Inhaltszusammenfassung zur Seite Nr. 1
UX-QX3W_A[A].book Page 1 Friday, July 21, 2006 4:37 PM
MICRO COMPONENT SYSTEM
UX-QX3W
Consists of CA-UXQX3W and SP-UXQX1W
UX-QX3A
Consists of CA-UXQX3A and SP-UXQX1A
To disable the demonstration
display, refer to page 7.
INSTRUCTIONS
GVT0182-005A
[A]
Inhaltszusammenfassung zur Seite Nr. 2
UX-QX3W_A[A].book Page 1 Friday, July 21, 2006 4:37 PM Warnings, cautions and others CAUTION To reduce the risk of electrical shocks, fire, etc.: 1. Do not remove screws, covers or cabinet. 2. Do not expose this appliance to rain or moisture. CAUTION — F (STANDBY/ON) button! Disconnect the mains plug to shut the power off completely (the STANDBY lamp goes off). When installing the apparatus, ensure that the plug is easily accessible. The F (STANDBY/ON) button in any position does not disconn
Inhaltszusammenfassung zur Seite Nr. 3
UX-QX3W_A[A].book Page 1 Friday, July 21, 2006 4:37 PM Table of Contents Introduction Listening to the Radio Notes on Operations............................. 2 Listening to the Radio..........................13 Installation............................................... 2 Setting the AM Tuner Spacing ..............13 Notes on Handling................................... 2 Tuning in to a Radio Station ..................14 Moisture Condensation ........................... 2 Storing (presetting)
Inhaltszusammenfassung zur Seite Nr. 4
UX-QX3W_A[A].book Page 2 Friday, July 21, 2006 4:37 PM Notes on Operations Installation Moisture Condensation • Install the System in a location with adequate Moisture may condense inside the lens on the ventilation to prevent internal heat buildup in the System in the following cases: System. • After starting to heat the room • DO NOT install the System in a location near • In a damp room heat sources, or in a place subjected to direct • If the System is brought directly from a cold sunlig
Inhaltszusammenfassung zur Seite Nr. 5
UX-QX3W_A[A].book Page 3 Friday, July 21, 2006 4:37 PM Introduction The numbers in the figure indicate the Part Identification pages where the details of the parts are. 15 10 9 9 18 14 19, 20 22 12 16, 17 11, 22 10 15 * 9, 13 11 9,14 9 9, 15 - 17 9, 18 9, 15, 23 7 Remote control sensor: 4 Disc tray: 15 7 ** 13 - 15, 17 13 - 15, 17 15, 23 * When the power is turned off, the STANDBY lamp lights red. When the power is turned on, the STANDBY lamp goes off. ** This terminal is for connecting
Inhaltszusammenfassung zur Seite Nr. 6
UX-QX3W_A[A].book Page 4 Friday, July 21, 2006 4:37 PM The numbers in the figure indicate the Remote Control pages where the details of the parts are. Inserting Batteries into the Remote Control 9, 18, 21 8, 14, 16, 17, 20 8 8, 17, 21 8, 14, 18, 20, 21 8, 14, 15, 17, 20, 21 15 R6(UW)·UM-3(UW) 15 R6·AA type dry-cell 18 batteries (2) 16 11 9, 14 9, 15, 9, 18 16, 17 12 16, 17 14 8, 20 22 9, 22 19 9 10 9 9, 10 12 11 10 CAUTION • Do not use a used battery and a new battery together. • Do
Inhaltszusammenfassung zur Seite Nr. 7
UX-QX3W_A[A].book Page 5 Friday, July 21, 2006 4:37 PM Introduction Connections Do not connect the AC power cord until all other connections have been made. Connecting the FM antenna Connecting the Antennas Main unit (rear view) Connecting the AM antenna 1 Set up the AM loop antenna FM antenna (supplied) (supplied). Insert the tab into the slot. Main unit (side view) 2 Connect the antenna cord. Stretch out the FM Main unit (side view) Main unit (rear view) antenna to the best positi
Inhaltszusammenfassung zur Seite Nr. 8
UX-QX3W_A[A].book Page 6 Friday, July 21, 2006 4:37 PM Connections Connecting the Speakers There is no difference between the left and right speakers. After connecting the speakers, gently pull the speaker cords to make sure that they are firmly connected. Main unit (rear view) Speaker cord White White Black Black Right speaker (rear view) Left speaker (rear view) CAUTION NOTE • Improper speaker cord connection spoils the stereo • Do not short-circuit the and speaker effect and sound q
Inhaltszusammenfassung zur Seite Nr. 9
UX-QX3W_A[A].book Page 7 Friday, July 21, 2006 4:37 PM Introduction Do not connect the AC power cord until all other connections have been made. Connecting a Digital Audio Connecting the Power Cord Player AC outlet Main unit (rear view) ■ To listen to a Digital Audio Player Main unit (front view) To the audio output Stereo mini plug audio • After making all other necessary connections, cord (not supplied) connect the power cord. • When you unplug the power cord or if a power NOTE failure
Inhaltszusammenfassung zur Seite Nr. 10
UX-QX3W_A[A].book Page 8 Friday, July 21, 2006 4:37 PM Basic Operations and Settings 4 Press or repeatedly to About this manual In this manual, operations mainly using the set the day of the week. remote control are explained; however, some 5 Press . buttons on the main unit work the same way as those on the remote control. You can use • "CLOCK SET!" appears on the display either button in this case. window and the built-in clock starts working. NOTE • While setting the clock, you can
Inhaltszusammenfassung zur Seite Nr. 11
UX-QX3W_A[A].book Page 9 Friday, July 21, 2006 4:37 PM Turning On/Off the System Emphasizing Bass Sound (AHB PRO) Press . Press . • While the System is turned off, pressing one of • Each time you press , the AHB PRO (Active the buttons below also turns on the System. Hyper Bass PRO) function changes between Remote control: "AHB PRO ON" (initial setting) and "AHB PRO OFF." Main unit: • When the AHB PRO function is activated, The corresponding source will be selected by lights on
Inhaltszusammenfassung zur Seite Nr. 12
UX-QX3W_A[A].book Page 10 Friday, July 21, 2006 4:37 PM Basic Operations and Settings Adjusting the Tone α Sound NOTE α Sound • Before adjusting, set the sound mode to "SOUND α (alpha) waves are regarded as one type of MODE NORMAL" ( page 9). When the sound brain wave that is emitted when a person is mode is set to any item other than "SOUND MODE relaxed. JVC's α SOUND function is designed NORMAL" and you press , "NO OPERATE" to produce natural and comfortable sound that appears on
Inhaltszusammenfassung zur Seite Nr. 13
UX-QX3W_A[A].book Page 11 Friday, July 21, 2006 4:37 PM For the locations of remote control buttons, refer to page 8. Changing the Illumination Touch Illumination Color Even while the System is turned off, you can illuminate the front panel temporarily—Touch Press repeatedly. illumination. • Each time you press , the illumination color for the front panel changes as follows: UX-QX3W RAINBOW = SPACE = SEASONS = CANARY = ECOLOGY = MARSHMALLOW = COSMIC = SHERBET = SODA = POP CANDY = POLA
Inhaltszusammenfassung zur Seite Nr. 14
UX-QX3W_A[A].book Page 12 Friday, July 21, 2006 4:37 PM Basic Operations and Settings Changing the Display Auto Standby Brightness (DIMMER) The System is turned off (on standby) automatically with the Auto Standby function Press repeatedly. activated. • Each time you press , the brightness of the While any source other than FM or AM is front panel changes as follows: selected... Press . : Dims the display. • "A.STANDBY SET" appears on the display window. : Dims the display more than D
Inhaltszusammenfassung zur Seite Nr. 15
UX-QX3W_A[A].book Page 13 Friday, July 21, 2006 4:37 PM Listening to the Radio The System can receive FM and AM radio broadcasts. Setting the AM Tuner Spacing Before operating the tuner, it is required to select the appropriate AM space interval used for your area. On the main unit: Number buttons While the System is turned off... To select 10 kHz spacing, while holding down , press . "AM 10kHz STEP" appears on the display window. To select 9 kHz spacing, while holding down , press . "
Inhaltszusammenfassung zur Seite Nr. 16
UX-QX3W_A[A].book Page 14 Friday, July 21, 2006 4:37 PM Listening to the Radio Tuning in to a Radio Station Storing (presetting) Radio Stations 1Press or . You can store up to 30 FM and 15 AM radio Example: When FM is selected as the stations. source • There is a time limit in doing the following steps. If the setting is canceled before you finish, start Preset number ( right column) from step 1 again. 1 Tune in to a radio station you want to store. • Refer to "Tuning in to a Radio Sta
Inhaltszusammenfassung zur Seite Nr. 17
UX-QX3W_A[A].book Page 15 Friday, July 21, 2006 4:37 PM Listening to Discs The System can play back regular CDs and 3 Press to start playback. finalized CD-Rs/CD-RWs (recorded in audio CD or ■ While an audio CD is being played back... MP3 format). CD indicator (Lights while a disc is stopped and flashes while a disc is being played back or paused.) Elapsed playing time (Flashes while a disc is paused.) Track number Number buttons ■ While an audio CD is stopped... Total number of tracks
Inhaltszusammenfassung zur Seite Nr. 18
UX-QX3W_A[A].book Page 16 Friday, July 21, 2006 4:37 PM Listening to Discs Specifying the Track (Direct Program Playback Track Selection) This function allows you to program up to 99 tracks. Press the number buttons to select While playback is stopped... the track you want to listen to. • Refer to "Using the number buttons" ( page 1 Press repeatedly to select 8). "PROGRAM." Repeat Playback Source display This function allows you to listen repeatedly to the same track (or group: only for
Inhaltszusammenfassung zur Seite Nr. 19
UX-QX3W_A[A].book Page 17 Friday, July 21, 2006 4:37 PM For the locations of remote control buttons, refer to page 15. ■ To cancel the random playback ■ To confirm the programmed track order While playback is stopped... While playback is stopped... Press repeatedly until the source display Press or repeatedly. ■ To add tracks appears on the display window. You can add a track as the last track in the NOTE program. • Ejecting the disc or turning off the System also While playback is sto
Inhaltszusammenfassung zur Seite Nr. 20
UX-QX3W_A[A].book Page 18 Friday, July 21, 2006 4:37 PM Listening to a Digital Audio Player ■ How does the QP Link work? While the QP Link is activated, starting playback performs the following: – While listening to another source... Changes the source to LINE automatically. – While the System is turned off... Turns on the System and selects LINE as the source automatically. NOTE • When the sound signal from the Digital Audio Player is too weak, QP Link may not function correctly. In this
