Inhaltszusammenfassung zur Seite Nr. 1
Operating instructions
TV
Connect 42
Connect 37
Connect 32
233–33319.020
3 3 3 1 9 0 2 0
Inhaltszusammenfassung zur Seite Nr. 2
Contents Electronic Programme Guide ................................................................. 30 Remote control – TV functions ................................................................ 3 Electronic Programme Guide – EPG ...............................................................30 Control unit front side of the device ....................................................... 4 Configuring EPG .......................................................................................
Inhaltszusammenfassung zur Seite Nr. 3
Remote control – TV functions Switch on / (page 20) ............................................................. Sound off/on switch off to standby mode .....................................(page 12) (page 52) .................... LED display for current operating mode (1 Switch over to radio mode ..............................(page 12, 36) (page 11, 52) ......................................Switch over to TV mode (page 52) ................................Swit
Inhaltszusammenfassung zur Seite Nr. 4
Control unit front side of the device Display (3 Connectivity Button M: Call the menu Display: in the menu: up/down The mains switch is located on = Standby the bottom of the set in the middle = Operation = Operation without on-screen display On/Off button: (Radio, EPG data capture or timer recording) Switch on from the standby mode Switch off to the standby mode Button +: Station up in the menu: to the right Button – : DR+ Station down in the menu: to the left (2
Inhaltszusammenfassung zur Seite Nr. 5
Connections r re e�r side of the devic r � side of the device e – – – Connect Connect Connect ������ Factory settings: AV1: DVD player AV2: DVD recorder Common Interface You can change this during the (CI-Slot) initial installation (page 12) or Display USB connection 1 in the connection wizard (page (3 (USB stick/card reader) 37). Connectivity Before you connect other devices Headphones connection or make any changes, please start the connection wizard (page 37) S-
Inhaltszusammenfassung zur Seite Nr. 6
Connections re�r side of the device – Connect �7 / Connect 4� Factory settings: (2 AV1: DVD player Connection for additional antenna AV2:D VDr ecorder Common Interface You can change this during the (CI-Slot) initial installation (page 12) or USB connection 1 in the connection wizard (page (USB stick/card reader) 37). Headphones Before you connect other devic- connection es or make any changes, please start the connection wizard S-VHS connection (AVS) (page 37)
Inhaltszusammenfassung zur Seite Nr. 7
Welcome Thank you! About this operating manual Loewe sets high standards in technology, design and user friendliness. This For many questions concerning the technology you will find an answer applies equally for TV, video and accessories. in the index of your TV set. If your question concerns TV set operation, you can access a function directly from the index of the Tv set. Owing to Your new TV set is equipped for the TV standard
Inhaltszusammenfassung zur Seite Nr. 8
Welcome Assist+ Operating convenience with wizards You can select the most important operating modes directly with the This TV set offers user prompting with wizards that take you through the Assist+ menu (ASSIST button). Selectable modes are: TV, Radio digital, settingsstep-by-step. Teletext, PhotoViewer, Index and when equipped with Digital Recorder or You can return to the previous step or exitthe wizar dat any time. Network Mediaplayer
Inhaltszusammenfassung zur Seite Nr. 9
For your s�fety For your own safety and to prevent unnecessary damage to your device, Power supply read and comply with the following safety instructions: The wrong voltage can damage the set. This equipment must only be connected to a mains power supply which has the same voltage and Proper use and environmental conditions frequency as that specified on the rating plate; use the power cable This TV set is intended exclusively for the reception and rep
Inhaltszusammenfassung zur Seite Nr. 10
For your s�fety Environmentl pr � otection Repairs and accessories Energy consumption Your TV set is equipped with an eco-standby power supply. In the standby Never remove the back of the TV set yourself. Only have your TV device mode, the power consumption drops to low power (see technical data on repaired or servicedby authorized television technicians. page 57). If you want to save even more energy then switch the device Only use ori
Inhaltszusammenfassung zur Seite Nr. 11
AAA LR03 Initil inst � ll � tion � Installing the TV set Connecting the TV set Installas manually rotatable table unit with the TableS tandincluded. Connecting to the mains Seeaccessories (page 58)for other installationoptions. Connectthe TV set to a220-240V power outlet: First plug the small plug of the power cable into the power connection on the rear of the TV, then plug the Preparing the remote control unit large powerplug into a mains
Inhaltszusammenfassung zur Seite Nr. 12
Initil inst � �ll�tion Turning the set on/off First installation wizard Switching the TV set to standby mode Initial installation after switching on for the first time This wizard starts automatically after the set is switched on for the first Actuate the mains switch on the bottom of the set. time, however it can also be called later manually in the TV index, see The display in the control panel on the front of the set Repeat initial installation
Inhaltszusammenfassung zur Seite Nr. 13
Initil inst � ll � tion � Explanations of the setting possibilities, including the upgradeable LNC Normally, you do not need to change the values for high frequencies and low band, unless the LNC (LNB) of your satellite satellite reception: Low Band / system uses a different oscillator frequency (important Location of Select the countryfor country-specific pre-settings. High Band for thefr equency display). TV set If UK or IRL is selected for the
Inhaltszusammenfassung zur Seite Nr. 14
Initi�l inst�ll�tion Digital Link If you have logged in and connected a recorder in the Positioning/aligning the DVB-T antenna Plus connection wizard, the Digital Link Plus transmission If you receive one or more DVB-T stations with picture or sound interfer- starts when the sound component wizard closes. If a ence, you should change the position and alignment of the antenna. Ask Digital Link Plus compatible recorder is connected, the
Inhaltszusammenfassung zur Seite Nr. 15
Operting convenience � General information on menu operation The info display Menus for the individual operating modes (TV, Radio, PIP, EPG, Teletext, The info display shows a content-based info text for each menu item at PhotoViewer, MusicBox and Digital Recorder, if installed) are called with the top edge of the screen to aid you in making the settings. In conjunc- the MENU button. Other menus can be opened with other buttons on tion
Inhaltszusammenfassung zur Seite Nr. 16
Oper�ting convenience The index in the TV set The Assist+ menu You can start all wizards and many operating functions directly from The most important additional functions of the TV set can be called this point. The complete function scope of the TV set can thus be easily directly by theA ssist+ menu. understood. Call Assist+ Alphabetic sorting is preceded by the items Language, Integrated features and Repeat initial installation. Call Assist+men
Inhaltszusammenfassung zur Seite Nr. 17
Oper�ting convenience TV menu – Overview diagram TV menu Picture Sound Connections Settings (9 (1 Picture adjustment Sound via New devices/modifications Stations (1 (1 Search wizard Contrast Sound effects Sound components Manual adjustment (1 Colour intensity Sound adjustment Antenna DVB Change stations Colour temperature Headphone volume Digital Link Plus Select/change favourites Brightness Loudness Miscellaneous Parental lock Manual adjustment of AV standard Sharpness more... Timer funct
Inhaltszusammenfassung zur Seite Nr. 18
D�ily oper �tion With the station list Select station ➠ I n normal TV mode, without other displays, no favour- With the keys P+ and P - on the remote control ites selected: P+/P–station up/down. OK call Station list. The station display with sound identification is displayed briefly. Sorting Station list COMP. IN 5 hr-fernsehen numerically ➠ I f favourites are selected, the station in the favourites list HDMI1/DVI 6 Phoenix HDMI2/DVI
Inhaltszusammenfassung zur Seite Nr. 19
D�ily oper �tion With the favourites lists Explanation of the icons following station names: DigitalD VB-T station (terrestrial viaantenna) You can save and call your favorite stations in 6 favourites lists (e.g. for DigitalD VB-C station(via cable) multiple users). Each favourites list can contain up to 99 stations. After initial installation, 10 stations from the station list are already stored in Digital DVB-S station (via satelli
Inhaltszusammenfassung zur Seite Nr. 20
D�ily oper tion � Explanations of the sound settings: Adjusting the sound Sound via Playback over the TV speakers, active speakers, Loewe Auro, Switching sound on/off Loewe Sound Projector or an external hi-fi amplifier. The selection active speakers, hi-fi/AV amplifier or Sound Soundoff; Projector is only possible if these have been logged in in Sound on:Pr essbutton again or setvolume V+. the audio component wizard. The Auro selection
