Inhaltszusammenfassung zur Seite Nr. 1
User's Manual
Inhaltszusammenfassung zur Seite Nr. 2
Copyright © DENSO WAVE INCORPORATED, 2002 All rights reserved. No part of this publication may be reproduced in any form or by any means without permission in writing from the publisher. Specifications are subject to change without prior notice. All products and company names mentioned in this manual are trademarks or regis- tered trademarks of their respective holders.
Inhaltszusammenfassung zur Seite Nr. 3
Preface Please READ through these operating instructions carefully. It will enable you to operate your BHT-7500/7500S/7500W correctly. After you have finished reading the instructions, keep this manual handy for speedy reference. i
Inhaltszusammenfassung zur Seite Nr. 4
How this book is organized This manual is made up of five chapters and appendices. Chapter 1. Quick Guide Describes the basic operating method of the BHT and the related notes. Chapter 2. Getting Started the BHT and System Mode Summarizes the BHT system configuration and describes the operation including preparation and System Mode (which is required for the efficient use of application programs). Chapter 3. Communications Operations of BHT Describes the communications operations of the BHT—the
Inhaltszusammenfassung zur Seite Nr. 5
■ Technical Terms Used in This Manual Source Program and Object Program (User Program) Generally, a source program is translated into an object program by a compiler. This manual calls an object program a user program. BHT-BASIC This manual expresses BHT-BASIC3.0 and BHT-BASIC3.5 as BHT-BASIC. BHT/BHT-7500/BHT-7500S/BHT-7500W This manual expresses the BHT-7500/BHT-7500S/BHT-7500W as "BHT." If it is neces- sary to make a clear distinction between the BHT models, this manual uses the "BHT- 7500S
Inhaltszusammenfassung zur Seite Nr. 6
SAFETY PRECAUTIONS Be sure to observe all these safety precautions. ■ Please READ through this manual carefully. It will enable you to use the BHT and CU correctly. ■ Always keep this manual nearby for speedy reference. Strict observance of these warning and caution indications are a MUST for preventing accidents which could result in bodily injury and substantial property damage. Make sure you fully understand all definitions of these terms and related symbols given below, before you proceed
Inhaltszusammenfassung zur Seite Nr. 7
WARNING Handling the battery cartridge • Never disassemble or heat the battery cartridge, nor put it into fire or water; Never doing so could cause battery-rupture or put me leakage of battery fluid, resulting in a into fire! fire or bodily injury. • Do not carry or store the battery car- tridge together with metallic ball-point pens, necklaces, coins, hairpins, etc. Doing so could short-circuit the termi- Do not nal pins, causing the batteries to rup- short- circuit me! ture or the battery flu
Inhaltszusammenfassung zur Seite Nr. 8
WARNING • Do not look into the laser beam source through the reading window or point the reading window towards the eyes. The laser beam emitted through the reading window is harmful to the eyes. • Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation expo- sure. Handling the CU • If smoke, abnormal odors or noises come from the CU, immediately unplug the AC adapter from the wall socket and contact your nearest dealer. Fa
Inhaltszusammenfassung zur Seite Nr. 9
CAUTION Basic handling tips • Never put the BHT in places where there are excessively high temperatures, such as inside closed-up automobiles, or in places exposed to direct sunlight. Doing so could affect the housing or parts, resulting in a fire. • Avoid using the BHT in extremely hu- mid or dusty areas, or where there are drastic temperature changes. Moisture or dust will get into the BHT, resulting in malfunction, fire or electri- cal shock. • Never disassemble or modify the BHT; doing so c
Inhaltszusammenfassung zur Seite Nr. 10
CAUTION • If you drop the BHT so as to damage its hous- ing, immediately turn off the power, pull out Do not the rechargeable battery cartridge or dry bat- drop tery cartridge, and contact your nearest dealer. me! Failure to do so could cause smoke or fire. • For those machines using the dry battery cartridge, do not mistake the plus and minus marks when loading dry cells into the cartridge. Failure to do so could cause battery-rupture or leakage of battery fluid, resulting in bodily injury, fi
Inhaltszusammenfassung zur Seite Nr. 11
CAUTION • Never cover or wrap up the CU or AC adapter in a cloth or blanket. Doing so could cause the unit to heat up inside, deforming its hous- ing, resulting in a fire. Always use the CU and AC adapter in a well-ventilated area. • Do not place the CU anyplace where it may be subjected to oily smoke or steam, e.g., near a cooking range or humidifier. Doing so could result in a fire or electrical shock. • Keep the power cord away from any heating equipment. Failure to do so could melt the shea
Inhaltszusammenfassung zur Seite Nr. 12
■ Proper Care of the BHT and CU Clean the housings, battery cartridge terminals, and CU-7001 charge terminals with a dry, soft cloth. Before cleaning, be sure to turn the BHT power off and unplug the AC adapter of the CU. • Never use benzene, alcohol, or other or- ganic solvents. The housing may be Take care of me with a dry soft marred or the paint may come off. cloth. • Never rub or strike the liquid crystal dis- play (LCD) with anything hard. The LCD NO WAY!! surface will be easily scratch
Inhaltszusammenfassung zur Seite Nr. 13
BHT-7500 FCC Regulations This Device complies with Part 15 of the FCC Rules and RSS-210 Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide r
Inhaltszusammenfassung zur Seite Nr. 14
BHT-7500S US and Canada Regulations This device complies with Part 15 of the FCC Rules, Canadian ICES-003 and RSS-210 Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limi
Inhaltszusammenfassung zur Seite Nr. 15
BHT-7500S Labeling For USA and Canada For European Union For Australia FCC ID: PZWBHT-7500S
!" On the BHT is a radio frequency radiation related label suited to the destination. xiii
Inhaltszusammenfassung zur Seite Nr. 16
BHT-7500W Declaration of Conformity (For European Union) The radio frequency module that comlies with the Directive 99/5/EC(R&TTE) is mounted on this device (BHT-7500W). DECLARATION OF CONFORMITY Directive 99/5/EC (R&TTE) Manufacturer or Authorized representative : DENSO WAVE INCORPORATED Address : 1-1 Showa-cho, Kariya-shi, Aichi-ken, 448-8661, Japan We declare on our sole responsibility, that the following product : - Kind of equipment : Radio frequency module - Type-designation : MI802B3 is c
Inhaltszusammenfassung zur Seite Nr. 17
BHT-7500W Labeling For European Union
!" On the BHT is a radio frequency radiation related label suited to the destination. xv
Inhaltszusammenfassung zur Seite Nr. 18
Content Overviews Preface................................................................................................................................. i How this book is organized .............................................................................................. ii SAFETY PRECAUTIONS..................................................................................................... iv Chapter 1 Quick Guide .........................................................................
Inhaltszusammenfassung zur Seite Nr. 19
3.3 RS-232C Interface Specifications ............................................................................. 127 3.4 Basic Communications Specifications and Parameters ........................................ 129 3.4.1 Basic Communications Specifications ............................................................ 129 3.4.2 Communications Parameters ........................................................................... 131 3.5 Communications Protocols .................................
Inhaltszusammenfassung zur Seite Nr. 20
Chapter 1. Quick Guide Chapter 2. Getting Started the BHT and System Mode Chapter 3. Communications Operations of the BHT Chapter 4. Error Messages Chapter 5. Handling the CU-7000 (Option) Appendices
