Bedienungsanleitung Allstar Products Group MVP 110927

Inhaltszusammenfassung zur Seite Nr. 1

ABC DEF
1 2 3
by
GHI JKL MNO
4 5 6
PRS TUV WXY
7 8 9
MVP Quik-Code
0#
*
Wireless Keyless Entry
ON
RESET
Installation Instructions
Model 110927
Proper installation of your radio controls will assure years of
trouble-free operation
READ THE FOLLOWING INSTRUCTIONS THOROUGHLY
BEFORE STARTING INSTALLATION
Your MVP Quik-Code Wireless Keyless Entry is designed to remotely operate
MVP garage door openers. The system permits the user to select one of 10,000
personal identification numbers (

Inhaltszusammenfassung zur Seite Nr. 2

Mounting the Quik-Code Wireless Keyless Entry Step 1: Choose a convenient location that does not interfere with the normal opening and closing of the ABC DEF door. Keep in mind that some doors swing outward 1 2 3 GHI JKL MNO 4 5 6 and will damage an improperly located keypad. PRS TUV WXY 7 8 9 MOUNT THE KEYPAD A MINIMUM OF 5 0# * FEET ABOVE THE GROUND TO KEEP IT ON RESET OUT OF REACH OF CHILDREN. Step 2: The screws provided are adequate for mounting directly to wood or similar ma

Inhaltszusammenfassung zur Seite Nr. 3

Programming Steps for Quik-Code Wireless Keyless Entry Step 1: The red Keypad lighting should be Off. If it is on, wait until it turns off (approximately 20 seconds). Step 2: Using the end of a paper clip, put the receiver of the MVP Into Learn Mode by pressing and quickly releasing the recessed learn button located on the super deluxe wall station. The work-lamp on the MVP will turn on (or blink off then on) to indicate the receiver is Learn Button ready to learn a code. You have

Inhaltszusammenfassung zur Seite Nr. 4

Operational Check After installing your keypad, check the operation by entering your PIN and door number. Operation should be reliable. However, environmental conditions and the location of the keypad will affect distance. • If the keypad doesn’t activate the operator check the PIN number. The PIN number entered must exactly match the learned PIN number. • Press the ON/RESET button and wait a few seconds before entering your PIN number. Press the keys slowly but avoid holding the butto