Inhaltszusammenfassung zur Seite Nr. 1
User Manual for the Antari M-1 Mobile Fog Machine
Congratulations on the purchase of your new
ANTARI M-1 Mobile Fog Machine
Save and read these instructions
Bitte lesen Sie und sichern Sie diese Anweisungen
Lisez et Gardez ces instructions
© 2007 Antari Lighting and Effects Ltd.
M-1 Mobile Fogger
Inhaltszusammenfassung zur Seite Nr. 2
INTRODUCTION Thank you for choosing Antari’s M-1 Mobile Fogger. You now own a sturdy and portable state-of-the-art fog machine. Prior to use, we suggest that you carefully read all of the instructions. By following the suggestions found in this user manual, you can look forward to exceptional performance from your Antari Mobile Fog Machine for years to come. Please follow these operations, safety and maintenance instructions to ensure a long and safe life for your fog machine. Spe
Inhaltszusammenfassung zur Seite Nr. 3
No user serviceable parts inside. Refer to your Antari dealer or other qualified service personnel. Danger of Burns For adult use only. Fog machine must be installed out of the reach of children. Never leave the unit running unattended. Keep nozzle at least 50 cm (20 in.) away from contact with anything while in operation. The fog vapor at point of release is under pressure and is extremely hot. Never aim the output nozzle directly at people. Fog machine output is h
Inhaltszusammenfassung zur Seite Nr. 4
UNPACKING & INSPECTION Open the shipping carton and check that all equipment necessary to operate the system has arrived intact. In addition to this user manual, you should receive the following items: 1. M-1 Mobile fogger 2. 12V – 2.3Ah rechargeable battery 3. Rechargeable battery charger 4. Power cable for the battery charger 5. 500 cc bottle of Antari fog liquid 6. Briefcase sized Mobile Fogger flight case Before beginning initial setup of your Antari M-1 Mobile Fog Machine,
Inhaltszusammenfassung zur Seite Nr. 5
1. Lift-up the plate before inserting the battery. 2. Make sure the battery is inserted on the right position (see photo). The green light by the front of the handle will flash when the button is first pressed. This indicates the battery has enough charge to power the M-1. When the red light starts to flash, the battery needs to be charged. The machine will still be able to fog for a short period of time after the red light begins flashing. 5
Inhaltszusammenfassung zur Seite Nr. 6
OPERATION To generate smoke, press the button on the front of the M-1 Mobile Fogger’s handle. There are two operation modes that can be selected for the M-1. 1. Operation mode 1. Allows the fog machine to fog as long as the handle’s button or the remote control’s button is pressed down. To stop fogging, stop pressing the button. 2. Operation mode 2. Works on a press once to start and press again to stop basis. In this mode, start fogging by pressing the button. The M-1 will
Inhaltszusammenfassung zur Seite Nr. 7
Installation The M-1 Mobile Fogger can be carried in hand or installed in a fixed location as desired. Wherever the machine is placed, it is important that fog does not shoot directly at any one’s face, at open flames or directly into any heat susceptible material. The machine can be held or installed at any angle. After refilling the liquid tank, screw the cap on tightly. Failing to do so will result in leakage if the machine is placed at an angle. 7
Inhaltszusammenfassung zur Seite Nr. 8
OPTIONAL REMOTE CONTROL OPERATION There are two optional remote controls designed for the M-1 Mobile Fogger. 1. MCT-1 Timer Remote Control: This remote control is connected via an 8-meter cord. The duration of the fog blast is set at 10 seconds. The interval is controlled by the dial on the remote and is adjustable between 3 and 220 seconds. 2. MCR-1 Wireless Remote Control: This remote control consists of two components. The transmitter is on a small key chain and has a range of up t
Inhaltszusammenfassung zur Seite Nr. 9
Do not open the case. There are no user serviceable parts inside. Return the machine to an Antari dealer for service. Performance Notes All fog machines develop condensation around the output nozzle. Because this may result in some moisture accumulation on the surface below the output nozzle, consider this condensation when installing your unit. Fog machines may sputter small amounts of fog occasionally during operation and for a minute or so after being turned off. This is nor
Inhaltszusammenfassung zur Seite Nr. 10
C08M1 10
