Bedienungsanleitung Korg TPB-2

Inhaltszusammenfassung zur Seite Nr. 1

KORG INC. 4015-2 Yanokuchi, Inagi-city, Tokyo 206-0812 Japan
2004 KORG INC. 1506 EH Printed in Japan
©
CE mark for European Harmonized Standards
CE mark which is attached to our company’s products of AC mains operated
Warning
apparatus until December 31, 1996 means it conforms to EMC Directive (89/
336/EEC) and CE mark Directive (93/68/EEC).
When installing, servicing, or replacing parts for this product, do not perform any
And, CE mark which is attached after January 1, 1997 means it conf

Inhaltszusammenfassung zur Seite Nr. 2

5. Insert the TPB-2's flat cable into the connector. Introduction Make sure that the connector is oriented correctly, and press it firmly Thank you for purchasing the Korg TPB-2 Dual Tube Preamp Board w/ in until the connector lock engages. Optical Compression. In order to enjoy long and trouble-free use, please read this owner’s manual carefully and use your TPB-2 only as directed. Features The TPB-2 is a dual-channel preamp featuring two 12AX7 vacuum tubes, plus fast operating and transparent

Inhaltszusammenfassung zur Seite Nr. 3

8. Level meter 1. Parts and their function The meter shows the audio level. If the needle moves into the red area above 0 dB, this indicates that digital clipping is occurring. Set the gain trim knob and the compressor sensitivity knob to prevent the needle from exceeding 0 dB. 1 9. Gain reduction LED This LED will light when gain reduction is being applied by the compressor. 2 10. Compressor sensitivity knob This specifies the audio level where the compressor begins to kick in. 3 Turning the kn

Inhaltszusammenfassung zur Seite Nr. 4

2-4. Using the link switch 4. Specifications Turn on the link switch if you want to use stereo compression. Input connectors: XLR-3-31 type (+48 V phantom power, switchable), When you’re recording a stereo source, and the level of one channel rises 1/4” TRS phone jack (balanced / unbalanced is Hi-Z) to the point where compression is being applied to only that one channel, then the relative volume of the other channel will increase, Input impedance: 4 k (XLR-3-31), 10 k (TRS phone Jacks), produci