Inhaltszusammenfassung zur Seite Nr. 1
DO NOT REMOVE PRIOR TO SALE!
OWNER’S MANUAL
Model 1193 w/harness
Model 1189
I. APPROVAL CONDITIONS and CARRIAGE REQUIREMENTS
Inflatable PFD Model No. 1189 is approved by the U.S. Coast Guard
for use as Type III Personal Flotation Device (PFD) and Model No.
1193 is approved as Type V Personal Flotation Device (PFD) with Type
III performance because the harness with it can cause injury if not
properly used.
Inflatable PFD’s are not approved for water skiing or other high impact,
high-speed activi
Inhaltszusammenfassung zur Seite Nr. 2
MECHANISM PARTS LIST SPECIFICATIONS Chest Size: 30 - 52 inches (76 - 132 cm) Weight Range: More than 90 pounds (41 kg) Minimum Height: For harness model 1193 only - 5 feet 5 inches (165cm) Age Range: 16 years of age and older Buoyancy (minimum): 33.7 Pounds (150 Newtons) when fully inflated Inflation System: Manual Inflation Mechanism (located on your right side) Oral Tube (located on your left side) Pull Tab (located on your right side) used to manually activate the inflation mechanism and inf
Inhaltszusammenfassung zur Seite Nr. 3
HARNESS USE INSTRUCTIONS FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY OR DEATH. • ALERT! Under no circumstances should the sailing harness be used in any climbing task or related activity. Failure to comply with this restriction in use may result in death or injury. • Always adjust harness snugly around your body. Failure to adjust properly may increase chance of injury. • Only use a tether that is less than 6.5 feet (2 meters) long. • This harness is not suitable for fall arrest
Inhaltszusammenfassung zur Seite Nr. 4
ADDITIONAL HARNESS INFORMATION • This harness was designed and tested to meet the requirements for OFFSHORE RACING COUNCIL (ORC) requirements for Sailing Harnesses. • USCG approval does not apply to the sailing harness. • It is strongly recommended that first time users of Sailing Harnesses receive instruction from a reputable dealer, sailing school, or otherwise experienced harness sailor. • Always wear over all other clothing to allow for chamber expansion during inflation. • Harness that is a
Inhaltszusammenfassung zur Seite Nr. 5
READ BELOW FOR MORE DETAILED INFORMATION! 1. Inspecting Your PFD For Damage Make sure that the PFD is free from rips, tears or punctures. This type of damage on the outside covering indicates that the Inflatable Chamber may have been exposed to potentially damaging elements. If these defects expose the yellow inflatable chamber material, discontinue use of the PFD until you have the PFD inspected by an authorized repair facility. If these defects are noticed but the yellow inflatable chamber ma
Inhaltszusammenfassung zur Seite Nr. 6
DONNING INSTRUCTIONS STEP 1 Wear like a jacket, inserting arms between straps and fabric. STEP 2 Close front buckle. Manual pull lanyard should be visible on your lower right side. STEP 3 Adjust belt through slide located on right side until a comfortably snug fit is obtained. For Model 1193 with harness, be sure that the bottom of the harness belt is at least 2 inches ( 5cm) above lowest rib. Adjust belt keeper to reduce slack in webbing. After donning, locate the Jerk To Inflate tab fo
Inhaltszusammenfassung zur Seite Nr. 7
INFLATION INSTRUCTIONS See Pages 12 -14 for additional information on testing and inflating your PFD. 1. Manual Inflation - To inflate, grasp the Jerk to Inflate tab and pull sharply downward. 2. Oral Inflation - The Oral Tube is located on the wearer's left side. Grasp the Oral Tube and bring to mouth. Blow air through the Oral Tube until the Inflatable Chamber is firm. If the chamber becomes soft due to CO2 permeance, Oral Inflation will be necessary to maintain full buoyancy. Whenever you ora
Inhaltszusammenfassung zur Seite Nr. 8
DEFLATION INSTRUCTIONS Depress Oral Valve (located inside end of Oral Tube) using either the protective cap or tab provided by inserting into the end of Oral Tube, see drawing. Gently compress air out of the inflatable chamber while depressing the Oral Valve. DO NOT TWIST OR WRING INFLATABLE CHAMBER TO DEFLATE. If for any reason the Oral Valve remains open, depress it several times. If it does not release, discontinue use of this PFD and take it to a certified repair station. (See Page 11 for
Inhaltszusammenfassung zur Seite Nr. 9
FREEZING TEMPERATURES Never use in below freezing temperatures, unless worn partially inflated. At or below 40° F (4° C) inflation time with CO2 gas will be longer. Wearing a partially inflated PFD in these conditions will provide some initial buoyancy while the PFD fully inflates. Caution: Do not fully inflate orally and then inflate with the CO2 cylinder. Repeated CO2 inflation after oral inflation will damage the PFD to the point that it will not hold air or float. OTHER USE GUIDELINES 1. Alw
Inhaltszusammenfassung zur Seite Nr. 10
V. CARE AND MAINTENANCE INSTRUCTIONS GENERAL PRODUCT LIFE EXPECTANCY The reliability and service life of this PFD depends greatly upon how it is used and cared for. Avoid storing PFD in direct sunlight. Sunlight contains ultraviolet radiation that weakens synthetic materials. Prolonged exposures to high temperatures and high humidity may shorten service life of this PFD. While it is known that these elements degrade the materials, every use environment is unique so there is no sure way to estim
Inhaltszusammenfassung zur Seite Nr. 11
REARMING KIT(S) Use Rearming Kit No. 0932. See Rearming Instructions on back cover. CARE AND CLEANING INSTRUCTIONS Drying - If the device is wet, place on a coat hanger to allow thorough drying. Do not place in direct sunlight to dry. Do not use any heat source or place on radiator. Cleaning - Damp wipe only with mild detergent recommended for synthetic fabrics. Remove grease and oil immediately. After every use, rinse well with fresh water. Read instructions provided on the device. • DO NO
Inhaltszusammenfassung zur Seite Nr. 12
VI. WHY ARE PFDS REQUIRED SAFETY EQUIPMENT? Drownings are the leading cause of fatalities involving recreational boating. A PFD provides flotation to help keep your head above water, help you to stay face up in the water, and increase your chances for survival and rescue. Most adults only need an extra 7 to 12 pounds (31 to 53 Newtons) of flotation to keep their heads above water. The proper size PFD will properly support the weight of the wearer. Since this inflatable PFD does not have inhere
Inhaltszusammenfassung zur Seite Nr. 13
HOW DO YOU TEST YOUR PFD USING THE MANUAL INFLATOR? 1. To test your inflatable PFD, you will need: • Your fully armed PFD, and • Rearming kit approved for your PFD. 2. Put on the PFD. 3. Actuate the inflation system by jerking firmly downward on the pull tab. The PFD should fully inflate within 5 seconds. 4. Get into shallow water, just deep enough that you can stand with your head above the surface. 5. See if the PFD will float you on your back or just slightly back of vertical. In a relaxed
Inhaltszusammenfassung zur Seite Nr. 14
HOW DO YOU TEST YOUR PFD USING THE ORAL INFLATOR? 1. To test your inflatable PFD, you will not need any spare parts or rearming kits. 2. Remove the CO2 cylinder to prevent inadvertent activation of the inflation system, which could potentially damage the PFD. 3. Put on the PFD. 4. Get into shallow water, just deep enough that you can stand with your head above the surface. 5. If you are a weak swimmer or non-swimmer, inflate the PFD partially so that you are supported well enough to be able
Inhaltszusammenfassung zur Seite Nr. 15
VIII. WEAR YOUR PFD In approximately 80 percent of all boating fatalities, the victims were not wearing a PFD. Most fatal accidents happen on calm sunny days. This inflatable PFD is much more comfortable to wear than other PFD types. Get into the habit of wearing this PFD. Non-swimmers and children especially should wear a hybrid or non-inflatable PFD at all times when on or near the water. IX. HYPOTHERMIA Prolonged exposure to cold water causes a condition known as hypothermia - a substantial
Inhaltszusammenfassung zur Seite Nr. 16
Some Points to Remember About Hypothermia Protection: 1. Always wear your PFD. Even if you become incapacitated due to hypothermia, the PFD will keep you afloat and greatly improve your chances of rescue. 2. Do not attempt to swim unless it is to reach a nearby craft, fellow survivor, or a floating object on which you can lean or climb. Swimming increases the rate of body heat loss. In cold water, drown- proofing methods that require putting your head in the water are not recommended. Keep your
Inhaltszusammenfassung zur Seite Nr. 17
X. EACH OF THESE DEVICES IS INTENDED TO HELP YOU SAVE YOUR OWN LIFE For your PFD to function properly follow these suggestions to verify that it fits, floats, and remains in good condition. 1. Check the status of the inflator and make sure that the status indicator is green. Check before each outing. 2. Get in the habit of rearming the inflation mechanism right after each CO2 inflation. 3. This PFD requires rearming with a new cylinder after each CO2 inflation. Always have rearming kits to
Inhaltszusammenfassung zur Seite Nr. 18
DO NOT ATTACH PFD'S TO YOUR BOAT Each PFD has straps, hooks, buckles, or other means for securing the device in place on the wearer. Some PFDs also incorporate decorative dee rings or tabs. Such items are not to be used to attach the device to the boat. Attaching the device to the boat will not permit it to perform as intended. The exception is when a Saftey harness (Model 1193) is worn with a tether of less than 6.5 feet (2 m) having a quick release under load hardware. Refer to Page 3 for ha
Inhaltszusammenfassung zur Seite Nr. 19
REPACKING INSTRUCTIONS Always deflate the PFD and rearm the Inflation Mechanism - follow REARMING Instructions prior to REPACKING! 1. Lay device out flat with the yellow inflatable chamber up. Fold right inside edge over as shown, exposing Velcro® strip. 2. Fold right outside edge over, securing Velcro® strips. Fold left inside edge over, exposing Velcro® strip. 3. Fold left outside edge over, securing Velcro® strips. Fold right topside over, exposing Velcro® strip. Position Jerk to Inflate T
Inhaltszusammenfassung zur Seite Nr. 20
(printer id) 20
