Inhaltszusammenfassung zur Seite Nr. 1
DESKPOWER 6000/SS Series User’s Manual
Fujitsu endeavours to ensure that the information in this document is correct, but accepts no liability
for any error or omission in the same. Any procedures described in this document for operating Fujitsu
products should be read and understood by the operator before such products are used. To ensure
that Fujitsu products function without risk to safety and health, such procedures should be strictly
observed by the operator. The development of Fujitsu prod
Inhaltszusammenfassung zur Seite Nr. 2
IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions carefully. Save these instructions for future reference. 2. Follow all warnings and instructions marked on the product. 3. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. 4. Do not use this product near water. 5. Do not place this product on an unstable cart, stand, or table. The product may fall, causing serious damage to the product. 6. Slots and ope
Inhaltszusammenfassung zur Seite Nr. 3
13. Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a. When the power cord or plug is damaged or frayed. b. If liquid has been spilled into the product. c. If the product has been exposed to rain or water. d. If the product does not operate normally when the operating instructions are followed. Adjust only those controls that are covered by the operating instructions since improper adjustment of other controls may result
Inhaltszusammenfassung zur Seite Nr. 4
Before Starting Your PC For Safe Operations This manual contains the important safety information for using DESKPOWER. Read this manual thoroughly before using your PC. This equipment may be adversely affected by the momentary drop of supplied voltage due to lightning. An uninterruptible AC power supply is recommended to use against the momentary drop of supplied voltage. (This message is based on the Japan Electronic Industry Development Association’s guidelines for measures against momentary v
Inhaltszusammenfassung zur Seite Nr. 5
Conventions used in this manual Warning messages This manual uses various pictorials. This manual uses various safety signs and symbols so that you can use the PC system safely and prevent personal injury and/or property damage. The following gives the signs and their explanations. Be familiar with these signs before proceeding to the subsequent sections of this manual. This indicates a hazardous situation that could result in death or severe injury CAUTION if the user does not perform the proc
Inhaltszusammenfassung zur Seite Nr. 6
Command entry (from keyboard) A command entry is represented in this manual as follows: diskcopy a: a: ↑↑ • If two letters are separated by a space as indicated by the top arrow, press the [Space] bar once. Commands, an example of which is given above in lowercase, can also be entered in uppercase. • [CD-ROM drive] indicates the name of CD-ROM drive being used. Enter the drive name in accordance with your PC environment. [CD-ROM drive]:\setup.exe Sample screens Only the typical examples are show
Inhaltszusammenfassung zur Seite Nr. 7
Warning and caution labels Your PC bears the warning and caution labels as shown below. Never detach or soil the warning or caution labels. Rear surface of the equipment TN DESKPOWER MODEL FPC-S90000 LISTED U UL1950 P/N CP070181-01 L ® 7J61 200-240V(1.75A)/100-120(3.5A) 50/60Hz MADE IN SINGAPORE By Fujitsu Limited Japan(J) FUJITSU LIMITED To prevent electric shock, WARNING switch off the PC and connected peripherals and Electric shock unplug power cords from respective outlets before disa
Inhaltszusammenfassung zur Seite Nr. 8
Manual configuration Chapter 1 Introduction This chapter provides basic information on the PC, such as the names and functions of individual parts, and also explains the basic operation of the PC, such as turning the power on or off. Chapter 2 Hardware This chapter provides basic information on how to handle the peripherals installed (or can be installed) on the PC. Chapter 3 Troubleshooting This chapter explains the BIOS Setup program used to set the date or energy- saving mode of the PC. In ad
Inhaltszusammenfassung zur Seite Nr. 9
Contents CHAPTER 1 Introduction 1 Part Names and Functions ..............................................................2 Front of the PC unit .......................................................................................... 2 Back of the PC unit .......................................................................................... 4 Inside the PC unit ............................................................................................. 6 Motherboard .......................
Inhaltszusammenfassung zur Seite Nr. 10
3 Increasing the Memory Capacity...................................................39 Location of memory modules ......................................................................... 40 Applicable memory modules .......................................................................... 40 Installing memory modules ............................................................................ 41 4 Installing Expansion Cards ............................................................44 Location
Inhaltszusammenfassung zur Seite Nr. 11
CHAPTER 1 Introduction
Inhaltszusammenfassung zur Seite Nr. 12
1 Part Names and Functions This section explains the names and functions of the parts of the PC unit and the motherboard. Front of the PC unit 1 2 3 9 10 11 4 5 6 12 7 13 8 14 15 2
Inhaltszusammenfassung zur Seite Nr. 13
1 Power switch Press this switch to turn on the PC or set the system to the standby mode. 2 Power lamp This lamp lights up when the PC is on. It lights up in green when the PC is in operation and in amber when the PC is in the standby (power- saving) mode. 3 Hard disk access lamp This lamp lights up while the hard disk is accessed. 4 Volume Use this control to adjust the volume of the speaker or headphones. Turn this control upward to increase or downward to decrease the volume. 5 Headphone jack
Inhaltszusammenfassung zur Seite Nr. 14
Back of the PC unit 1 6 2 7 8 3 9 4 10 11 5 12 13 14 15 4
Inhaltszusammenfassung zur Seite Nr. 15
1 Venthole An opening provided to let heat go out of the PC. 2 Inlet Connect the power cable of the PC unit to this connector. 3 Outlet Connect the power cable of the display to this outlet. 4 Burglarproof lock Install a lock to protect the device inside the PC against theft. 5 Expansion slot Insert an optional expansion card to this slot. This slot accommodates a PCI card. 6 Mouse connector Connect a mouse. 7 Keyboard connector Connect the keyboard. 8 Serial connector Connect the cable of an RS
Inhaltszusammenfassung zur Seite Nr. 16
Inside the PC unit 1 2 3 1 Expansion slot Insert an optional expansion card to this slot. This slot accommodates a PCI card. A SCSI card allows you to use an external hard disk drive or magneto-optical disk drive. 2 Power supply unit 3 Internal hard disk This is an IDE-compliant hard disk. 6
Inhaltszusammenfassung zur Seite Nr. 17
Motherboard 1 2 5 6 4 3 1 CPU 2 DIMM slots Memory modules are inserted into these slots. When seen from the front of the PC unit, DIMM1 and DIMM2 are arranged in this order from the right. 3 Secondary IDE connector (IDE2) A standard CD-ROM is connected. 4 Primary IDE connector (IDE1) A standard hard disk is connected. 5 Internal battery This battery provides power to retain information on date and time, and settings made in BIOS Setup. The life is about 5 years under normal use. 6 Floppy conne
Inhaltszusammenfassung zur Seite Nr. 18
2 Keyboard This section explains the functions of the keys on the keyboard. The keyboard shown in this diagram is an example. Depends on the model, the keyboard layout may differ but the function of the keys is similar. Point The functions assigned to the keys vary depending on an OS or program running on your PC. For details, refer to the manual for the OS or program. 12 345 67 20 8 9 10 11 12 13 14 15 16 17 18 19 1 Esc (escape) key Press the Esc key to terminate the execution of softwar
Inhaltszusammenfassung zur Seite Nr. 19
8 Caps Lock/Alphanumeric key Use the Caps Lock/Alphanumeric key to type alphabetical characters. Press [Caps Lock] to switch between uppercase and lowercase. 9 Ctrl (control) key Use the Ctrl key in combination with another key. Its function varies with each application. 10 Windows key Press the Windows key to display the “Start” menu. 11 Alt key Use the Alt key in combination with another key. Its function varies with each application. 12 Application key This key has the same function as clicki
Inhaltszusammenfassung zur Seite Nr. 20
3 Mouse Left button Scroll button Right button Point • Clean the mouse regularly. Using the mouse Moving the mouse Lightly hold the mouse and place your index and middle fingers on the left and right buttons on the mouse. Slide and move the mouse over a plane surface, such as a desktop. As you move the mouse, an arrow (called the mouse pointer) moves in the same way on the screen. Move the mouse and see how the mouse pointer moves. Using the mouse buttons Clicking Click Clicking is a
