Bedienungsanleitung Human Touch Massage Chairs

Inhaltszusammenfassung zur Seite Nr. 1

July 29, 2009
REPLACING THE BACKREST COVER
HT-5040
®
To ensure that Human Touch products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all
SERVICE LEVEL: 2
product repairs are performed using only factory-new parts and in accordance with these product repair instructions.
Tools Required: 4 mm (5/32" " ") ) A Allen llen key key, , P Phillips-head hillips-head scr screw ewdr driv iver er, , fla flat t-head -h

Inhaltszusammenfassung zur Seite Nr. 2

6. Tip the backrest cover backward then lay it carefully down on the floor behind the chair. 7. Disconnect the connector at the base of the backrest (Fig.4). 8. Using a flat-head screwdriver, remove the screw that secures the yellow/ Ground wire green ground wire to the chair frame. screw 9. Remove the backrest cover. Ground wire Connector Back Backr rest est c co ov ver er (Fig.4) 2

Inhaltszusammenfassung zur Seite Nr. 3

INSTALLING THE NEW BACKREST COVER 1. Place the new backrest cover on the floor behind the chair, as shown (Fig.5). Ground wire 2. Connect the large connector. screw 3. Insert the ground wire screw through the loop on the end of the ground wire, place the screw in the corresponding screw hole on the chair frame, then secure the screw using a flat-head screwdriver (Fig.5). 3. Thread the remote control cables from the backrest through the backrest cover, so that they are accessible after th