Inhaltszusammenfassung zur Seite Nr. 1
DMS-AV TSP2000
Home Theater Amplifier
Owner's Manual
Inhaltszusammenfassung zur Seite Nr. 2
DMS-AV Owner’s Manual ©2012 Universal Remote Control, Inc. The information in this manual is copyright protected. No part of this manual may be copied or reproduced in any form without prior written consent from Universal Remote Control, Inc. UNIVERSAL REMOTE CONTROL, INC. SHALL NOT BE LIABLE FOR OPER- ATIONAL, TECHNICAL OR EDITORIAL ERRORS/OMISSIONS MADE IN THIS MANUAL. The information in this manual may be subject to change without prior notice. URC - Control the Experience is a registered tra
Inhaltszusammenfassung zur Seite Nr. 3
DMS-AV HOME THEATER AMPLIFIER IMPORTANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . 7 Cautions on Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 FCC Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Introduction / Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 4
DMS-AV HOME THEATER AMPLIFIER HDMI Audio Output . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 CEC Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 Auto A/V Sync . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 Video PReP ® . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 Video Test Patterns . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 5
DMS-AV HOME THEATER AMPLIFIER Night Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35 Surround modes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . . . . . 36 40 Selecting the Surround mode. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . . . . . . . . 40 Cancelling the surround mode for stereo operation Tone Setting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 6
DMS-AV HOME THEATER AMPLIFIER IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 10. Only use attachments/accessories 2. Heed all warnings. specified by the manufacturer. 3. Follows all instructions 11. Use only with the cart, stand, 4. Do not use this apparatus near tripod, bracket, or table specified water. by the manufacturer, or sold with 5. Clean only with dry cloth. the apparatus. When a cart is used, 6. Do not block any ventilation use caution when moving the openings. I
Inhaltszusammenfassung zur Seite Nr. 7
DMS-AV HOME THEATER AMPLIFIER Safety Precautions To prevent fire or shock hazard, do not expose this unit to rain or moisture. Care should be taken to prevent objects or liquid from entering the enclosure. Never handle the power cord with wet hands. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: To completely disconnect this product from the main AC power, disconnect the plug from the wall socket outlet. The main plug is used to
Inhaltszusammenfassung zur Seite Nr. 8
DMS-AV HOME THEATER AMPLIFIER • To prevent the risk of electric shock, do not remove cover. No user- serviceable parts inside. Refer servicing to qualified service personnel. • These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. • The ventilation should not be impeded by covering the ventilation openings with items
Inhaltszusammenfassung zur Seite Nr. 9
DMS-AV HOME THEATER AMPLIFIER • It is recommended that the system speaker impedance seen by the amplifier channels of the receiver not fall below 4 ohms. Best amplifier thermal stability is achieved when it operates into a 4 ohms or greater speaker load. The nominal impedance of most home speakers range between 6 and 8 ohms. The receiver should be serviced by qualified personnel when: A. The receiver is not functioning properly. B. Objects have entered the chassis. C. The receiver was exposed t
Inhaltszusammenfassung zur Seite Nr. 10
DMS-AV HOME THEATER AMPLIFIER FCC INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment Off and On, the user is encouraged to try to correct the interferen
Inhaltszusammenfassung zur Seite Nr. 11
DMS-AV HOME THEATER AMPLIFIER DMS-AV Front Panel 1 2 3 4 5 6 7 1. Right-Hand Knob -The right selector knob’s primary purpose is audio volume adjustment. 2. Power LED – This LED illuminates Blue when the DMS-AV is ON and Red when the DMS-AV is in Standby mode. 3. Ethernet LED - The Ethernet LED illuminates STEADY BLUE when successfully connected to an Ethernet network, otherwise when not connected it will BLINK BLUE. 4. HDMI LED - The HDMI LED illuminates Blue when the DMS-AV is playing an HDM
Inhaltszusammenfassung zur Seite Nr. 12
DMS-AV HOME THEATER AMPLIFIER DMS-AV Rear Panel 1 2 3 4 5 6 7 8 9 10 11 12 13 1. Voltage Triggers, Reset Switch and Ethernet - The two 12 volt triggers present at this section of the back panel supply a maximum current of 100 mA, and can be used to trigger an external amplifier, or can also be used to trigger the use of an anamorphic lens on a projector. These jacks are both 3.5 mm mono style female mini jacks. The pin is positive(+), and the sleeve is ground. Each of the 12V DC triggers may be s
Inhaltszusammenfassung zur Seite Nr. 13
DMS-AV HOME THEATER AMPLIFIER 3. Remote Infrared Input - The Infrared Input port allows for easy integration with an RF(radio frequency) to IR (infrared) style base station, such as the URC MRF-350 or MRF-260. This port provides the ability to perform simple one-way control of the DMS-AV with a URC legacy-style infrared remote control, such as a MX-900, MX-980 or MX-880, among others. Use of this port with RF based remote controls allows for “stand alone” operation of the DMS-AV, that is, use o
Inhaltszusammenfassung zur Seite Nr. 14
DMS-AV HOME THEATER AMPLIFIER 8. Component Video Inputs/Output - The DMS-AV has three component video connections. Two of these connections are inputs, while the third connection acts as a video output (in case HDMI is not used). The component video inputs accept a maximum input resolution of 1080i/60Hz. The component video output supports a maximum output resolution of 1080i/60Hz. Composite and HDMI video are not converted and will not output via the component video. The on-screen display i
Inhaltszusammenfassung zur Seite Nr. 15
DMS-AV HOME THEATER AMPLIFIER Quick Start Considerations Your URC receiver is pre-programmed for ease of operation, right out of the box. In general, there is minimal setup required to start using your new DMS-AV Network Home Theater Processor. To quickly setup and begin operating your receiver, follow these steps: 1. Start with all AC power cords unplugged from their designated AC outlet. 2. From each source device, connect the A/V cables which could include composite, component, or HDMI
Inhaltszusammenfassung zur Seite Nr. 16
DMS-AV HOME THEATER AMPLIFIER The rest of this manual will give further insight into the many aspects of your new receiver. Some additional installation considerations should be noted as follows: • It is important that your electronic equipment be located where there is proper ventilation. Failure to ventilate your receiver could result in erratic operation and possible failure caused by overheating. A minimum of 3” should be maintained above the receiver. Do not place items directly on top of
Inhaltszusammenfassung zur Seite Nr. 17
DMS-AV HOME THEATER AMPLIFIER • Determine the type of cable that is needed for each connection. Keep in mind that the quality of the cabling that is used may make a difference in the overall audio and video quality. Try to keep interconnecting cable runs as short as possible. When routing cables between equipment, be sure to keep AC cables separate from audio cables. It is a good idea to bundle like cables together to keep interference (noise) to a minimum. • It is a good idea to label each cab
Inhaltszusammenfassung zur Seite Nr. 18
DMS-AV HOME THEATER AMPLIFIER Connection Overview Audio Connections Description Cable Jack HDMI Connections can carry uncompressed standard or High Definition digital video and audio. It offers the best HDMI picture and sound quality. This offers the best sound quality and allows a Dolby Optical Digital and DTS signal to be sent. The audio quality Digital is the same as for coaxial. Audio This offers the best sound quality and allows a Dolby Coaxial digital and DTS signal to be sent. The audi
Inhaltszusammenfassung zur Seite Nr. 19
DMS-AV HOME THEATER AMPLIFIER Video Inputs - Hardware Connections Video Input Connection – HDMI The URC surround processor provides 5 HDMI A/V inputs. While HDMI carries both audio and video, URC allows options to process audio and video separately (please see the menu setup for further options). To connect an HDMI video source to the URC DMS AV, connect the HDMI cable to the HDMI output on the source. Then connect the other end of the cable into the corresponding HDMI input on the processor.
Inhaltszusammenfassung zur Seite Nr. 20
DMS-AV HOME THEATER AMPLIFIER Video Outputs - Hardware Connections Video Output Connection - HDMI The HDMI output connection on the receiver carries high-definition video to your television or monitor. To connect an HDMI video output from the DMS- AV, connect the HDMI cable to the HDMI output on the DMS-AV. Then connect the other end of the cable into the corresponding HDMI input on your television or monitor. Shown below is the HDMI output on the DMS-AV going to the HDMI input on a monitor. HDMI
