Bedienungsanleitung SECO-LARM USA Elite 3X Vandal Dome Cameras EV-2866-PKGQ

Inhaltszusammenfassung zur Seite Nr. 1

Elite 3X Vandal Dome Cameras
For Flush or Surface Mount

Installation Manual

EV-2866-NKGQ NTSC
EV-2866-PKGQ PAL

3 Cameras in 1:
1
/ ” Sony Super HAD II CCD 2.8~12mm Varifocal lens
3
600 TV Lines 256x Digital slow shutter
12VDC/24VAC On-screen display (OSD)
Note: Products with model numbers that end with “Q” or that have a round green “Q” sticker are RoHS compliant.

Inhaltszusammenfassung zur Seite Nr. 2

Elite 3X Vandal Dome Cameras for Flush or Surface Mount Specifications: EV-2866-NKGQ EV-2866-PKGQ Type IR LED Dome Camera Video Output Mode NTSC PAL 1 Pickup Element /3” Sony Super HAD II CCD Resolution 600 TV Lines Lens (Varifocal) 2.8~12mm # of Infrared LEDs 33 (850nm) Effective Pixels 768x494 pixels 752x582 pixels Video Output 1Vp-p composite video, 75Ω 0.00006 Lux (LEDs ON) Minimum Illumination 0.05 Lux (LEDs OFF) S/N ratio >52dB (AGC OFF) On

Inhaltszusammenfassung zur Seite Nr. 3

Elite 3X Vandal Dome Cameras Overview: OSD joystick Service monitor port BNC Camera connector Set screw Base (For surface mounting only) Dome Rubber ring Important: DC Plug to Do not cut the DC jack or the female BNC terminal block DC Jack connector as this will void the warranty. Before Starting: 1. Please read this manual carefully and keep it for future 5. Do not mount the camera in areas exposed to reference. radiation, strong magnetic fields, or s

Inhaltszusammenfassung zur Seite Nr. 4

Elite 3X Vandal Dome Cameras for Flush or Surface Mount Troubleshooting: Check that the camera is powered up. Check that the power supply’s polarity is correct. Check that the monitor is powered up. The screen is blank. Check that the video cable connecting the camera to the monitor is connected properly. Clean the lens using a soft, clean cloth. The screen image is dim Check that the light source is adequate. Adjust the monitor’s contrast knob. The screen image has poor con