Inhaltszusammenfassung zur Seite Nr. 1
BIPAC-8500/8520
SHDSL VPN Firewall Bridge / Router
User’s Manual
Version Release 1.54c
Inhaltszusammenfassung zur Seite Nr. 2
Table of Contents Table of Contents CHAPTER 1: INTRODUCTION ..........................1 CHAPTER 1: INTRODUCTION ..........................1 INTRODUCTION TO YOUR BIPAC-8500/8520 ROUTER............................................................ 1 FEATURES ........................................................................................................................... 1 BIPAC-8500 / 8520 SHDSL ROUTER APPLICATION ............................................................ 4 CHA
Inhaltszusammenfassung zur Seite Nr. 3
Permanent Table....................................................................................21 PPTP Status................................................................................................................................22 IPSec Status ............................................................................................................................... 23 L2TP Status ............................................................................................
Inhaltszusammenfassung zur Seite Nr. 4
IP Throttling..........................................................................................100 Virtual Server (“Port Forwarding”) ..............................................................................................101 Advanced ...................................................................................................................................104 Static Routing.......................................................................................104
Inhaltszusammenfassung zur Seite Nr. 5
Billion BIPAC-8500 / 8520 SHDSL VPN Firewall Bridge / Router Chapter 1: Introduction Introduction to your BIPAC-8500/8520 Router Welcome to the Billion BIPAC-8500/8520 Router. Your Billion router is an “all-in-one” unit, combining an SHDSL modem, SHDSL router and Ethernet network switch, providing everything you need to get the machines on your network connected to the Internet over your SHDSL broadband connection. With features such as an SHDSL Quick-Start wizard and DHCP Server, yo
Inhaltszusammenfassung zur Seite Nr. 6
Billion BIPAC-8500 / 8520 SHDSL VPN Firewall Bridge / Router Network Address Translation (NAT) Allows multi-users to access outside resources such as the Internet simultaneously with one IP address/one Internet access account. Many application layer gateway (ALG) are supported such as web browser, ICQ, FTP, Telnet, E-mail, News, Net2phone, Ping, NetMeeting, IP phone and others. Firewall Supports SOHO firewall with NAT technology, automatically detects and blocks Denial of Servi
Inhaltszusammenfassung zur Seite Nr. 7
Billion BIPAC-8500 / 8520 SHDSL VPN Firewall Bridge / Router Simple Network Management Protocol (SNMP) It is an easy way to remotely manage the router via SNMP. Web based GUI Supports web based GUI for configuration and management. It is user-friendly and comes with on-line help. It also supports remote management capability for remote users to configure and manage this product. Firmware Upgradeable Device can be upgraded to the latest firmware through the WEB based GUI.
Inhaltszusammenfassung zur Seite Nr. 8
Billion BIPAC-8500 / 8520 SHDSL VPN Firewall Bridge / Router BIPAC-8500 / 8520 SHDSL Router Application 8500 / 8520 Figure 1.1 Application Diagram of 8500 / 8520 Thank you for your purchase, and welcome to the world of broadband Internet! 4 Chapter 1: Introduction
Inhaltszusammenfassung zur Seite Nr. 9
Billion BIPAC-8500 / 8520 SHDSL VPN Firewall Bridge / Router Chapter 2: Installing the Router Important note for using the BIPAC-8500 / 8520 SHDSL Router DO NOT use the BIPAC-8500/8520 in high humidity or high temperatures. DO NOT use the same power source for the BIPAC-8500/8520 as other equipment. DO NOT open or repair the case yourself. If the BIPAC- Warning 8500/8520 is too hot, turn off the power immediately and have it repaired at a qualified service center.
Inhaltszusammenfassung zur Seite Nr. 10
Billion BIPAC-8500 / 8520 SHDSL VPN Firewall Bridge / Router The Front LEDs of BIPAC-8500 1 4 2 3 LED Meaning Lit when successfully connected to SHDSL line and it is 1 LINE synchronized. Lit when connected to an Ethernet device. LAN Port 2 Green for 100Mbps; Orange for 10Mbps. 1X — 4X (RJ-45 connector) Blinking when data is Transmitted / Received. 3 SYS Lit when the system is ready. 4 PWR Lit when power is ON. 6 Chapter 2: Installing the Router
Inhaltszusammenfassung zur Seite Nr. 11
Billion BIPAC-8500 / 8520 SHDSL VPN Firewall Bridge / Router The Front LEDs of BIPAC-8520 1 2 5 3 4 LED Meaning 1 Lit when successfully connected to SHDSL line and it is LINE 1 & 2 synchronized. 2 Lit when connected to an Ethernet device. LAN Port 3 Green for 100Mbps; Orange for 10Mbps. 1X — 4X (RJ-45 connector) Blinking when data is Transmitted / Received. 4 SYS Lit when the system is ready. 5 PWR Lit when power is ON. 7 Chapter 2: Installing the Route
Inhaltszusammenfassung zur Seite Nr. 12
Billion BIPAC-8500 / 8520 SHDSL VPN Firewall Bridge / Router The Rear Ports 4 1 3 2 *6 5 ＊Only the BIPAC-8520 has two Line jack ports. BIPAC-8500 has one. Port Meaning Power Switch 1 Power ON/OFF switch PWR 2 Connect the supplied power adapter to this jack. After the device is powered on, press it to reset the device or restore to factory default settings. 3 RESET 0-3 seconds: reset the device 6 seconds above: restore
Inhaltszusammenfassung zur Seite Nr. 13
Billion BIPAC-8500 / 8520 SHDSL VPN Firewall Bridge / Router Cabling One of the most common causes of problems is bad cabling or SHDSL line(s). Make sure that all connected devices are turned on. On the front of the product is a bank of LEDs. Verify that the LAN Link and SHDSL line LEDs are lit. If they are not, verify that you are using the proper cables. Ensure that all other devices connected to the same telephone line as your Billion router (e.g. telephones, fax machines, analog
Inhaltszusammenfassung zur Seite Nr. 14
Billion BIPAC-8500 / 8520 SHDSL VPN Firewall Bridge / Router Chapter 3: Basic Installation The router can be configured with your web browser. A web browser is included as a standard application in the following operating systems: Linux, Mac OS, Windows 98/NT/2000/XP/Me, etc. The product provides a very easy and user-friendly interface for configuration. PCs must have an Ethernet interface installed properly and be connected to the router either directly or through an external repea
Inhaltszusammenfassung zur Seite Nr. 15
Billion BIPAC-8500 / 8520 SHDSL VPN Firewall Bridge / Router Configuring PCs in Windows For Windows XP 1. Go to Start / Control Panel (in Classic View). In the Control Panel, double-click Network Connections. 2. Double-click Local Area Connection. (See Figure 3.1) Figure 3.1: LAN Area Connection 3. In the LAN Area Connection Status window, click Properties. (See Figure 3.2) 4. Select Internet Protocol (TCP/IP) and click Properties. (See Figure 3.3) 5. Select
Inhaltszusammenfassung zur Seite Nr. 16
Billion BIPAC-8500 / 8520 SHDSL VPN Firewall Bridge / Router For Windows 2000 1. Go to Start / Settings / Control Panel. In the Control Panel, double-click Network and Dial-up Connections. Figure 3.5: LAN Area Connection 2. Double-click Local Area (“LAN”) Connection. (See Figure 3.5) 3. In the LAN Area Connection Status window, click Properties. (See Figure 3.6) 4. Select Internet Protocol (TCP/IP) and click Properties. (See Figure 3.7) 5. Select the Obta
Inhaltszusammenfassung zur Seite Nr. 17
Billion BIPAC-8500 / 8520 SHDSL VPN Firewall Bridge / Router For Windows 98 / ME 1. Go to Start / Settings / Control Panel. In the Control Panel, double-click Network and choose the Configuration tab. 2. Select TCP / IP -> NE2000 Compatible, or the name of any Network Interface Card (NIC) in your PC. (See Figure 3.9) 3. Click Properties. Figure 3.9: TCP / IP 4. Select the IP Address tab. In this page, click the Obtain an IP address automatically radio button. (See F
Inhaltszusammenfassung zur Seite Nr. 18
Billion BIPAC-8500 / 8520 SHDSL VPN Firewall Bridge / Router For Windows NT4.0 1. Go to Start / Settings / Control Panel. In the Control Panel, double-click Network and choose the Protocols tab. 2. Select TCP/IP Protocol and click Properties. (See Figure 3.12) 3. Select the Obtain an IP address from a DHCP server radio button and click OK. (See Figure 3.13) Figure 3.12: TCP / IP Figure 3.13: IP Address 14 Chapter 3: Basic Installation
Inhaltszusammenfassung zur Seite Nr. 19
Billion BIPAC-8500 / 8520 SHDSL VPN Firewall Bridge / Router Factory Default Settings Before configuring your, you need to know the following default settings. Web Interface: Username: admin Password: admin LAN Device IP Settings: IP Address: 192.168.1.254 Subnet Mask: 255.255.255.0 ISP setting in WAN site: PPPoE DHCP server: DHCP server is enabled. Start IP Address: 192.168.1.100 IP pool counts: 100 Username and Password The default username and p
Inhaltszusammenfassung zur Seite Nr. 20
Billion BIPAC-8500 / 8520 SHDSL VPN Firewall Bridge / Router Information from your ISP Before configuring this device, you have to check with your ISP (Internet Service Provider) what kind of service is provided such as PPPoE, PPPoA, RFC1483, or IPoA. Gather the information as illustrated in the following table and keep it for reference. PPPoE VPI/VCI, VC-based/LLC-based multiplexing, Username, Password, Service Name, and Domain Name System (DNS) IP address (it can be automatically
