Inhaltszusammenfassung zur Seite Nr. 1
0
0
7
0
5
6
0
0
6
0
5
5
0
0
5
0
5
4
0
NOTICE TO INSTALLER:
LEAVE THESE INSTRUCTIONS
WITH THE GRILL OWNER FOR
FUTURE REFERENCE.
OWNER’S MANUAL
ASSEMBLY AND OPERATING INSTRUCTIONS
SAVE THIS MANUAL FOR FUTURE REFERENCE
WARNING
HAZARDOUS EXPLOSION MAY
RESULT IF THESE WARNINGS AND
INSTRUCTIONS ARE IGNORED. READ
AND FOLLOW ALL WARNINGS AND
INSTRUCTIONS IN THIS MANUAL TO
AVOID PERSONAL INJURY, INCLUDING
DEATH OR PROPERTY DAMAGE.
0
4
0
5
3
0
0
3
0
5
2
0
0
2
0
5
1
0
0
1
Inhaltszusammenfassung zur Seite Nr. 2
IMPORTANT SAFETY WARNINGS WE WANT YOU TO ASSEMBLE AND USE YOUR GRILL AS SAFELY AS POSSIBLE. THE PURPOSE OF THIS SAFETY ALERT SYMBOL IS TO ATTRACT YOUR ATTENTION TO POSSIBLE HAZARDS AS YOU ASSEMBLE AND USE YOUR GRILL. WHEN YOU SEE THE SAFETY ALERT SYMBOL PAY CLOSE ATTENTION TO THE INFORMATION WHICH FOLLOWS! READ ALL SAFETY WARNINGS AND INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING AND OPERATING YOUR GRILL. DANGER FOR YOUR SAFETY: IF YOU SMELL GAS: 1. Shut off gas to the appliance at the LP cylinder a
Inhaltszusammenfassung zur Seite Nr. 3
WARNING • Never use natural gas in a unit designed for liquid propane gas. • Never use charcoal briquets or lighter fluid in a gas grill. • Leak test all connections before first use, even if grill was purchased fully assembled and after each tank refill. • Never check for leaks using a match or open flame. CAUTION! Strong odors, colds, sinus congestion, etc. may prevent the detection of propane. Use caution and common sense when testing for leaks. • Always keep gasoline, paint thinner, or othe
Inhaltszusammenfassung zur Seite Nr. 4
WARNING • FOR OUTDOOR USE ONLY. DO NOT operate indoors or in an enclosed area such as garage, shed or breezeway. • Use your grill OUTDOORS in a well ventilated space away from dwellings or other buildings to prevent dangers associated with gas accumulation and toxic vapors. We recommend your grill be situated at least 10 feet from buildings. • Maintain a minimum clearance of 24 inches (60 cm) between all sides of grill and walls or other combustible material. • DO NOT install in or on a recreati
Inhaltszusammenfassung zur Seite Nr. 5
The cylinder must also be equipped with: • A shut-off valve terminating in a Type 1 gas cylinder valve outlet. • A Type 1 valve that prevents gas flow until a positive seal is obtained. • An arrangement for vapor withdrawal. • A collar to protect the cylinder shut off valve. • A safety relief device having direct communication with the vapor space of the cylinder. • A listed over-filling prevention device (OPD). WARNING • Turn off the cylinder valve when your grill is not in use. • Handle the t
Inhaltszusammenfassung zur Seite Nr. 6
WARNING FILLING THE LP GAS CYLINDER: • Allow only qualified LP gas dealers to properly fill or repair your LP gas cylinder. • New tanks should be purged prior to filling; inform LP gas dealer if you are using a new tank. • DO NOT allow the cylinder to be filled beyond 80% capacity. Over-filled tanks can create a dangerous condition. Over-filled tanks can build-up pressure and cause the relief valve to expel propane gas vapors. The vapor is combustible and if it comes in contact with a spark sour
Inhaltszusammenfassung zur Seite Nr. 7
WARNING • Never use your grill without leak testing all gas connections and hoses. See the section on "Leak Testing" in this manual for proper procedures. WARNING The pressure regulator and hose assembly supplied with your gas grill is designed to work with an LP gas supply cylinder. • DO NOT attempt to connect it to any other fuel supply source such as a natural gas line. • DO NOT use any other pressure regulator/hose assembly other than the one supplied with your grill. • DO NOT attempt to adj
Inhaltszusammenfassung zur Seite Nr. 8
DANGER LEAK TESTING: To prevent fire or explosion hazard: • DO NOT smoke or permit ignition sources in the area while conducting a leak test. • Perform test OUTDOORS only in a well ventilated area. • Never perform a leak test with a match or open flame. • Never perform a leak test while the grill is in use. WARNING WHEN TO PERFORM A LEAK TEST: • After assembling your grill and before lighting for the first time, even if purchased fully assembled. • Every time the LP gas cylinder is refilled or i
Inhaltszusammenfassung zur Seite Nr. 9
6. Check each place listed (A - J) for growing bubbles which indicates a leak. 7. Turn OFF gas supply at cylinder valve. 8. Turn on control knobs to release gas pressure in hose. 9. Turn control knobs to “off” position. 10. Tighten any leaking connections. 11. Repeat soapy water test until no leaks are detected. DO NOT use the grill if leaks cannot be stopped. Contact a qualified gas appliance repair service. 12. Turn OFF gas supply at cylinder valve until you are ready to use your grill. 13. Wa
Inhaltszusammenfassung zur Seite Nr. 10
WARNING Read, understand and follow all warnings and instructions contained in this manual. DO NOT skip any of the warnings and instructions contained in the preceding sections of this manual. WARNING LIGHTING INSTRUCTIONS: Follow the instructions exactly. 1. OPEN THE GRILL LID before attempting to light the burner so that fumes do not accumulate inside the grill. An explosion could occur if grill lid is down. 2. Check that all burner control knobs and the cylinder valve are turned to the OFF po
Inhaltszusammenfassung zur Seite Nr. 11
TURNING OFF THE GRILL: 1. Turn OFF the LP tank valve. 2. Turn all burner control knobs to the OFF position. NOTE: Turn off LP cylinder first to prevent gas from being left in the system under pressure. CAUTION! • The LP tank valve should always be in the off, or closed, position when the grill is not in use. To turn off the LP tank valve, turn knob clockwise until it stops. WARNING OPERATING THE GRILL: Never use Charcoal or Lighter Fluid inside your Gas Grill. Read and follow all warnings and in
Inhaltszusammenfassung zur Seite Nr. 12
WARNING • DO NOT leave your grill unattended while in use. • DO NOT move grill when in use. Lock wheels in place to stabilize grill. • DO NOT use water to extinguish flare-ups. • Have fire extinguisher readily accessible suitable for use with gas appliances. • Only use ceramic briquets that are large enough so they do not fall through the briquet grate to the burner. This will prevent grease build-up. TO MINIMIZE FLARE-UPS: • Trim excess fat from meats prior to cooking. • Cook meats with high fa
Inhaltszusammenfassung zur Seite Nr. 13
USING OTHER FEATURES OF THE GRILL: THE SINK: • Attach a standard garden hose to the supply line and a spigot to provide water for the faucet. Turn on the water supply to the garden hose. The faucet handle turns on and off the water flow. NOTE: Do not leave water supply to garden hose on when not in use. • Attach the drain hose (provided) at the base of the sink to direct outflow water. A pail or large bucket can be placed at the end of the drain hose to catch the waste water. If desired, a stand
Inhaltszusammenfassung zur Seite Nr. 14
WARNING TRANSPORTING AND STORAGE: • Never move a grill when it is hot or when objects are on the cooking surfaces. • Make sure that cylinder valve is shut off. After moving the grill check that all gas connections are free of leaks. Check the venturi tubes to ensure they are properly connected to the valves and the orifices are inside the venturi tube. Follow the instructions listed below. BEFORE STORING YOUR GRILL: • Ensure that the fuel supply tank valve is fully closed. • Clean all surfaces.
Inhaltszusammenfassung zur Seite Nr. 15
BURNERS AND VENTURIS • Although your burner is constructed of high quality stainless steel, it will rust as a result of the extreme heat and acids from cooking foods. Regularly inspect the burner for cracks, abnormal holes, and other signs of corrosion damage. If found, replace the burner. • Venturi tubes can become blocked by spiders and other insects building their nests. Blocked venturi tubes can prevent gas flow to the burner and could possibly result in a venturi fire. To clean the venturi
Inhaltszusammenfassung zur Seite Nr. 16
TROUBLE SHOOTING: Problem: Possible Causes: • Burner will not light 1. Check LP cylinder fuel level. 2. Bad electrode spark. Check to see if the grill will match light. Electrode or collector may need adjustment. 3. Venturi may not be properly seated. 4. Venturi may be obstructed. 5. The cylinder valve may be closed. 6. Regulator is not properly seated on cylinder valve. • Fire at control knobs 1. Venturi is obstructed. See section on Cleaning and Maintenance of the Venturi. 2. Venturi is improp
Inhaltszusammenfassung zur Seite Nr. 17
PROPER CARE & MAINTENANCE • To protect your grill from excessive rust, the unit must be kept clean and covered at all times when not in use. A grill cover may be ordered directly from Brinkmann by calling 1-800-468-5252 or 1-800-527-0717. • Wash cooking grill and briquet grate with hot, soapy water, rinse well and dry. Lightly coat cooking grill with vegetable oil or vegetable oil spray. • Clean inside and outside of grill by wiping off with a damp cloth. Apply a light coat of vegetable oil or v
Inhaltszusammenfassung zur Seite Nr. 18
ASSEMBLY INSTRUCTIONS READ ALL SAFETY WARNINGS & ASSEMBLY INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING OR OPERATING YOUR GRILL. WE RECOMMEND TWO PEOPLE WORK TOGETHER WHEN ASSEMBLING THIS UNIT. The following tools are required to assemble this Brinkmann Backyard Kitchen: • Pliers • Phillips & Flathead Screwdrivers • Adjustable Wrench PARTS LIST: 1 25 1 Hanging rack 1 Right side panel 2 1 Temperature gauge 26 1 Grease cup wire frame 3 27 1 Hood 1 Grease cup 4 1 Hood handle with handle stands 28 1 Tank
Inhaltszusammenfassung zur Seite Nr. 19
0 0 7 0 5 6 0 0 6 0 5 5 0 0 5 0 5 4 0 1 2 3 6 4 7 10 8 5 9 13 15 19 12 14 18 11 16 17 25 22 24 21 23 20 33 26 31 30 29 28 32 34 27 39 40 38 36 37 41 35 42 45 47 44 43 46 FOR MISSING PARTS, PLEASE CALL CUSTOMER SERVICE AT 1-800-527-0717. (Proof of purchase will be required.) Inspect contents of the box to ensure all parts are included and undamaged. 18 0 4 0 5 3 0 0 3 0 5 2 0 0 2 0 5 1 0 0 1
Inhaltszusammenfassung zur Seite Nr. 20
PARTS BAG CONTENTS Make sure you have all items listed under PARTS LIST and PARTS BAG CONTENTS before you begin the installation process. Your Parts Bag will include: 2 - Hood pivot pins 2 - Cotter pins PARTS BAG CONTAINS: 10 #8 X 3/8" Sheet metal screws 12 Stainless steel sheet metal screws 2 Hood pivot pins 34 M6 X 35 bolts 2 - Wingnuts 4 M6 X 12 bolts 34 - M6 X 35 bolts 4 Plastic inserts 2 Cotter pins 2 Wing nuts 10 M6 X 5 hex nuts 10 - M6 X 5 hex nuts 4 Stainless steel acorn nuts 4 - M6 X 12
