Bedienungsanleitung Audiovox ACAM250

Inhaltszusammenfassung zur Seite Nr. 1

2.5” LCD Backup Monitor
Model: ACAM250

Installation/User’s Manual








Features:
• 2.5” TFT color LCD display
• Flexible mounting pad with 3M tape monitor mounts on either
vehicle windshield or dashboard
• Rearview camera input
• Automatically displays backup camera image when vehicle is in
reverse

Inhaltszusammenfassung zur Seite Nr. 2

Warnings This product is intended to assist in safe driving by signaling the driver of obstacles behind the vehicle while the vehicle is in reverse. You, as the driver, are solely responsible for the safe operation of your vehicle and the safety of your passengers according to your local traffic regulations. Do not use any features of this system to the extent it distracts you from safe driving. Your first priority while driving should always be the safe operation of your vehicle. Audiovo

Inhaltszusammenfassung zur Seite Nr. 3

TABLE OF CONTENTS Warnings 1 Product description 2 Packing list 3 Installation Instructions 3 Operation 6 Maintenance 6 Troubleshooting 7 Warranty card 8 Product Description This Rearview Mirror/Monitor, when used with a backup camera, is designed to assist the driver by providing a clear and wide image of the area behind the vehicle whenever the vehicle is s

Inhaltszusammenfassung zur Seite Nr. 4

Packing List Description Figure 2.5” Monitor Power Cable Tap Connectors Alcohol Wipe 3

Inhaltszusammenfassung zur Seite Nr. 5

Installation Instructions Mounting the Monitor The monitor with flexible mounting pad and 3M tape mounts on either the vehicle windshield or dashboard. 1. Choose a monitor location in your vehicle that does not block your view for safe driving. 2. Clean the monitor mounting area with the alcohol wipe provided. 3. Remove the protective film from the 3M flexible adhesive mounting pad on the bottom of the monitor and carefully press into place. Note: Once pressed into place, the pad

Inhaltszusammenfassung zur Seite Nr. 6

Wiring the Monitor 1. Wire the Power Cable to the vehicle’s reverse lamp. a) Locate the reverse lamp in the tail light assembly. Using the tap connector supplied, perform the following steps: i. Place the un-stripped positive lead wire on the run channel. ii. Insert the un-stripped red power wire completely. iii. Fold the tap connector back over the wires and make the connection by crimping the u-contact down flush with the plastic insulator. iv. Close the top hinged cover until latche

Inhaltszusammenfassung zur Seite Nr. 7

Operation The monitor will automatically display the rear observation camera image whenever the vehicle is engaged in reverse. Maintenance Though your Monitor requires little care, you can still maintain its condition and performance following the procedures below. • Keep your system away from excessive moisture, extreme heat or cold and magnetic fields. • Keep liquids away from the display monitor. • To avoid damage, do not place auxiliary devices or other objects on the top

Inhaltszusammenfassung zur Seite Nr. 8

Troubleshooting Symptoms Solutions Ensure that the parallel red and black line from The ON/OFF signal light the control box is connected properly. is not on after the car is started 1. Verify that the LCD Contrast No video signal appears (Brightness) control knob is not set too while reversing the car low 2. Check the rearview Camera lens. 3. Check the rearview Camera wiring and connection. 4. Confirm that the cable from the monitor is connected properly. Video image is

Inhaltszusammenfassung zur Seite Nr. 9

8

Inhaltszusammenfassung zur Seite Nr. 10

© 2008 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, N.Y. 11788 9