Bedienungsanleitung Actiontec electronic 1524

Inhaltszusammenfassung zur Seite Nr. 1

Actiontec® 1520 and 1524

How to Recover Firmware for Mac OS® 8.01 to 9.2.2



If your Actiontec® DSL modem isn’t working (i.e., the Internet LED light isn't on) or isn’t responding
properly, this recovery procedure will reset the modem to factory defaults.
Before you begin the steps in this document:
• Download the appropriate firmware recovery file, either for the Actiontec 1520 or 1524.
• Plug the modem into one computer directly, using the Ethernet cable (don’t use a wireless
c

Inhaltszusammenfassung zur Seite Nr. 2

2. Select Apple. Then select Control Panels and TCP/IP. © 2005 Qwest Communications International Inc. 2

Inhaltszusammenfassung zur Seite Nr. 3

3. Select Configure. Then select Manually. © 2005 Qwest Communications International Inc. 3

Inhaltszusammenfassung zur Seite Nr. 4

4. To complete the modem firmware recovery, set your TCP/IP stack for static IP addressing using the following values: • IP Address: 192.168.0.99 • Subnet Mask: 255.255.255.0 • Router Address: 192.168.0.1 NOTE: If you’ve changed the LAN IP Address of your Actiontec gateway, use the new LAN IP address for the router address. 5. Select Save. © 2005 Qwest Communications International Inc. 4

Inhaltszusammenfassung zur Seite Nr. 5

6. Double-click on the folder placed on your desktop during the un-stuff process. 7. Select the recovery icon to start the recovery process. © 2005 Qwest Communications International Inc. 5

Inhaltszusammenfassung zur Seite Nr. 6

8. Select Start. © 2005 Qwest Communications International Inc. 6

Inhaltszusammenfassung zur Seite Nr. 7

9. When you see Tftp Server started! and Bootp Server started!, unplug the power from the back of the modem and hold down the Reset button. While holding down the Reset button, plug the power cord back into the modem. Once the recovery process starts, release the Reset button. NOTE: Once the recovery process begins, don’t interrupt it. If interrupted, you’ll have to start the process again from the beginning. © 2005 Qwest Communications International Inc. 7

Inhaltszusammenfassung zur Seite Nr. 8

10. Once the progress bar displays 100%, the recovery process is complete. Select Exit. 11. Unplug the power cable from the back of the modem. Wait 30 seconds and plug it back in. The modem will automatically train, but you need to reconfigure it before you can browse the Internet. 12. Before you begin the reconfiguration process, set your Mac to dynamic addressing. © 2005 Qwest Communications International Inc. 8

Inhaltszusammenfassung zur Seite Nr. 9

13. Select Apple. Then select Control Panels and TCP/IP. © 2005 Qwest Communications International Inc. 9

Inhaltszusammenfassung zur Seite Nr. 10

14. Select Configure. Then select Using DHCP Server. 15. Select Save. Then close the window by clicking on the red ball in the top left corner. 16. Reconfigure the Actiontec modem according to the configuration information you recorded before starting this recovery process. For additional information, refer to your ISP worksheet. © 2005 Qwest Communications International Inc. 1 0