Bedienungsanleitung American Standard Town Square Pressure Balance Bath/Shower Fitting 2555.602

Inhaltszusammenfassung zur Seite Nr. 1

Installation
Instructions
TOWNSQUARE
2555.602
PRESSURE BALANCING BATH AND
SHOWER-Built-in Diverter for TUB FILLER
with EverClean™ Finish
Congratulations on purchasing your American Standard faucet with
EverClean finish found only on American Standard faucets.
EverClean Finish
• One wipe effortlessly removes spots
 Eliminates the need for cleaners and scrubbing
Certified to comply with ANSI A112.18.1
 Permanent surface protectant remains beautiful
for the life of the faucet
M968789 Rev.

Inhaltszusammenfassung zur Seite Nr. 2

7 5 3 1 1 1 5 5 0 1 1 3 3 1 1 1 1 9 9 7 7 5 5 3 3 1 1 INSTALL DIVERTER DIVERTER 2 PORT When finished tiling the wall, remove PLASTER GUARD (1). Remove two screws that secure the DIVERTER LID (2) and 2 remove Lid. Inspect the inside surface of diverter port. Diverter port must be free of any dirt. Clean if necessary. Install DIVERTER (3) with SCREWS (4) removed from DIVERTER LID (2). Operate DIVERTER (3). DIVERTER (3) should slide in and out smoothly. Push on DIVERTER COVER (5). 3 4 5 INSTALL TRI

Inhaltszusammenfassung zur Seite Nr. 3

INSTALL HANDLE 5 Install HANDLE BUSHING (1) onto CAP (2). 7 Find correct position of HANDLE (3) and push HANDLE (3) onto VALVE STEM (4). Install HANDLE SCREW (5) and push in INDEX CAP (6). Check proper operation of HANDLE. 5 6 Screw on DIVERTER KNOB (7). 2 1 4 3 TO GAIN ACCESS TO VALVE FOR SERVICING 6 Pull INDEX CAP, unscrew HANDLE SCREW and pull HANDLE off valve stem. Remove two SCREWS holding ESCUTCHEON and remove ESCUTCHEON. Remove COVER by pulling straight out. Shut off water supply by eith