Inhaltszusammenfassung zur Seite Nr. 1
Inhaltszusammenfassung zur Seite Nr. 2
FCC Note: CAUTION This device complies with Part 15 of the FCC Rules. To RISK OF ELECTRIC SHOCK assure continued compliance follow the attached DO NOT OPEN installation instructions and do not make any CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, unauthorized modifications. DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. This equipment has been tested and found to comply with REFER TO SERVICING TO QUALIFIED SERVICE PERSONNEL. the limits for a class A digital device, pursuant t
Inhaltszusammenfassung zur Seite Nr. 3
CONTENTS PREFACE ................................................................................................................................................................................ 4 FEATURES .............................................................................................................................................................................. 5 SPECIAL NOTES ON OPERATION ...........................................................................................
Inhaltszusammenfassung zur Seite Nr. 4
PREFACE • The Panasonic AW-E750, AW-E655, AW-E650 and • Option cards may also be installed. AW-E350 are digital signal processing color video cameras that incorporates three CCDs; ❈ The following cards are not available for AW-E750, AW-E655, AW-E650, AW-E350; 2/3" 3CCD (AW-E750) · AW-PB301 Component Studio Card 1/2" 3CCD (AW-E655, AW-E650) · AW-PB302 RGB Card: The camera unit 1/3" 3CCD (AW-E350) contains this function. A digital video signal processing system is packed in · AW-PB303 High-sensit
Inhaltszusammenfassung zur Seite Nr. 5
FEATURES 1. Digital video signal processing for high quality, high 8.CCD readout is switchable between field and frame reliability, high performance, lightweight and modes. Vertical resolution can be stepped up in compact size. frame mode and it is effective for shooting still objects. 2. Resolution: 850 lines (HIGH BAND DTL: ON) S/N ratio: 9. The built-in synchronized scanning system reduces 67dB (DNR ON) (AW-E750, AW-E655, AW-E650) noise in computer graphics. 66dB (DNR ON) (AW-E350) 10. Variou
Inhaltszusammenfassung zur Seite Nr. 6
SPECIAL NOTES ON OPERATION • Turn power off before connecting or disconnecting • There is a cooling fan inside. cables. Do not cover the port or otherwise block ventilation • Connection or disconnection of any studio cable, during operation. Internal heat buildup can cause a RCB cable or other cable to any unit of equipment fire. must be performed while power is off. It is an expendable part, and must be replaced • While the camera is in automatic mode; about every 30 000 hours. (Whenever fan re
Inhaltszusammenfassung zur Seite Nr. 7
PRECAUTIONS DON'TS • Do not attempt to disassemble the camera, Remote • Do not expose the camera or Remote Control Unit Control Unit (RCU) or other units. In order to pre- (RCU) to rain or moisture, and do not try to operate vent electric shock, do not remove screws or cov- the equipment in wet conditions. Do not operate the ers. There are no user-serviceable parts inside. camera or RCU if it becomes wet. • Do not abuse the camera. Avoid striking, shaking, • Do not operate the camera or Remote C
Inhaltszusammenfassung zur Seite Nr. 8
DOS • Refer any servicing to qualified service personnel. • Take immediate action if ever the camera or RCU should become wet. Turn the power off and have • Handle the camera with care. the unit checked by an authorized service facility. • Protect the precision made lens by placing the lens cap over when the camera is not in use. If the lens • Follow normal safety precautions to avoid personal is not installed, protect the surface of the prism by injury. placing the body cap into the lens mount
Inhaltszusammenfassung zur Seite Nr. 9
Inhaltszusammenfassung zur Seite Nr. 10
2. Lens fixing ring knob Rotate the lens fixing ring knob counterclockwise 7 = and remove the lens mount cap. Mount the lens on the camera and rotate the lens fixing ring knob clockwise in order to fix the lens securely. 8 3. Mic Jack (model AW-E655 only) 9 This is a ø3.5 mm mic jack which supports PLUG IN ; POWER. Use the microphone which has more than : 1kΩ of impedance, unbalanced. 4. Mounting hole < To install the camera on a wall or ceiling or to use a pan/tilt head or tripod, secure t
Inhaltszusammenfassung zur Seite Nr. 11
7. MENU Switch (MENU/A) 11. Video Output Connector (VIDEO OUT) A composite video signal is provided at this con- A menu will appear on the monitor screen when this switch is pressed for about 5 seconds. This item nector. can be selected by pressing the switch while the menu is on the screen. 12. Iris Connector (IRIS) Input terminal for lens with an iris control function. 8. ITEM/AWC Switch (ITEM/AWC/S) The item just below can be selected by pressing Pin No. Signal Pin No. Signal 9 1 this switch
Inhaltszusammenfassung zur Seite Nr. 12
15. Power Indicator Pin No. Signal Pin No. Signal 9 1 Focus Mode 8 10 2 Red LED lamp lights to indicate that the specified Signal Control 1 Position/Speed 7 7 12 11 3 DC power is supplied to the camera. (+5.0 V) 6 4 /Auto Focus 5 Zoom Mode 2 16. DC 12 V Input Connector (DC 12V IN) 8 Focus Control Position/Speed 12 V DC is supplied through the optional DC power 3 GND 9 Zoom Control supply cable (AW-CA4T1). Iris Iris Mode 4 10 Remote/Camera Position/Speed (Recommended AC adaptor: AW-PS505) 5 Iris
Inhaltszusammenfassung zur Seite Nr. 13
Inhaltszusammenfassung zur Seite Nr. 14
2. Camera Mounting 1. AW-E750 or AW-E655 models: Use the screws provided to attach the accessory mounting adaptor to the bottom panel of the camera. AW-E650 or AW-E350 models: Use the screws provided to attach the accessory mounting adaptor to the top or bottom panel of the Camera Mounting Bracket (WV-831) camera. Use a screwdriver or similar to tighten the screws to secure the mounting adaptor. Make sure that the mounting adaptor is attached the right way round. Mounting adaptor Preventing the
Inhaltszusammenfassung zur Seite Nr. 15
FLANGE BACK ADJUSTMENT (FOR ZOOM LENS) AW-E750, AW-E655, AW-E650 FOCUS Ring Flange back adjust ring This adjustment will bring the subject into focus across the whole range from the maximum telephoto position to the widest angle position of the zoom lens. 1. Fully open the iris by shooting a dark object. (Iris selection switch should be set to M.) 2. Loosen the flange back lock knob. Flange back lock knob 3. Aim the camera at any object over 2 meters away AW-E750, AW-E655, AW-E650 from the camer
Inhaltszusammenfassung zur Seite Nr. 16
AW-E350 FOCUS Ring This adjustment will bring the subject into focus across the whole range from the maximum telephoto position to the widest angle position of the zoom lens. Perform this adjustment when back focusing is not achieved with a fixed focus lens. (Adjustment range: ±0.2 mm) LOCK knob FOCUS knob 1. Fully open the iris by shooting a dark object. 2. Aim the camera at any object over 2 meters away AW-E350 from the camera, remove the cap over the camera’s flange back adjust screw, and lo
Inhaltszusammenfassung zur Seite Nr. 17
IRIS GAIN CONTROL IN A LENS An iris gain control hole is usually provided in the front Iris gain control (G, S) of the lens. Adjustment of the iris gain, with a screwdriv- er through the hole may be done as follows. (Shape and location of the hole may vary depending on the type of lens.) 1. Turn the iris selection switch to Position A (AUTO). 2. Rotate the iris gain control to the maximum gain, but in a range where no hunting or oscillating of the Automatic iris power zoom lens iris ring develop
Inhaltszusammenfassung zur Seite Nr. 18
Inhaltszusammenfassung zur Seite Nr. 19
CONNECTION OF A REMOTE CONTROL UNIT (RCU) Connection to the RCU (WV-RC700A, WV-RC550) is Notes: made through the optional RCU cable AW-CA50A26. • The maximum extension distance between the 1. Turn RCU power off before connecting cables. camera and WV-RC700A is 300 m. The maximum 2. Set the cable selection switch of the RCU to MULTI extension distance between the camera and WV- (in case of using the WV-RC700A) RC550 is 100 m. 3. Connect the 50-pin connector of the RCU cable to • Use the followi
Inhaltszusammenfassung zur Seite Nr. 20
