Bedienungsanleitung Axor Citterio 39144XX1

Inhaltszusammenfassung zur Seite Nr. 1

Installation / Warranty
Citterio
39144XX1
Citterio
39148XX1
90614801 02/2006

Inhaltszusammenfassung zur Seite Nr. 2

Axor Citterio Wall Mount Lav Mixer with Cross Handles 39144XX1 Axor Citterio Wall Mount Lav Mixer with Lever Handles 39148XX1 39144XX1 39148XX1 Technical Data Flow rate @ 45 psi 2.2 gpm Maximum water pressure 145 psi Recommended water pressure: 14.5 - 75 psi o o Recommended hot water temp.: 120 F - 140 F* *Some municipalities limit the maximum water temperature from the water heater to o 120 or below. Please know and follow all applicable local

Inhaltszusammenfassung zur Seite Nr. 3

· Remove the inserts from the hot and cold plaster shields. · Cut the plaster shields so that they extend 1/16” from the wall. Seal around the shields with a suitable, non-staining, waterproof bathroom sealant. · Lever handle version only: Remove the hot and cold cartridges using a 17 mm deep socket wrench. Replace them with the 1⁄4 turn ceramic cartridges included with the trim kit. The hot cartridge is marked with notches on the wrench flats. · On the spout outlet,

Inhaltszusammenfassung zur Seite Nr. 4

· Install the outer sleeves to the hot and cold valves. Measure each outer sleeve to a point 3/8” from the surface of the finished wall. Mark the sleeve at this point. Cut the sleeves. Install the inner sleeve. · Measure the inner sleeve to a point 1⁄2” from the surface of the finished wall. Mark and cut the inner sleeve at this point. Place the handle over the inner sleeve. · The handle should be parallel to the floor. If it is not, remove the handle. Remove the ha

Inhaltszusammenfassung zur Seite Nr. 5

· Attach the spout and spout escutcheon to the wall plate with the screws provided. · Place the plate and spout assembly over the valve. Install the handle escutcheons and the handles. Turn the handle bases clockwise, so that they thread onto the outer sleeves. · Secure the spout to the spout adapter by tightening the set screw. User Instructions – Lever handle version · Turn the handle downwards (clockwise for cold, counter- clockwise for hot) to turn the water on.

Inhaltszusammenfassung zur Seite Nr. 6

Replacement parts 1 lever handle 39296XXX 2 cross handle 39295XXX 3 hot escutcheon 96759XXX 4 cold escutcheon 96758XXX 5 spout escutcheon 96760XXX 6 escutcheon 96757XXX 7 aerator 13085000 8 fixing set 96393000 9 hot cartridge 96351000 10 cold cartridge 96350000 11 extension kit 96259000 (optional)

Inhaltszusammenfassung zur Seite Nr. 7

Cleaning Recommendation for Hansgrohe Products Modern faucetry and shower products utilize a combination of materials to comply with the needs of the market with regard to design and functionality. To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper treatment is not covered under the Hansgrohe warranty. Cleaning Materials for Faucets and Showers • To remove lime scale, use only products made specifically for that purpose. Always follow the man

Inhaltszusammenfassung zur Seite Nr. 8

THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR: A. Conditions, malfunctions or damage not resulting from defects in material or workmanship. B. Conditions, malfunctions or damage resulting from (1) improper installation, improper maintenance, misuse, abuse, negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “no rinse” cleaning products, or the use of the product in any manner contrary to the product instructions. C. Labor or other expense