Bedienungsanleitung Aiphone JA-DGV

Inhaltszusammenfassung zur Seite Nr. 1

1206
Vandal Resistant Color Pan Tilt Video Door Station
- INSTALLATION INSTRUCTIONS -
FLUSH MOUNTING INSTRUCTIONS
1. Cut a hole in the wall that is 9-1/16" x 6-1/8". (Ensure
that mounting depth of at least 2-11/16" is available.)
2. Pass cable through knockout holes.
3. Secure back box to wall so that front of box is flush with
the outside edge of the wall.
4. Connect wires to the JA-DGV. (See wiring diagram)
5. Attach the JA-DGV to the mounting box using the
supplied screws and tamper proo

Inhaltszusammenfassung zur Seite Nr. 2

WIRING PRECAUTIONS 1. Keep video wires at least 12" away from AC 100~240V power lines. 2. Use 2 conductor non-shielded wire with PE insulation. (Aiphone 871802 wire.) Coax-cable cannot be used. 3. If there are unused wires in the cable, install a 120 Ω resistor between each pair of unused conductors. JA-DGV JA-2MCD 4. Do no mix audio/video wires with those of another video door station or device in the same cable. IMAGE VIEW AREA (approx.) when panned-and-tilted •The image view area is a guide

Inhaltszusammenfassung zur Seite Nr. 3

SPECIFICATIONS Power Source: Supplied by master station. Consumption: 370mA (max.) 4.5mA (Standby, approximate) Picture element: CCD camera Image view area Vertical Horizontal (approx.): In horizontal position: 18" 26" When pan-and-tilted: 3' 6' Min. illumination: Less than 1 Lux (at 20" from camera). Ambient temperature: 14° F ~ 140° F. Wiring: 2 parallel wires, non-polarized to master. PE Insulated, low capacitance. Use Aiphone wire # 871802 Wiri