Bedienungsanleitung Anchor Audio AN-130

Inhaltszusammenfassung zur Seite Nr. 1

HAVING TROUBLE W/ YOUR SOUND SYSTEM?
CONDITION POSSIBLE CAUSE
No Sound (Power LED Not Lit) • turn POWER switch on
• plug in power cord
No Sound (Power LED Lights) • check for output from source
• make sure all cables are completely plugged in
• increase volume control
• press mute button on remote (AN-130RC only)
• turn power switch to off then back to on (AN-130RC only)
Distorted Sound • check input cable connection
• lower input signal level
Excessive Hum or Noise • use shielded input ca

Inhaltszusammenfassung zur Seite Nr. 2

A MESSAGE FROM THE OWNER OPERATING THE WIRELESS MICROPHONE / TRANSMITTER Thank you for choosing an Anchor Audio portable sound system. Our products incorporate state-of-the-art design and CHANNEL SELECTION - HANDHELD TRANSMITTER CHANNEL SELECTION - BODY-PACK TRANSMITTER the finest quality of materials and workmanship. We’re proud of our products and appreciate the confidence which you 1. Unscrew battery cover on bottom of microphone 1. The channel selection dial is located on the side have sh

Inhaltszusammenfassung zur Seite Nr. 3

DIVERSITY WIRELESS BY ANCHOR AUDIO FEEDBACK Anchor Audio UHF wireless is a 16 channel, diversity wireless system that utilizes two independent antennae to Feedback is a howling noise or shrill sound that is self-generated by the sound system. It is caused by a micro- receive signals. The diversity feature means the receiver will process the stronger of the two antenna signals, ef- phone picking up the sound coming from the speaker and then being re-amplified. Once a feedback loop is started fec

Inhaltszusammenfassung zur Seite Nr. 4

BASIC SYSTEM OPERATION LINE IN The AN-130 monitor is used to amplify the signal from a The line-level RCA input jacks may be used with audio sources such as computers, VCR’s, and POWER SWITCH microphone, electronic musical instrument or line-level sources cassette tape or compact disc players. The inputs may be used for two separate sources, or (cassette, CD, VCR, etc). they may be used to sum L+R stereo outputs to a mono signal without the need for adapters. You’ll need a connection cable