Inhaltszusammenfassung zur Seite Nr. 1
Inhaltszusammenfassung zur Seite Nr. 2
Important Information About Your EMP-7100/5100 Please read the following important information about your EMP- 7100/5100 projector. Important Safety Information Warning: Never look into the projector lens when the lamp is switched on as the bright light can damage your eyes. Never let children look into the lens when it is on. Warning: Never open any covers on the projector except the lamp and filter covers. Dangerous electrical voltages inside the projector can cause severe injury. Except as sp
Inhaltszusammenfassung zur Seite Nr. 3
EMP-7100/5100 QUICK START projection lamp indicator operation panel operation indicator remote control receiver zoom ring focus ring speaker (Figure is EMP-7100) front foot foot releace bottan Operation Panel Button/controller Function Power Turns power on and off. Menu Displays or closes the menu. Video Switches from computer to video. Computer Switches between Computer 1 and Computer 2, and from video to computer. Auto Automatically adjusts the graphic signal being sent from a computer to opti
Inhaltszusammenfassung zur Seite Nr. 4
EMP-7100/5100 QUICK START Remote Control Button/controller Function Menu Displays or closes the menu. Auto Automatically adjusts the graphic signal being sent from a computer to optimize it for projection. Video Switches from computer to video. Computer Switches between Computer 1 and Computer 2, and from video to computer. Effects 1 ~ 5 Function buttons for add-on functions which can be assigned using the ELP Link II software that comes with the projector. Pointer Moves the computer’s pointer w
Inhaltszusammenfassung zur Seite Nr. 5
(Figure is EMP-7100) DATA/VIDEO PROJECTOR Owner’s Manual
Inhaltszusammenfassung zur Seite Nr. 6
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photo copied, recorded, or otherwise, without the prior written permission of Seiko Epson Corporation. No patent liability is assumed with respect to the use of the information contained herein. Neither is any liability assumed for damages resulting from the use of the information contained herein. Neither Seiko Epson Corporation no
Inhaltszusammenfassung zur Seite Nr. 7
Contents Introduction vii Getting the Most Out of Your Projector viii Optional Accessories ix Safety Instructions x Where to Get Help xii World Wide Web site xii Transporting your projector xiii Remote control information xiv 1 Installation 1 Unpacking the Projector 2 Additional Items 3 Setting Up the Projector 5 Connecting to a Computer 7 Connecting to a PC desktop computer 8 Connecting to a PC laptop computer 9 Connecting to a Macintosh desktop computer 11 Connecting to a Macintosh Power
Inhaltszusammenfassung zur Seite Nr. 8
2 Using the Projector 19 Turning the Equipment On and Off 20 Adjusting the Screen Image 21 Screen Image Position 22 AUTO Button 23 Resize Button 23 Controlling the Projector 24 Checking the Status of the Projector 29 Operation Indicator 29 Projection Lamp Indicator 30 3 Using the Menus 31 Accessing the Menus 32 Changing Menu Settings 33 Video Menu (Computer) 35 Video Menu (Video) 37 Audio Menu 38 Option Menu 39 Using Custom Functions 42 4 Using ELP Link II 47 Introduction 48 How to connect 49
Inhaltszusammenfassung zur Seite Nr. 9
Details of Each Function 61 Setting and operating the function [key] 65 Operating the projector control function 65 Projector Control 65 Test Pattern Setting 68 User Logo Setting 68 Initial Screen for the User Logo Setting 68 Logo Data 69 User Logo Edit Screen 69 Color Property Setting 70 5 Maintenance 71 Cleaning the Lens 72 Cleaning the Projector Case 72 Cleaning the Air Filter 72 Replacing the Lamp 74 6 Troubleshooting 79 Problems with the Projector 80 Problems with the Image or Sound 83 A
Inhaltszusammenfassung zur Seite Nr. 10
vi Contents
Inhaltszusammenfassung zur Seite Nr. 11
Introduction The compact, lightweight EPSON EMP-7100/5100 Projector allows you to project XGA (EMP-7100), SVGA (EMP-5100) full-color images and video onto a large screen for presentations. The projector can connect simultaneously ® ® to three image sources: two PC or Apple Macintosh computer image sources plus on video source such as a video tape deck, camcorder, or digital camera. Audio can also be connected for each image source. Images are displayed in XGA (EMP-7100) and SVGA (EMP-5100) compa
Inhaltszusammenfassung zur Seite Nr. 12
Getting the Most Out of Your Projector The projector comes with a full set of features that allow you to control the settings for the image display, video and audio. To get the most out of your projector read this section for a quick summary of the important features. Remote control The buttons on the remote control allow you to turn the projector on and off, an provide direct access to auto set-up, blank, freeze, volume, mute and image source switching. Remote control buttons can also be used f
Inhaltszusammenfassung zur Seite Nr. 13
Optional Accessories To enhance your use of the projector, EPSON provides the following accessories: • Carrying cases designed especially for the projector and its cables. Both a soft and a hard case are available. • An ELP Link II cable set, a computer cable and a MAC adapter set etc. to connect to another computer. • A remote control receiver which may be used when the projector cannot be controlled directly with the remote control. • Replacement lamps. You can purchase these accessories from
Inhaltszusammenfassung zur Seite Nr. 14
Safety Instructions These graphics are used throughout the manual to draw your attention to important information about the EMP-7100/5100. u Note: Additional useful details or tips. u Caution: Steps to avoid damage to your equipment. u Warning: Steps to avoid personal injury. Always follow these safety instructions when setting up and using the projector: 1. Do not place the projector on an unstable trolley, stand or table. 2. Do not use the projector near water or sources of heat. 3. Use attach
Inhaltszusammenfassung zur Seite Nr. 15
8. Do not place the projector where the cord can be stepped on as this may result in fraying or damage to the lead or the plug. 9. Unplug the projector from the wall socket before cleaning. Use a damp cloth for cleaning. Do not use liquid or aerosol cleaners. 10. Do not block the slots and openings in the projector case. They provide ventilation and prevent the projector from overheating. Do not place the projector on a sofa, rug or other soft surface or in a built-in installation unless proper
Inhaltszusammenfassung zur Seite Nr. 16
Where to Get Help SEIKO EPSON CORPORATION provides local customer support and service through a nationwide network of authorized EPSON dealers and Service Centres. For inquiries please contact the appropriate representative listed in the section entitled “After sales service contact addresses” at the end of this manual. When you call for technical assistance, be ready to identify your system and its configuration. If you need help with any software program you are using, please refer to the docu
Inhaltszusammenfassung zur Seite Nr. 17
Transporting your projector The projector contains many glass parts and precision parts. To prevent shock damages while transporting, handle as the followings. l when transport to a maker due to troubleshooting • Use the original packing. • If you don't have the original packaging, use the equivalent, put cushioning around the projector. l when frequently transport for business use • First, put the projector in a hard carrying case(ELPKS06), then pack it in a firm box, using cushioning. • EPSON
Inhaltszusammenfassung zur Seite Nr. 18
Remote control information The EMP-7100/5100 can be operated by remote control via infrared (IR) receivers located at the front of the projector. The projector may not respond to remote control commands under the following conditions: • The ambient light is too bright. • Certain types of fluorescent lighting are used. • A strong light source shines into the IR receiver. • Other equipment that emits infrared energy, such as a radiant room heater, is in the room. These conditions commonly cause pr
Inhaltszusammenfassung zur Seite Nr. 19
1 Installation This chapter tells you how to unpack and set up your projector and connect it to other equipment. The projector must be connected to a computer or a video source such as a video tape deck, camcorder, digital camera or laser disk player. 1
Inhaltszusammenfassung zur Seite Nr. 20
Unpacking the Projector Make sure all of the following components are present when you unpack the projector. • Projector • Lens cover • Remote control • 2 AA batteries • Power cord • Computer cable • Audio cable • Video/audio cable • MAC adapter set MAC Desktop adapter MAC Monitor adapter • ELP Link II Kit Main cable PS/2 mouse cable Serial mouse cable MAC mouse cable PC serial cable MAC serial cable ELP Link II for Windows ELP Link II for Macintosh 2 1 • Installation
