Inhaltszusammenfassung zur Seite Nr. 1
Mini-Cube Home Theater Package
Model MNCS / MNCSB
Mini-Cube Speakers
Model MNC / MNCB
Instruction Manual
Inhaltszusammenfassung zur Seite Nr. 2
INTRODUCTION M&S Systems is introducing cube speakers (MNC) and a cube speaker package for Home Theater applications (MNCS) offering quality sound at an affordable price. The compact size allows for installation in any room without being intrusive to your decor. These products also offer many features, including the following: • 360° swivel speaker allow for full area coverage • A complete frequency range when a subwoofer is added • Ceiling or wall mount • Compact design • Shielde
Inhaltszusammenfassung zur Seite Nr. 3
The subwoofer for the Mini-Cube Home Theater Package has an 8” active woofer. It is available in a black matte finish. RMS Power Rating 100 Watts Frequency Response 40 Hz to 350 Hz Crossover 40 Hz to 180Hz (Adjustable) Controls Power, Volume, Crossover Frequency, Phase Connections RCA Jacks and Spring Terminals Height 13.3 “ Width 9.8 “ Depth 13.7 “ Weight 20 lbs. UNPACKING YOUR SPEAKERS After carefully unpacking your speakers, the carton and the packing material should be
Inhaltszusammenfassung zur Seite Nr. 4
Figure 1 SPEAKER CONNECTONS 1. Turn off the receiver or amplifier and unplug it from the power outlet. 2. Use a 2-conductor 16-gauge speaker wire (M&S part number MS16X) for best results. Note: Remove about 2 inches of the outside jacket from both ends of the wire then strip approximately ½ inch of the insulation from each conductor at the speaker end. Use the recommended strip length as specified in the amplifier/receiver installation manual for the other end. 3. Proper c
Inhaltszusammenfassung zur Seite Nr. 5
LT RT AMP Figure 2 5. The MNCS system may be connected two ways depending on the amplifier used with the system. The major difference is the subwoofer connections. • An amplifier with a subwoofer output connection, usually a RCA type connector would be the preferred connection when used with the MNCS subwoofer (see figure 3). A shielded audio cable is required for this setup with a Y-adaptor connecting the audio cable
Inhaltszusammenfassung zur Seite Nr. 6
CENTER LT POWERED RT FRONT LT FRONT RT SUBWOOFER AMP LT REAR RT REAR Figure 4 6. IMPORTANT! Make sure there are no loose strands of wire touching each other across the speaker or amplifier terminals. This can create a short circuit and damage your electronics. 7. Plug your amplifier or receiver in, turn it on, and enjoy your new music system. SETTING UP THE SYSTEM Use the
Inhaltszusammenfassung zur Seite Nr. 7
• The power switch can be set to OFF-AUTO-ON. The OFF position disables the subwoofer completely. The AUTO position puts the subwoofer in a standby mode (low power) when the system is not in use. When a signal is applied, the subwoofer is automatically turned on. The ON position is a constantly ready with or without a music signal. The AUTO position is recommended for most applications. SERVICE & TROUBLESHOOTING M&S Systems is committed to producing high quality products for the ho
Inhaltszusammenfassung zur Seite Nr. 8
WARRANTY M&S Systems 2-Year Limited Product Warranty M&S Systems warrants for 2 years all products to be free of defects The warranty period begins from either (1) the date of “first user” purchase of this product or (2) the first close of escrow date on a residence in which this new product was originally installed. This warranty extends to the original user of the product and to each subsequent owner of the product during the term of this warranty. M&S Systems will repair or
