Inhaltszusammenfassung zur Seite Nr. 1
TABLE OF CONTENTS
INTRODUCTION 3
PRODUCT OVERVIEW 4
BEFORE YOU BEGIN 8
BATTERY INSTALLATION 9
LOW BATTERY WARNING 10
GETTING STARTED 10
PLACEMENT OF THE UNITS 10
REMOTE AND INDOOR TEMPERATURE 11
MAXIMUM AND MINIMUM READINGS 11
LOST COMMUNICATION 12
TRANSMISSION COLLISION 13
WWVB RADIO CONTROLLED TIME 13
ATOMIC CLOCK 14
TIME AND CALENDAR DISPLAY MODES 14
Honeywell
MANUAL SETTINGS 15
Personal Weather Station
CLOCK ALARMS 15
SNOOZE 17
BACKLIGHT 17
P
Inhaltszusammenfassung zur Seite Nr. 2
INTRODUCTION PRODUCT OVERVIEW Thank you for selecting the Honeywell Wireless Personal Weather Station. This MAIN UNIT device combines precise time keeping with monitoring and displaying the FEATURES weather conditions from up to three remote locations. · New Double-Tool Design In this package you will find: · Time automatically sets to the US Atomic Clock · One main unit (receiver) · 12 or 24 hours Time Format · One remote sensor (transmitter) TS15C · Dual crescendo Time Alarm with Snooz
Inhaltszusammenfassung zur Seite Nr. 3
FRONT/REAR VIEW · Activates clock s manual programming mode F. DOWN ( ) button B C · Decreases the parameters A · Activates manual remote channels search I · Disables time alarms (W) and (S) and Ice Warning Alarm G. ALARM button · Allows toggling between the calendar display and three time alarm modes · Allows programming available alarms D H. MEM button E J · Toggles between current, minimum, maximum readings of the indoor H F and remote temperature K · Clears the
Inhaltszusammenfassung zur Seite Nr. 4
REMOTE SENSOR · Keeps the remote sensor on the wall FEATURES F. °C/ °F SWITCH · New double-tool design · Selects the temperature display in Celsius or Fahrenheit · Remote temperature transmission to the main unit via 433 MHz frequency BEFORE YOU BEGIN · Case can be wall mounted using built-in hanger · We recommend using alkaline batteries for the remote sensor and · Selection of the temperature display in Celsius or Fahrenheit main unit when temperatures are above 32°F (0°C). We recomme
Inhaltszusammenfassung zur Seite Nr. 5
MAIN UNIT 2. The effective operating range may be influenced by the surrounding building materials and how the receiver and transmitter are positioned. · Remove the battery compartment door. 3. Place the remote sensor so that it faces the main unit (receiver), minimizing · Install 2 batteries (UM-3 or AA size 1.5V) matching the polarity as obstructions such as doors, walls, and furniture. shown in the battery compartment. 4. Though the remote sensors are weather-resistant, they should be
Inhaltszusammenfassung zur Seite Nr. 6
REMOTE AND INDOOR TEMPERATURE LOST COMMUNICATION The remote temperature information line is located on the top line of the main If the main unit display line for the remote sensor reading goes blank, press unit s display. and hold DOWN ( ) button for 2 seconds to begin a new signal search. If the The wave icon is located above the remote channel number indicates the signal still isn t received, please make sure that: reception status from the corresponding remote sensor. · The remo
Inhaltszusammenfassung zur Seite Nr. 7
TRANSMISSION COLLISION ATOMIC CLOCK Signals from the other household devices such as wireless doorbells, home Immediately after establishing communication between the main unit and security systems, and entry control, may interfere with this product or cause remote sensor, the atomic time signal receiver will open and start to search for temporary reception interruption. This is normal and will not affect the general the atomic time signal. The search usually takes between 5-8 minutes. p
Inhaltszusammenfassung zur Seite Nr. 8
MANUAL SETTINGS subsequent days It is necessary to set the desired US TIME ZONE. · If Ice Warning Alarm ( PRE-AL) is activated, in will sound at the set TIME ZONE time and alarm icon will flash once the remote temperature for Channel · Press MODE button once so that the Day of the Week abbreviation is One (1) will reach 32°F(0°C) and below displayed to the right of the time; for example: pm 2:37tu NOTE: Ice Warning Alarm can be set only if one or both - Weekday or · Select the Time Zone by
Inhaltszusammenfassung zur Seite Nr. 9
than the Weekday or Single alarm. PRECAUTIONS · Select the desired Ice Warning Alarm interval in 15 minutes increments This product is engineered to give you years of satisfactory service if handled between 15 and 90 minutes, using UP ( ) or DOWN ( )buttons carefully. Here are a few precautions: · Press ALARM button to confirm and exit from the alarm setting mode. · Do not immerse the units in water. · Do not clean the units with abrasive or corrosive materials. They may ACTIVATING THE A
Inhaltszusammenfassung zur Seite Nr. 10
TROUBLESHOOTING SPECIFICATIONS Check here before contacting customer service. Main Unit Indoor Temperature Proposed operating range: 23.0°F to 122.0°F (-5°C to +50°C) Issue Symptom Solution Temperature resolution: 0.2°F (0.1°C) Main unit US Atomic Time Place unit by the window and User-selectable (°F or °C) temperature display Maximum number of remote sensors: 3 (one included) signal is not received keep it there overnight Readings update interval: every 45 seconds Remote sensor
Inhaltszusammenfassung zur Seite Nr. 11
FCC STATEMENT DECLARATION OF CONFORMITY This device complies with Part 15 of the FCC Rules. Operation is subject to the We following two conditions: (1) This device may not cause harmful interference, Name: Hideki Electronics, Inc. and (2) This device must accept any interference received, including Address: 7865 SW Mohawk interference that may cause undesired operation. Tualatin, OR 97062 Warning: Changes or modification to this unit not expressly approved by the declare that the
Inhaltszusammenfassung zur Seite Nr. 12
STANDARD WARRANTY INFORMATION This product is warranted from manufacturing defects for one year from date of retail purchase. It does not cover damages or wear resulting from accident, misuse, abuse, commercial use, or unauthorized adjustment and repair. Note that online product registration is required to ensure valid warranty protection. To register your product, go to our Company website at: www.honeywellweatherstations.com. Click Online Product Registration under the Customer Service
