Inhaltszusammenfassung zur Seite Nr. 1
A27W231
USER’S MANUAL
TABLE OF CONTENTS
IMPORTANT SAFETY INSTRUCTIONS -------------------------- 2
PREPARATION ----------------------------------------------------------- 4
OPERATING INSTRUCTIONS --------------------------------------- 6
Use of the remote control ---------------------------------------- 6
To use the menus -------------------------------------------------- 7
Main menu ------------------------------------
Inhaltszusammenfassung zur Seite Nr. 2
SYMBOL SYMBOL DEFINITION DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol,within an equilateral triangle,is intended to alert the user to the presence of uninsulated “dangerous voltage”within the product’s enclosure that SA 1965 may be of sufficient magnitude to constitute a risk of electrical shock to persons. INSTRUCTIONS: The exclamation point within on equilateral triangle to alert the User to the presence of important operating and maintenance (servicing) in
Inhaltszusammenfassung zur Seite Nr. 3
IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any of the ventilation openings. Install in accordance with the manufacturers instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that
Inhaltszusammenfassung zur Seite Nr. 4
C. The appliance has been exposed to rain; or D. The appliance does not appear to operate normally or exhibits a marked change in performance; or E. The appliance has been dropped, or the enclosure damaged. 18. Tilt/Stability – All televisions must comply with recommended international global safety standards for tilt and stability properties of its cabinets design. Do not compromise these design standards by applying excessive pull force to the front, or top, of the cabinet, which cou
Inhaltszusammenfassung zur Seite Nr. 5
PREPARATION 1. Place the TV on a solid surface. Ensure that the TV is placed in a position to allow free flow of air. Do not cover the ventilation openings on the back cover. To prevent any unsafe situations, no naked flame sources, such as lighted candles, should be placed on or in the vicinity. Avoid heat, direct sunlight and exposure to rain or water. The equipment shall not be exposed to dripping or splashing. 2. Insert the aerial plug firmly into
Inhaltszusammenfassung zur Seite Nr. 6
3. Remote control: Remove the cover of the battery compartment. Insert the 2 batteries supplied (Type AAA 1.5V). 4. Power: Insert the power cord in the wall socket having an AC power supply . 5. Turn the TV on: Press the power button at the topside of the TV to turn it on. If the TV is in power off, the indicator in front of the TV illuminates amber. 5
Inhaltszusammenfassung zur Seite Nr. 7
OPERATING INSTRUCTIONS USE OF THE REMOTE CONTROL MUTE POWER Press to turn on/off the Temporarily interrupt the TV. The TV is never sound or restore it. completely powered off br DISPLAY unless it is physically (1) Display Channel number unplugged. when use RF input. (2) Display input source CH when use other input Press or (or ▲ or ▼)to except TV RF input. browse through the TV channels which are not erased. PRE-CH To display
Inhaltszusammenfassung zur Seite Nr. 8
TO USE THE MENUS 1. Press the MENU button repeatedly to display each menu 2. Use the cursor up/down to select a menu item or adjust the setting of Menu item. 3. Use the cursor left/right to enter a submenu or enable the function. 4. Press the MENU button to exit the menu. MAIN MENU Press the MENU button into the main OSD (On Screen Display). Adjust item include VIDEO ADJUST, AUDIO ADJUST, PIP, SLEEP TIMER , SET UP and PC ADJUST. 7
Inhaltszusammenfassung zur Seite Nr. 9
Video Adjust 1. Contrast, Brightness and Saturation are adjusted from 0 to 100. 2. Black Level is adjusted from 0 to 100. 3. Sharpness is adjusted from -5 to+5. You can adjust picture contrast, brightness, color, tint and sharpness to the levels you prefer. 4. Reset is set up to default value. When adjust any item sub-OSD will show up like this. Audio Adjust 1. Volume is adjusted from 0 to 100. 2. Bass and Treble are adjusted from 0 to 100. You can adjust picture
Inhaltszusammenfassung zur Seite Nr. 10
PIP 1. PIP function is turn on /off small picture 2. Position is move for small picture 3. Source is choose from TV /AV1/AV2/S VIDEO 4. Audio select is choose from MAIN/SUB Sleep Timer is for set a time period after which the TV should switch itself to standby. The counter runs from 30 > 60 > 90 > 120 minutes. The timer begins to count down from the number of minutes selected after the display has disappeared. Note: To view the remaining time, press the SLEEP button once. To ca
Inhaltszusammenfassung zur Seite Nr. 11
4. CH SEARCH for search all TV program and storing in memory. 5. CH DEL. /ADD. If “ DEL” the channel will be masked. 6. MANU SCAN for search TV. Program channel by channel. After scan a new program, press MENU key, it will be automatically saved in the last channel. 7. CH SWAP save the location of current channel and destination channel for each other 8. View Mode : Includes 3 modes: Press repeatedly to select 4:3 /16:9 / non-Linear. 9. Reset is set up to default value of BLUE
Inhaltszusammenfassung zur Seite Nr. 12
Connect Peripheral Equipment FRONT PANEL CONTROL KNOBS Power Key: Press to turn on or off the TV. MENU Key: Press to show the OSD menu and exit OSD menu at the TV. Down / Up Key: Press to perform select function and channel. - / + Key: Press to confirm your function selection and adjustment. Source Key: Press to select your input source. There is a wide range of video and audio equipment that can be connected to your TV. The following connection diagrams show
Inhaltszusammenfassung zur Seite Nr. 13
VIDEO RECORDER How to connect 1. Connect the supplied antenna cable to the RF IN port of your VCR. 2. Connect another RF cable from the output RF of your VCR to the input of your TV. Better quality when playing from your VCR can be obtained if you also connect the Video, Audio LEFT AND right (only for stereo equipment) cables to the VIDEO, AUDIO L and R inputs AV. If you are using only mono equipment, connect only the VIDEO and the AUDIO L (Mono) ports.
Inhaltszusammenfassung zur Seite Nr. 14
CAMERA, CAMCORDER, VIDEO GAME SET … DIGITAL CAMERA How to connect 1. Connect your digital camera, camcorder, videogame set… to VIDEO port and AUDIO L for mono equipment. 2. For stereo equipment also connect AUDIO R . S-VHS quality with an S-VHS camcorder is obtained by connecting the S- VHS cable with the S-VIDEO input and AUDIO input . How to use 1. Select VIDEO AV2 or S-VIDEO. 2. Turn on the external AV equipment. DVD PLAYER How t
Inhaltszusammenfassung zur Seite Nr. 15
DIGITAL SET TOP BOX When you dispose of a Digital Antenna cable connected to a digital Set Top Box, connect the Set Top Box to the COMPONENT INPUT How to connect 1. Connect the three separate component video cables to the DTV player’s Y, Pb, Pr or Y, Cb, Cr ports and to the Y, Pb and Pr ports on the TV. 2. Connect the audio cables to the DTV player’s AUDIO L and R ports and to the AUDIO L and R ports on the TV. How to use 1. Select COMPONENT
Inhaltszusammenfassung zur Seite Nr. 16
HEADPHONE 1. Insert the plug into the headphone port , when insert headphone will block speaker audio output. 2. Press the key on the remote control to switch off the sound from the headphone and the internal loudspeakers of the TV. 3. Press the cursor lift/right to adjust the volume. Note: When a TV channel or external AV source is blocked because of a rating set via the Parental control menu, also the headphone is muted. TIPS Care of the screen
Inhaltszusammenfassung zur Seite Nr. 17
Product Specification Feature 27" screen XGA (1024 x 768 ) Resolution 2 High Brightness (550 cd/m ) High Contrast Ration (600:1 ) Wide Viewing Angle ( 170 H / 170 V ) PC Input Items Specification Screen Size 27” TFT-LCD Panel 16 : 9 Aspect Ratio 1280 x 720 (WXGA) Resolution 597mm x 336mm Display Area (opening) H x V 0.4665mm x 0.4665mm Pixel Pitch Display colors 16.7 million LCD Panel 550:1 Contrast Ratio 2 550 cd/ m Brightness Viewing Angle 17
Inhaltszusammenfassung zur Seite Nr. 18
Analog: D-Sub 15 pin (detachable Signal Input cable) PnP compatibility DDC 2B Analog: FH: 31.5kHz to 48kHz Input frequency PC Input FV: 60Hz to 75Hz Recommended Analog: 1024 x 768 (60Hz) Headphone Mini-jack for stereo Input Audio (3.5ø) Speaker (built-in): Two 3 watt speakers Headphone Mini-jack for stereo Audio Output Audio Output: L / R (3.5ø) Line Output (RCA L/R) OSD language English/ Chinese(Default Language: English) Table Stand Included Wall Mount VESA
Inhaltszusammenfassung zur Seite Nr. 19
Before Calling Service Please make these simple checks before calling service. These tips may save you time and money since charges for receiver installation and adjustments of customer controls are not covered under your warranty. Symptoms Items to Check and Actions to follow “ Ghost ” or double *This may be caused by obstruction to the image antenna due to high rise buildings or hills. Using a highly directional antenna may inprove the picture. No power *Check that
Inhaltszusammenfassung zur Seite Nr. 20
GLOSSARY Audio / Video Inputs Located on the rear and the front of the receiver these connectors (RCA phono type plug) are used for the input of audio and video signals. Designed for use with VCRs (or other accessories) in order to receive higher picture resolution and offer sound connection options. Menu An on-screen listing of feature controls shown on the TV screen that are made available for user adjustments. Multichannel Television sound (MTS) The broadcast standa
