Inhaltszusammenfassung zur Seite Nr. 1
Bruksanvisning
Owner’s Manual
MEDIAMASTER
9820 T
S 1
Inhaltszusammenfassung zur Seite Nr. 2
MEDIAMASTER 9820 T Contents GENERAL OPERATION OF THE List of TV or Radio Channels 17 Options (Green Button) 17 MEDIAMASTER 4 FOR YOUR SAFETY 4 TV Release (0) 18 Video Recording 18 REMOTE CONTROL 5 Rear Panel 6 The TEXT Button (Teletext) 18 Main Menu 19 Front Panel 6 ABOUT THE SMARTCARD 7 General Information 19 Channels 19 Subscription TV Services with a Smartcard (Viaccess) 7 Edit Channels 19 Guide 23 INSTALLATION OF THE MEDIAMASTER 8 Preparing the Remote Control 8 System Configuration 23 Chann
Inhaltszusammenfassung zur Seite Nr. 3
GENERAL OPERATION OF THE MEDIAMASTER Throughout this manual you will notice that the everyday opera- tion of your Mediamaster is based on a series of user friendly on- screen displays and menus. These menus will help you get the most from your Mediamaster, guiding you through installation, channel selection, viewing and many other functions. All functions can be carried out using the buttons on the remote control, and some of the functions can also be carried out using the buttons on the front p
Inhaltszusammenfassung zur Seite Nr. 4
REMOTE CONTROL This section describes how to operate the Mediamaster using the buttons on the remote control. Some of the functions can also be carried out using the buttons on the front panel. To switch the Mediamaster in and out of standby mode. EXIT TV To return to the viewing mode from a menu without stor- ing settings (in menu mode). To turn the sound off/on (mute). - + To adjust the volume of digital programmes. The Mediamaster’s maximum level is controlled by the TV’s present volume se
Inhaltszusammenfassung zur Seite Nr. 5
Rear Panel Mains lead DIGITAL AUDIO AUX SCART TELEPHONE TV/VCR 230 V AC phono connector for connection to a for modem for an RF- ± 15% S/PDIF output for VCR, or an analogue connection to cable to the 50-60 Hz connection to satellite receiver the telephone aerial input a HiFi system wall socket of the TV or VCR 230 V TELEPHONE ±15% DIGITAL AUDIO 50 Hz TV / VCR AUX L TV SERIAL TV AERIAL WARNING! AUDIO DO NOT OPEN – ELECTRICAL R SHOCK HAZARD 44 10285 AUDIO L R TV SCART SERIAL PORT TV AERIAL for a
Inhaltszusammenfassung zur Seite Nr. 6
ABOUT THE SMARTCARD AND CA MODULE To be able to receive terrestrial scrambled digital channels you will need a Smartcard from the Service Provider, ”Senda”. Senda is the the programme distributor. Please note that a Smartcard may only be valid for a single Serv- ice Provider and due to this, a specific range of channels. The Smartcard and the CA module may also provide access to special menus not described in this manual. If so, please follow the instructions from the Service Provider. Note: The
Inhaltszusammenfassung zur Seite Nr. 7
INSTALLATION OF THE MEDIAMASTER The box for your Mediamaster should contain the following items: • the Mediamaster • a remote control with 2 AAA batteries • a SCART lead (fully featured 1,0 metre) Telephone • an aerial/RF lead (double screened 1,5 metres) SCART lead RF lead modem cable • a telephone modem cable (10 metres with a splitter) • an Owner’s Manual • a Software License agreement License Owner’s manual agrement About the SCART sockets • The rear panel of the Mediamaster is equipped wit
Inhaltszusammenfassung zur Seite Nr. 8
• Certain outdoor antennas are pointed at an analogue slave transmitter. The roof antenna should be pointed at a digital TV transmitter. • It is not always advisable to position the antenna as high as possible. If problems arise, experiment with different antenna heights. The same applies to analogue transmissions. 2. Indoor or window-mounted antenna This type of antenna may be enough if the reception conditions are very good. If an indoor antenna is used, please note the fol- lowing: • Use an a
Inhaltszusammenfassung zur Seite Nr. 9
Connecting the Mediamaster There are many different types of TV/VCR and other equipment that you can connect to the Mediamaster. In this manual you will see some of the most common ways to connect your equipment. If you use RF leads you will have to tune your TV and VCR to the Mediamaster output channel (see page 12). If you have problems with your connections and need help, con- tact your dealer or Service Provider. Connecting the Mediamaster to the TV TV • Connect a SCART lead between the main
Inhaltszusammenfassung zur Seite Nr. 10
Connecting an Analogue Satellite Receiver and VCR • Connect a SCART lead between the main SCART socket on the TV and the TV SCART socket on the Mediamaster. • Connect a SCART lead between the TV SCART socket on the satellite receiver and the AUX SCART socket on the Mediamaster. Aerial • Connect a SCART lead between the VCR and the 2:nd SCART socket on the 2 1 TV (if available). Dish RF • Connect an RF lead from the RF output on the VCR to the TV aerial input on the TV. SCART • Connect an RF lead
Inhaltszusammenfassung zur Seite Nr. 11
Tuning Procedure when RF Connections are Used This procedure is necessary only if your Mediamaster is con- nected to the TV with an RF lead and no SCART leads are used To tune your TV to the RF signal you might also need your TV manual in addition to this manual. The steps below explain what to do if you have been unable to use SCART leads in your con- nection. • Plug in your Mediamaster. Tuning your TV to the Mediamaster • Select a channel number on the TV that is not currently used for other T
Inhaltszusammenfassung zur Seite Nr. 12
FIRST TIME INSTALLATION General Information Once you have correctly connected the Mediamaster, you also have to perform a “First Time Installation.” During this procedure, helpful information is displayed at the bot- tom of the menus. Please note! The OK button always confirms a selection within these menus, and pressing it will take you to the next step in the installation process. However, and this is important, often more than one value has to be entered in a menu. First, perform all necessar
Inhaltszusammenfassung zur Seite Nr. 13
FIRST TIME INSTALLATION Channel Search The Channel Search procedure can be performed in two differ- ent ways. • “Automatic Search” or “Manual Search.” Automatic Search • Start the Automatic Search on the digital terrestrial network by pressing OK. Manual Search When you perform a Manual Search you first need to enter some parameters for the channel search to work. The information you need to enter in this menu is available from your Service Provider. Select channel: Specify the UHF channelnumber
Inhaltszusammenfassung zur Seite Nr. 14
VIEWING MODE General Information The following describes the basic functions of your Mediamaster while watching terrestrial digital TV . Some of the functions described here are dependent on the Service Provider and can only be used if they are included in the transmitted programme information. Please note, that during the Channel Search procedure, the Mediamaster may download a large number of channels. This may include channels also those to which you do not have access unless you have a Smart
Inhaltszusammenfassung zur Seite Nr. 15
VIEWING MODE The “i” (Information) Button The Mediamaster has the ability to display information about pro- grammes currently being broadcast as well as those being broad- cast next. By pressing the “i” button while watching TV you will get a spe- cial Programme Information Banner. Select channel with or the numeric buttons. The “i” symbol is coloured blue when displaying information about the current channel, and red when information for another channel is shown. • Press “i” again to get more
Inhaltszusammenfassung zur Seite Nr. 16
VIEWING MODE List of TV Channels At the channel search procedure, a Channel lists named “Chan- Name of the Indicates a Channel list closed network nels” containing all channels are created. In the “Channels” list scrambled channels are marked with a pic- ture of a Smartcard (if this information is transmitted in the sig- nal) and locked channels are marked with a padlock. If you have performed a new channel search the new channels found will be marked with a star in the “Channels” list. When vie
Inhaltszusammenfassung zur Seite Nr. 17
VIEWING MODE Format If you have a TV set with a 4:3 picture format, and the transmis- sion is in 16:9, you can select Fullscreen or Letterbox to change display format. Fullscreen will fill up the screen vertically, but cut off some infor- mation from the left and right sides of the picture. Letterbox will give a complete picture, but leave black areas at the top and bottom. TV Release (0) With the 0 button you can toggle between: digital terrestrial TV analogue terrestrial TV video (the video mu
Inhaltszusammenfassung zur Seite Nr. 18
MAIN MENU General Information Many of the functions of the Mediamaster are available from the Main Menu. • Press MENU to open it. Channels Please refer to “List of TV channels” on page 17. Edit Channels From these menus you can create and edit channel lists. You can, among other things, create favourite lists; add, delete, rename and arrange the order of the channels within the lists. In the “All TV” list the channels are presented network by net- work. First the name ”Marknätet”(terrestrial net
Inhaltszusammenfassung zur Seite Nr. 19
MAIN MENU Create list From here you can create your own favourite lists, containing the channels you watch most frequently. You can give each list a spe- cific name, e.g. “Sport” or “Films.” When a favourite list is selected, you see only those channels defined in the list. When you have given the list a name; press OK and you will en- ter the “Select Channels” menu (see next page) from where you add channels to the list. How to give a specific name This procedure is the same whether you enter a
Inhaltszusammenfassung zur Seite Nr. 20
MAIN MENU Select Channels From this menu you add and remove the channels in your Favour- ite Lists. You use the “All TV” list as basis to select the channels from. A channel is added or removed by pressing the OK button. The square to the right on a line will be empty for removed channels, and will contain an “x” for added channels. • If you have a Favourite list that contains several satellites and networks, you can close the one(s) you are not going to work with. You open/close a satellite o
