO Marks Placing A Disc Sometimes marks are printed on a DVD disc and/or on its Opening the disc tray packaging to indicate information regarding the contents and Press x to open the disc tray. functions of the disc. Check the marks indicating the contents and functions of the disc. Note, however, that in some cases a disc may x not include a mark ev
Inhaltszusammenfassung zur Seite Nr. 11
Filename [DR-MV1SEK_03DiscInfo.fm] Masterpage:Right+ DR-MV1SEK_00.book Page 11 Thursday, April 15, 2004 3:30 PM DISC INFORMATION EN 11 Care And Handling Of Discs How to handle discs When handling a disc, do not touch the surface of the disc. Since discs are made of plastic, they are easily damaged. If a disc gets dirty, dusty, scratched or warped, the images and sound will not be picked up correctly, and such a disc may cause the unit to malfunction. Label side Do not damage the label
Inhaltszusammenfassung zur Seite Nr. 12
Filename [DR-MV1SEK_04Name.fm] Masterpage:Left0 DR-MV1SEK_00.book Page 12 Thursday, April 15, 2004 3:30 PM INDEX 12 EN Front View A B C D E F G H I J STANDBY/ON VCR/DVD VCR DVD VCR DUB DVD SAT REMAIN PR DV IN DVD F-1 (–) (+) S-VIDEO VIDEO (MONO) L - AUDIO - R REC MODE SLOW DVD KLM N O PQRU ST V W A Standby/On Button (1) N Front Display Panel pg. 14 B VCR/DVD Button pg. 22 O Infrared Beam Receiving Window C VCR Timer Lamp (#) pg. 56 P Remain Button (REMAIN) pg. 29, 43 VCR Lamp pg. 51
Inhaltszusammenfassung zur Seite Nr. 13
Filename [DR-MV1SEK_04Name.fm] Masterpage:Right+ DR-MV1SEK_00.book Page 13 Thursday, April 15, 2004 3:30 PM INDEX EN 13 Rear View A B CDF E G DVD/VCR DVD AUDIO OUT L-1 IN/OUT 2 Y IN LEFT PB RIGHT PR OUT COMPONENT VIDEO OUT ANTENNA DIGITAL AUDIO OUT PCM/ L-2 IN/DECODER STREAM SAT CONTROL COAXIAL OPTICAL DVD H I J K A Region Number Label pg. 8 E Component Video Output Connectors (COMPONENT B AC Power Cord pg. 18 VIDEO OUT) (DVD deck only) pg. 18 C Cooling Fan F L-1 Input/Output Connector
Inhaltszusammenfassung zur Seite Nr. 14
Filename [DR-MV1SEK_04Name.fm] Masterpage:Left+ DR-MV1SEK_00.book Page 14 Thursday, April 15, 2004 3:30 PM INDEX 14 EN Front Display Panel ABC DEI F GHJ KQ LM N O PR A VPS/PDC Indicator* pg. 46 – 47 H Linear PCM Indicator (LPCM) Appears when checking if the station being received transmits a Lights when “XP MODE REC AUDIO” is set to “LINEAR PCM” VPS/PDC signal. ( pg. 81) for recording with DVD-RAM, DVD-R and DVD-RW * VPS (Video Programme System) recording is not currently discs, and when
Inhaltszusammenfassung zur Seite Nr. 15
Filename [DR-MV1SEK_04Name.fm] Masterpage:Right+ DR-MV1SEK_00.book Page 15 Thursday, April 15, 2004 3:30 PM INDEX EN 15 On-Screen Display (DVD deck) When “SUPERIMPOSE” is set to “AUTO” and ON SCREEN on the remote control is pressed, various operational indicators appear on the TV screen. To clear the operational indicators, press ON SCREEN twice. A Disc Display H Clock Display Displays the type of the disc loaded on the disc tray. I Bar Meter Display pg. 33 B Title Number* Displays playbac
Inhaltszusammenfassung zur Seite Nr. 16
SET UP MENU Filename [DR-MV1SEK_04Name.fm] Masterpage:Left+ DR-MV1SEK_00.book Page 16 Thursday, April 15, 2004 3:30 PM INDEX 16 EN L Play Button (4) pg. 26, 51 Remote Control Select Button (SELECT) (DVD deck only) pg. 26, 60 M Reverse Search Button (3) (DVD deck) pg. 27, 34 Rewind Button (3) (VCR deck) pg. 51, 52 CABLE/SAT TV DVD Reverse Slow Button (SLOW –) pg. 28 TV/CBL/SAT N Stop Button (8) pg. 26, 51 VCR DVD VCR /DVD TIMER TIMER /DVD Clear Button (CLEAR) (DVD dec
Inhaltszusammenfassung zur Seite Nr. 17
SET UP MENU Filename [DR-MV1SEK_04Name.fm] Masterpage:Right+ DR-MV1SEK_00.book Page 17 Thursday, April 15, 2004 3:30 PM INDEX EN 17 Check Contents CHECK ALL THE CONTENTS SHOWN BELOW CABLE/SAT TV DVD TV/CBL/SAT VCR DVD VCR DVD Video Recorder TIMER TIMER /DVD /DVD NUMBER / TV PR/CABLE PR/ DVD PR 1 2 3 ABC DEF POWER 4 5 6 GHI JKL MNO VCR EJECT VCR/DVD TIMER VCR REC OPEN/CLOSE STOP PLAY TIMER DVD REC VCR DUBBING DVD PULL-OPEN PULL-OPEN REMAIN REC PAUSE REW FF CH REC LINK DV IN 7 8
Inhaltszusammenfassung zur Seite Nr. 18
Filename [DR-MV1SEK_04Name.fm] Masterpage:Left0 DR-MV1SEK_00.book Page 18 Thursday, April 15, 2004 3:30 PM INSTALLING YOUR NEW UNIT 18 EN 1 Place the unit on a stable, horizontal surface. Basic Connection 2 Connect the unit to a TV depending on the TV and cables you use. Basic Connection 8 To connect to a TV with AV input connectors — Aerial connector A Disconnect the TV aerial cable from the TV. Back of TV B Connect the TV aerial cable to the ANTENNA IN connector on the rear panel of the u
Inhaltszusammenfassung zur Seite Nr. 19
Filename [DR-MV1SEK_04Name.fm] Masterpage:Right0 DR-MV1SEK_04Name.fm Page 19 Thursday, April 22, 2004 6:32 PM INITIAL SETTINGS EN 19 NOTES: Auto Set Up ● In areas where no TV station transmits a PDC (Programme Delivery Control) signal, the unit can perform neither Auto Clock Set nor Auto Guide Program Number Set. Auto Channel Set/Auto Clock Set/Auto Guide Program ● If there is a power cut, or if you press 1 or SET UP while Auto Set Up is in progress, Auto Set Up will be interrupted; be su
Inhaltszusammenfassung zur Seite Nr. 20
Filename [DR-MV1SEK_04Name.fm] Masterpage:Left+ DR-MV1SEK_04Name.fm Page 20 Friday, April 23, 2004 9:41 AM INITIAL SETTINGS 20 EN If you have connected the unit to your TV via a 21-pin SCART Preset Download cable ( pg. 18), the unit will automatically perform Preset Download instead of the Auto Set Up in step 2 on page 19. After downloading, the unit sets the clock and Guide Program numbers Auto Channel Set by Downloading from TV/Auto Clock automatically. Set/Auto Guide Program Number S
