Bedienungsanleitung Dish Network MP1

Inhaltszusammenfassung zur Seite Nr. 1

®
DISH Receiver Setup for MP1 Antenna

™
DISH receivers will often not show when they are on signal if they have incorrect “Check Switch”
information. For this reason, DISH users must clear current settings before pointing. To do this for most
®
DISH receivers, follow these steps. The following instructions are based on a ViP 211 receiver.
If your receiver differs from the options shown, you may need to consult your receiver manual. The
wording and display used in your receiver may differ s

Inhaltszusammenfassung zur Seite Nr. 2

Input zip code of current location and dish type. Zip Code should be the zip code of 8 your current location. Note that whenever you move the satellite antenna to a new location, you must enter the zip code of your new current location. On the display, Dish System should always be Dish 300. The satellite should be whatever satellite you want to point at. Satellite 119 is the primary satellite, and the majority of programming is located here. Use Transponder 11 for Satellite 119. *If using a