Inhaltszusammenfassung zur Seite Nr. 1
27” Built In Wall Oven/ with
Installation
Microwave
Instructions
JKP85
“If you have questions, call 800-GE-CARES or visit our website at:
www.GEAppliances.com”
Before you begin
• ATTENTION INSTALLER!!
Read these instructions carefully and completely
All electric wall ovens must be hard wired
• IMPORTANT-Save these instructions for
(direct wired) into an approved junction
local inspector’s use.
box. A “plug and receptacle” is NOT
• IMPORTANT-Observe all governing
permitted on these products
codes
Inhaltszusammenfassung zur Seite Nr. 2
Installation Instructions IMPORTANT SAFETY INSTRUCTIONS Electrical For Your Safety Requirements This appliance must be supplied with the • Be sure your oven is installed properly by proper voltage and frequency, and connected a qualified installer or service technician. to an individual properly grounded branch • Be sure the oven is securely installed in a circuit, protected by a circuit breaker or fuse cabinet that is firmly attached to the house having amperage as noted on rating plate. struct
Inhaltszusammenfassung zur Seite Nr. 3
EASY INSTALLATION OF YOUR NEW 30" WALL OVEN Bef Bef Bef Bef Bef Bef Bef Bef Bef Bef Bef Befor or or or or or or or or or or ore e e e e e e e e e e e you you you you you you you you you you you you b b b b b b b b b b b begin-Read th egin-Read th egin-Read th egin-Read th egin-Read th egin-Read th egin-Read th egin-Read th egin-Read th egin-Read th egin-Read th egin-Read the e e e e e e e e e e es s s s s s s s s s s se e e e e e e e e e e e iiiiiiiiiiiin n n n n n n n n n n ns s s s
Inhaltszusammenfassung zur Seite Nr. 4
Installation Instructions Pre- Installation Checklist cont. Remove the bottom trim from the Place the oven on a table or platform top of the oven. It will be installed at even with the cutout opening. the end of installation. The trim is (Platform must support 275 lbs.) wrapped separately and taped to the top of the unit. Bottom Trim Side Trim 4
Inhaltszusammenfassung zur Seite Nr. 5
Installation Instructions Cutout for Built-In Oven W/Microwave A JUNCTION BOX Cabinet Width 27” LOCATION CABINET 10" WIDTH Recommended 27" Cutout Location From Floor ..... 21 5/8” CUTOUT WIDTH 25" MIN. Cutout Depth .23 1/2” Allow 7/8" 25 1/4" MAX. for overlap of Cutout Width .. 25 ” Min. oven over side edges of cutout ........................ 25 1/4” Max. Cutout Height 41 1/8” Min. 2" x 4" CUTOUT ........................ 41 1/4” Max. HEIGHT or 48" 41 1/8" MIN. equivalent Overall Height 41
Inhaltszusammenfassung zur Seite Nr. 6
Installation Instructions Electrical Connections B Turn off the circuit breaker or remove fuses ATTENTION INSTALLER!!! B1 to the oven branch circuit. All electric wall ovens must be hard wired (direct wired) into an approved junction With the oven in front of the cabinet B2 box. A plug and receptacle is NOT opening, on a table or platform, connect the permitted on these products. flexible conduit to the electrical junction box as shown below. You will need to purchase Do not shorten the flexible
Inhaltszusammenfassung zur Seite Nr. 7
Installation Instructions Electrial Connections cont. B NEW CONSTRUCTION AND OR FOUR-CONDUCTOR BRANCH CIRCUIT CONNECTION Three-Conductor Branch B4 Circuit Connection • When installing in a new construction, B3 or • When installing oven in a mobile When connecting to a 3-conductor branch home, or circuit, if local codes permit: • When local codes do not permit grounding through neutral: a.Connect the bare oven ground conductor with the crimped neutral (white) lead to the a. Cut the neutral (White
Inhaltszusammenfassung zur Seite Nr. 8
Installation Instructions Placing the Oven in the Opening C Sliding the Oven Into the Drilling the Pilot Holes C2 C1 Opening. a. Loop (do not tie) a 36” string around the Note: Before drilling the pilot holes conduit before the oven is slid into place. make sure the oven is pushed as far This will keep the conduit from falling behind back into the opening as it will go the oven. and centered. Pull out on string a. Drill four-1/8” pilot holes through the mounting PULL OUT ON STRING LOOP loop whil
Inhaltszusammenfassung zur Seite Nr. 9
Installation Instructions Replacing the Oven Preparing for the bottom C3 D Trim Installation Door a. With oven installed, take the bottom trim and center it on the bottom front edge of The oven door is heavy. You may need the cabinet opening. help lifting the door high enough to slide it into the hinges slots. Do not lift b. Using the trim as With Lower Trim With Lower Trim the door by the handle. a template mark In Position In Position Mark (3) Mounting Mark (3) Mounting
Inhaltszusammenfassung zur Seite Nr. 10
Installation Instructions E PRE-TEST CHECK LIST Check that the bottom trim is installed Remove all protective film if present, properly (see page 9). and any stickers. Check to be sure that all wiring is Check to be sure the mounting screws secure and not pinched or in contact are installed and flush with the side with moving parts. trim, (see page 9). Operation Checklist NOTE TO ELECTRICIAN: Remove all items from the inside The power leads supplied with this of the oven. appliance are UL recogn
Inhaltszusammenfassung zur Seite Nr. 11
NOTES 11
Inhaltszusammenfassung zur Seite Nr. 12
Pub. No. 31-10480 229C4053P460
