Inhaltszusammenfassung zur Seite Nr. 1
[ Put a stop to crime ]
S e c u r i t y s y s t e m a n d c o n v e n i e n c e
M MO OD DE EL L
[ User guide ]
76XV
Inhaltszusammenfassung zur Seite Nr. 2
Inhaltszusammenfassung zur Seite Nr. 3
Limited Lifetime Consumer Warranty For a period of five calendar year from the date of purchase of this auto-security device, Directed Electronics, Inc. promises to the ORIGINAL PURCHASER to repair or replace (with a comparable reconditioned model), free of cost, any electronic control module which proves to be defective in workmanship or material under normal use, SO LONG AS THE SYSTEM WAS SOLD, INSTALLED, AND SERVICED BY A PROFESSIONAL AUTO INSTALLER, AND REMAINS IN THE CAR IN WHICH THE SYS
Inhaltszusammenfassung zur Seite Nr. 4
TO THE MAXIMUM EXTENT ALLOWED BY LAW, ANY AND ALL WARRANTIES ARE EXCLUD- ED BY THE MANUFACTURER AND EACH ENTITY PARTICIPATING IN THE STREAM OF COM- MERCE THEREWITH. THIS EXCLUSION INCLUDES BUT IS NOT LIMITED TO THE EXCLU- SION OF ANY AND ALL WARRANTY OF MERCHANTABILITY AND/OR ANY AND ALL WAR- RANTY OF FITNESS FOR A PARTICULAR PURPOSE AND/OR ANY AND ALL WARRANTY OF NON-INFRINGEMENT OF PATENTS, IN THE UNITED STATES OF AMERICA AND/OR ABROAD. NEITHER THE MANUFACTURER OR ANY ENTITIES CONNECTED THEREW
Inhaltszusammenfassung zur Seite Nr. 5
iii 2004 Directed Electronics, Inc. ©
Inhaltszusammenfassung zur Seite Nr. 6
iv 2004 Directed Electronics, Inc. ©
Inhaltszusammenfassung zur Seite Nr. 7
Table of Contents Limited Lifetime Consumer Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . i What Is Included . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Important Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 System Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Your Warranty . . . . . . . . . . . . . . . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 8
Standard Configuration 2 2004 Directed Electronics, Inc. ©
Inhaltszusammenfassung zur Seite Nr. 9
What is Included ■ A control module ■ Two 3-button remote transmitters ■ A zone 2 impact sensor on-board the control module ■ A high-powered siren ■ A fault-proof starter interrupt on-board the control module ■ An LED Blue system status indicator ® switch ■ A push-button Valet Important Information Congratulations on the purchase of your state-of-the-art vehicle security system. This system has been designed to provide years of trouble-free operation. By carefully reading this guide prior to u
Inhaltszusammenfassung zur Seite Nr. 10
when using the remote transmitter. To access the battery for replacement, remove the rear cover of the remote with a small, flat-blade screwdriver. Your Warranty Your warranty card must be returned and the barcode serial num- ber must not be removed. If the warranty card is not returned, no warranty will be honored on your unit. It is also necessary to keep your proof of purchase, which reflects that the product was installed by an authorized dealer. Make sure you receive the war- ranty card fro
Inhaltszusammenfassung zur Seite Nr. 11
Transmitter Functions This system is programmable, making it possible to assign any trans- mitter button to any specific receiver function. The remote initially comes programmed with Standard Configuration, but may also be customized by an authorized dealer. The buttons in all of the instruc- tions in this manual correspond to a Standard Configuration remote. Standard Configuration Button The arm/disarm/panic functions are usually controlled by . Button An optional accessory function (such as tr
Inhaltszusammenfassung zur Seite Nr. 12
Using Your System The transmitter buttons indicated in this manual correspond to a standard configuration transmitter, unless otherwise specified. Arming You can arm the security system by pressing for one second. When the system arms, you will hear a short siren sound (chirp) and the parking lights will flash once. If the power door locks are controlled by the system, the doors will also lock. Once armed, the LED system status indicator will flash once per second to indicate that the system is
Inhaltszusammenfassung zur Seite Nr. 13
time a sensor is triggered during the Passive Arming countdown, the countdown starts over. Arming your security system protects your vehicle to the following degrees: ■ Light impacts trigger a warn-away response, causing the siren to chirp and the parking lights to flash for a few seconds. ■ Heavy impacts trip a trigger sequence, which consists of the siren sounding continuously and the parking lights flashing for 30 seconds. ■ If a door is opened, the siren immediately starts chirping and the
Inhaltszusammenfassung zur Seite Nr. 14
disarming indicates Tamper Alert, which is described in the Diagnostics section of this guide. Disarming Without a Transmitter If your transmitter is lost or damaged, you can manually disarm your vehicle security system. To disarm the system without a trans- mitter, you must have the vehicle's ignition key and know where the Valet switch is located. Be sure to check with your installer at the time of installation for the location of the Valet switch. To disarm the security system, turn the igni
Inhaltszusammenfassung zur Seite Nr. 15
Remote-Controlled Silent Arm/Disarm Use remote-controlled silent arm/disarm to temporarily turn off the arm or disarm chirps by briefly pressing before either arming or disarming. The confirmation chirp(s) will then be elimi- nated for that one operation only. To permanently turn off the arm and disarm chirps, contact your installation dealer. NOTE: The warn-away response to lighter impacts is bypassed if the system is armed using remote-controlled silent arm/disarm. This ensures that the sire
Inhaltszusammenfassung zur Seite Nr. 16
entering Valet Mode and will turn off if you are exiting Valet Mode. Remote-Controlled Valet You can also enter or exit Valet Mode by using the remote transmitter: 1. Open any vehicle door. 2. Press . 3. Press . 4. Press again. The LED system status indicator will light solidly if you have entered Valet Mode and will turn off if you have exited Valet Mode. ® Nuisance Prevention Circuitry ™ ™ Your security system has Nuisance Prevention Circuitry (NPC ) to prevent annoying false alarms. This ci
Inhaltszusammenfassung zur Seite Nr. 17
over. This ensures that a sensor that is continually being triggered will remain bypassed. ™ The vehicle doors are protected differently by NPC . If your secu- rity system is triggered by an open door for three, full 30-second cycles (one and one half minutes), the system will bypass the doors until the trigger ceases. ™ NOTE: Arming and disarming the system does not reset the NPC . The only ways to reset a bypassed zone are for that zone not to be triggered for 60 minutes or to turn the igniti
Inhaltszusammenfassung zur Seite Nr. 18
system ignores the input that was active when the system was armed, until that input ceases. Three seconds after that input ceases, the system will resume normal monitoring. For example, if your vehicle has an interior light exit delay and you arm the sys- tem before the light turns off, you may hear a Bypass Notification chirp. Three seconds after the light turns off, however, normal monitoring resumes. NOTE: Bypass Notification does not occur when the system is in remote- controlled silent arm
Inhaltszusammenfassung zur Seite Nr. 19
ments are listed in the following table, along with spaces to write in any optional sensors or switches that you have had installed. ZONE (Number of DEALER-INSTALLED LED Flashes) DESCRIPTION OPTIONS 1 Instant trigger for optional sensor, hood or trunk pins 2 A heavier impact detected by the on-board impact sensor 3 Door switch trigger 5 Ignition trigger NOTE: The LED does not report when the warn-away response has been activated; it only reports triggered sequences. ™ Stealth Coding Technology
Inhaltszusammenfassung zur Seite Nr. 20
several times within range of the vehicle. The system will auto- matically resynchronize and the transmitter will respond normally. High Frequency Your system transmits and receives at 434 MHz. This provides a cleaner spectrum with less interference and a more stable signal. Enjoy a phenomenal increase in range, even in areas with high radio interference. Programming Options Programming options control your system's normal, operational set-up. Most options do not require additional parts, but
