Bedienungsanleitung Black & Decker BM3B

Inhaltszusammenfassung zur Seite Nr. 1

6 VOLT / 12 VOLT
AUTOMATIC BATTERY MAINTAINER
INSTRUCTION MANUAL
Catalog
Number
BM3B
Thank you for choosing Black & Decker!
Go to www.BlackandDecker.com/NewOwner
to register your new product.
PLEASE READ BEFORE RETURNING THIS
PRODUCT FOR ANY REASON:
If you have a question or experience a problem with your Black & Decker purchase, go to
HTTP://WWW.BLACKANDDECKER.COM/INSTANTANSWERS
for instant answers 24 hours a day.
If you canʼt find the answer or do not have access to the internet,
call 1-8

Inhaltszusammenfassung zur Seite Nr. 2

voltage resulting in loss of power and overheating. The following table shows the correct size to use depending on SAFETY GUIDELINES / DEFINITIONS cord length and nameplate ampere rating. If in doubt, use the next heavier gage. The smaller the gage number, the heavier the cord. Minimum Gage for Cord Sets SAFETY GUIDELINES - DEFINITIONS Volts Total Length of Cord in Feet It is important for you to read and understand this manual. The information it contains relates to pro- 120V 0-25 26-50 51-100

Inhaltszusammenfassung zur Seite Nr. 3

� FIRST AID – SKIN: If battery acid comes in contact with skin, rinse immediately with water, then wash thoroughly with 2. Attach a 24-inch (minimum length) 6 AWG insulated battery cable to the Negative battery post (marked NEG, N, –). soap and water. If redness, pain, or irritation occurs, seek immediate medical attention. 3. Connect the Positive (RED) battery clamp to the Positive battery post (marked POS, P, + or red). EYES: If battery acid comes in contact with eyes, flush eyes immediately,

Inhaltszusammenfassung zur Seite Nr. 4

Charging Indicators 1 BATTERY TERMINAL CLAMPS Red LED – Bad connection, reverse polarity 6V/12V BATTERY MAINTAINER connection; check that the RED clamp is connected to + battery terminal. Blinking Green LED – Connection correct and charging Solid Green LED – Battery fully charged When the charger is properly connected, the LED will illuminate, indicating the inside smart circuit is functioning to Charger Connector judge the battery status. This procedure may take up to 2 minutes if battery vol

Inhaltszusammenfassung zur Seite Nr. 5

Connecting the Maintainer and Maintaining the Battery with the DC Accessory Plug FULL TWO-YEAR HOME USE WARRANTY The charger’s output leads also contain a DC accessory plug (Figure 4). Black & Decker (U.S.) Inc. warrants this product for two years against any defects in material or workmanship. The defective product will be replaced or repaired at no charge in either of two ways. Note: ALWAYS disconnect the AC power cord from the AC power outlet before connecting (or disconnecting) the charger