Inhaltszusammenfassung zur Seite Nr. 1
P-660HWP-Dx
802.11g HomePlug AV ADSL2+ Gateway
Quick Start Guide
Version 3.40
7/2007
Edition 1
Copyright © 2007. All rights reserved.
Inhaltszusammenfassung zur Seite Nr. 2
P-660HWP-Dx Quick Start Guide Overview The P-660HWP-Dx is a gateway which combines high-speed ADSL Internet access, a built-in switch, a firewall, and HomePlug AV and high-speed wireless networking capability. The figure below shows the P-660HWP-Dx connecting devices via a firewalled DSL connection to the Internet through: • standard electrical wiring and HomePlug AV adapters (“A”) • wireless • direct, wired connections using the P-660HWP-Dx’s built-in switch. The P-660HWP-Dx is also a fir
Inhaltszusammenfassung zur Seite Nr. 3
P-660HWP-Dx Quick Start Guide 1 Hardware Connections 1DSL: Use the gray telephone wire to connect your P-660HWP-Dx’s DSL port to a telephone jack (or to the modem port on a splitter if you are using one). 2ETHERNET: Use the yellow Ethernet cable to connect a computer to an ETHERNET port on the P-660HWP-Dx for initial configuration and/or Internet access. 3POWER: Use only the power cable that came in the package to connect your P- 660HWP-Dx to a power outlet. Make sure the power outlet is swi
Inhaltszusammenfassung zur Seite Nr. 4
P-660HWP-Dx Quick Start Guide 1 Open a browser such as Internet Explorer and go to your favorite website. Wait while your P-660HWP-Dx tries to detect your DSL connection to your ISP. This may take a few minutes. 2 After it detects the connection, the DSL light shows green on your device and the Internet light comes on when the Internet is ready for you to use. If you have a PPPoE connection, you will have to enter your user name and password. 3 Go to section 3 if you wish to configure you
Inhaltszusammenfassung zur Seite Nr. 5
P-660HWP-Dx Quick Start Guide 4 Enter your new password to log in again. 5 Click Apply in the screen below to create a new certificate for your P-660HWP-Dx. This screen will continue to appear until you apply this option. 6 Select Go to Wizard setup in the screen below. Click Apply to access the Wizard. 3.2 Connect to the Internet Using the Wizard 1 Click INTERNET/WIRELESS SETUP. The wizard autodetects your Internet connection. • If the Internet connection test is successful, you are ready to
Inhaltszusammenfassung zur Seite Nr. 6
P-660HWP-Dx Quick Start Guide • If you do not see the screen below, or your ISP has given you Internet access set- tings not available on this screen, see Troubleshooting. 3 In the next screen, select either Obtain an IP Address Automatically or Static IP Address. If you select Static IP Address then fill out the required fields based on the information provided by your ISP and click Apply. 4 If the Internet connection test is successful, either browse to your favorite website (such as ww
Inhaltszusammenfassung zur Seite Nr. 7
P-660HWP-Dx Quick Start Guide 1 Select Active and click Next to continue. It is strongly recommended that Enable OTIST is NOT selected. See the Users’ Guide for more information on OTIST. 2 Configure your wireless settings in the screen displayed. Click Next. 3 If you select either WEP or WPA-PSK security (recommended), then follow the directions to enter the appropriate key. Click Next to continue and Apply to save your wireless LAN settings. 4 Check your configuration in the screen below
Inhaltszusammenfassung zur Seite Nr. 8
P-660HWP-Dx Quick Start Guide 5 Click Finish to complete and save the wizard setup. Your Internet connection is ready for you to use. Open a browser such as Internet Explorer and navigate to a website. 4 Setting Up a Wireless Network To set up a wireless network you need at least one wireless network card/adapter. • If you have a desktop computer, use either a wireless USB adapter or a wireless PCI adapter. • If you have a laptop, use either a wireless USB adapter or a wireless CardBus card.
Inhaltszusammenfassung zur Seite Nr. 9
P-660HWP-Dx Quick Start Guide • Type the Network Password for your network. This will connect you to other Home- Plug AV devices which have the same password and allow you to configure them. HomePlugAV is the default password for ZyXEL HomePlug AV devices. • You do not need to type the Device Access Key (DAK) for the P-660HWP-Dx unless you want to change it. • Click Apply. 4 Go to Network > Powerline > Remote Setting to make a new network with a new Network Password and add the other HomeP
Inhaltszusammenfassung zur Seite Nr. 10
P-660HWP-Dx Quick Start Guide Troubleshooting If you cannot access the web configurator check the following. 1 Your computer may be set to use a static IP address in a different subnet from the ZyXEL device. See the User’s Guide for information on setting up your IP address. 2 If you are using Internet Explorer in Windows XP or Windows Server 2003, make sure you allow pop-up windows, JavaScript and Java permissions or set the Internet security level lower than High in Internet Explorer (in
Inhaltszusammenfassung zur Seite Nr. 11
P-660HWP-Dx Quick Start Guide section and enter it in the IP Address field. If not, select Obtain an IP Address Automatically. Click Apply and run the Internet/Wireless Setup wizard again r If you have a DSL connection and have entered your ISP settings, but you cannot access the Internet, follow these steps. 1 Check you have correctly entered the information your ISP gave you. 2 If you are using Bridge mode (check Mode in the Network > WAN > Internet Connection screen) click NAT > General
Inhaltszusammenfassung zur Seite Nr. 12
P-660HWP-Dx Quick Start Guide If you cannot access your HomePlug AV network, try the following: 1 Make sure that the network password is the same on all of your HomePlug AV adapters and that the DAKs for your HomePlug AV devices are typed correctly. 2 Make sure that all the power line adapters you are using are HomePlug AV compliant. The P-660HWP-Dx does NOT recognize earlier versions of HomePlug adapters such as HomePlug 1.0 or 1.0.1. 3 Plug a second HomePlug AV adapter into an adjacent o
Inhaltszusammenfassung zur Seite Nr. 13
P-660HWP-Dx Quick Start Guide 12
