Bedienungsanleitung Tascam IF-CB

Inhaltszusammenfassung zur Seite Nr. 1

IF-CB/DM
CobraNet Interface Card
Introduction Names and functions of parts
Thank you very much for purchasing the TASCAM IF-CB/
DM CobraNet™ Interface Card for TASCAM DM-3200
and DM-4800 mixers.
This Interface Card allows a TASCAM DM-3200/DM-4800
to be connected to a CobraNet digital audio network and to
send and receive up to 32 channels (16 inputs/16 outputs)
of uncompressed digital audio signals with a sampling
frequency of 48 kHz.
Before using the unit, please take time to read this ma

Inhaltszusammenfassung zur Seite Nr. 2

IF-CB/DM CobraNet Interface Card 2 Insert the IF-CB/DM card into the slot. Insert the card completely, aligning its edges with the white guidelines on the inside of the slot. Push the card in until it clicks into place and its backplate is even with the back of the mixer. Do not, however, push the card too hard. If you are having difficulty inserting it properly, pull it out once and try again. 3 Use the five screws that you removed earlier or the five screws included with this card to f

Inhaltszusammenfassung zur Seite Nr. 3

IF-CB/DM CobraNet Interface Card DUAL LINK: This shows the network connection method. Prefer Primary (default setting): • The Primary network has priority. If the Primary network connection is lost, the mixer automatically switches to the Secondary network, and reconnects to the Primary network when it recovers. Always Primary: • Only uses the Primary network. Always Secondary: • Only uses the Secondary network. Auto Switch: • Input settings (input routing) Uses the Primary netwo

Inhaltszusammenfassung zur Seite Nr. 4

IF-CB/DM CobraNet Interface Card Installing CobraNet Discovery 1 The latest version of CobraNet Discovery Utility can be downloaded at the following site. http://www.cobranet.info/downloads/disco DM-4800 OUTPUT SLOT page 2 Double-click the downloaded file and follow the 1 Use the POD 4 knob to select the output source instructions shown onscreen to install the software. group from the SOURCE SELECT at the right of 3 If the .NET Framework has not been installed on the screen. Options for eac