Inhaltszusammenfassung zur Seite Nr. 1
OPERATINGINSTRUCTIONS
TD A S
AUDIO/VIDEO RECEIVER RVD-9090R T0TALLY DISCRETE AMPLIFIER STAGE
ON SCREEN BAND FM MODE MEMO/ENTER
ST TUNED AUTO TAPE M PRESET
R
MEM
POWER dB
ON/OFF
kHz
MHz
VCR 2 SEL. DYNAMIC RANGE CINEMA EQ SPEAKER MODE
ms
Pro Logic THEATER HALL SLEEP
OPTICAL 1 OPTICAL 2 COAXIAL 1 COAXIAL 2 DTS DIGITAL DIRECT
STANDBY
MASTER VOLUME
STANDBY BASS TREBLE INPUT SELECTOR
DIGITAL 6 CHANNEL DSP
DIRECT STEREO AUDIO
INPUTS DIRECT MODE
TAPE
SPEAKER
MONITOR
VIDEO
PHONES CH SELECTOR CHANNEL L
Inhaltszusammenfassung zur Seite Nr. 2
Introduction UNPACKING AND INSTALLATION Congratulations on Your Purchase! FOR U.S.A. Your new high fidelity receiver is designed to deliver Note to CATV System Installer: This reminder is maximum enjoyment and years of trouble free service. provided to call the CATV system installer's attention Please take a few moments to read this manual to Article 820-40 of the NEC that provides guidelines thoroughly. It will explain the features and operation of for proper grounding and, in particular, spe
Inhaltszusammenfassung zur Seite Nr. 3
READ THIS BEFORE OPERATING YOUR UNIT FOR U.S.A. AND CANADA 120 V FOR OTHER COUNTRIES 110 V/220 V FOR YOUR SAFETY FOR YOUR SAFETY Units shipped to the U.S.A. and Canada are designed Units shipped to countries other than the above for operation on 120 V AC only. countries are equipped with an AC voltage selector switch on the rear panel. Refer to the following Observe all safety precautions with use of a polarized paragraph for the proper setting of this switch. AC plug. However, some products m
Inhaltszusammenfassung zur Seite Nr. 4
CONTENTS Introduction UNPACKING AND INSTALLATION....................................................................................................... 2 READ THIS BEFORE OPERATING YOUR UNIT................................................................................... 3 System Connections........................................................................................................................................ 5 Front Panel Controls.............................................
Inhaltszusammenfassung zur Seite Nr. 5
AUDIO OUT AUDIO IN VIDEO OUT VIDEO IN System Connections When making system connections, please be certain the AC cord is not plugged into an AC outlet. When making connections between components, please be sure to connect the white RCA plugs to the L(left) and the red RCA plugs to the R (right) jacks respectively. Change the position of the FM indoor antenna until you get the best possible reception of your favorite FM stations. A 75 ohm outdoor FM antenna may be used to further improve the
Inhaltszusammenfassung zur Seite Nr. 6
CONNECTING SPEAKERS Front right Front left FRONT SPEAKERS (8Ω) SER. NO AUX AC INPUT S-VIDEO 120V~60Hz R L COAXIAL 1 MON. CD OUT LR FRONT SPEAKERS CAUTION (8Ω) FRONT MODEL NO. RVD-9090R RISK OF ELECTRIC SHOCK AM VIDEO PLAY VCR 2 DO NOT OPEN LOOP PRE MON. AUDIO/VIDEO RECEIVER OUT OUT TAPE WARNING:"SHOCK HAZARD-DO NOT OPEN" MON. MADE IN KOREA REAR DESIGNED IN USA AVIS:"RISQUE DE CHOC-ELECTRIQUE-NE P AS COAXIAL 2 REC DVD R L OUVRIR" REAR Rear "Manufactured under license fro
Inhaltszusammenfassung zur Seite Nr. 7
PRE OUT connections LR Power amplifier FRONT PRE OUT Front speakers REAR SUB CENTER WOOFER Power amplifier Rear speakers Power amplifier Center speaker AC INPUT CORD Plug this cord into a wall AC Powered subwoofer outlet. Use these jacks when adding additional amplifiers. Connect the PRE OUT jacks to the powered speakers or the power amplifiers connected to speakers respectively. To emphasize the deep bass sounds, connect a powered subwoofer. CONNECTING 6 CH DIRECT INPUTS SER.
Inhaltszusammenfassung zur Seite Nr. 8
Front Panel Controls DYNAMIC RANGE/CURSOR LEFT( ) BUTTON/INDICATOR BAND BUTTON ON SCREEN DISPLAY BUTTON/INDICATOR FM MODE/CURSOR UP( ) BUTTON FRONT/REAR VCR 2 SELECT BUTTON/INDICATOR CINEMA EQ/CURSOR DOWN( ) BUTTON/INDICATOR DTS INDICATOR MEMORY/ENTER BUTTON TONE DIRECT INDICATOR STANDBY BUTTON/ INDICATOR SPEAKER MODE/CURSOR RIGHT( ) BUTTON DOLBY DIGITAL POWER SWITCH REMOTE SENSOR (AC-3) INDICATOR TD A S AUDIO/VIDEO RECEIVER RVD-9090R T0TALLY DISCRETE AMPLIFIER STAGE ON SCREEN BAND FM
Inhaltszusammenfassung zur Seite Nr. 9
Speaker Placement To obtain the best surround sound effect in your home, place the speakers as FRONT TV set FRONT LEFT RIGHT SUB CENTER follows; WOOFER SPEAKER Front speakers: Place each front speaker about 1m (40 ) from the TV set. Center speaker: Place the center speaker either above or below the TV set to assure good visualization of center channel program. Rear speakers: Place the rear speakers approximately 1m above the ear level of a seated listener on the direct left and right of them
Inhaltszusammenfassung zur Seite Nr. 10
DIGI LINK III System Remote Controls This receiver and other compatible Sherwood components can be operated via remote control. Compatible Sherwood components bear the DIGI LINK II or III logo. To enable the DIGI LINK control system, you must first interconnect the green(Digi Link) jacks on each Sherwood component using standard RCA cables. (See page 6 for details) ENTER BUTTON PRESET SCAN BUTTON NUMERIC(1~0)/CURSOR CONTROL ( , , , ) BUTTONS ON SCREEN DISPLAY BUTTON POWER OSD ENTER
Inhaltszusammenfassung zur Seite Nr. 11
30 REMOTE CONTROL OPERATION RANGE TD A S AUDIO/VIDEO RECEIVER RVD-9090R T0TALLY DISCRETE AMPLIFIER STAGE ST AUTO PRESET ON SCREEN BAND FM MODE MEMO/ENTER TUNED TAPE M R MEM POWER dB ON/OFF kHz MHz VCR 2 SEL. DYNAMIC RANGE CINEMA EQ SPEAKER MODE ms Pro Logic THEATER HALL SLEEP OPTICAL 1 OPTICAL 2 COAXIAL 1 COAXIAL 2 DTS DIGITAL DIRECT STANDBY MASTER VOLUME STANDBY BASS TREBLE INPUT SELECTOR DIGITAL 6 CHANNEL DSP DIRECT INPUTS DIRECT MODE STEREO AUDIO TAPE SPEAKER MONITOR VIDEO PHONES CH SELECT
Inhaltszusammenfassung zur Seite Nr. 12
Operations ADJUSTING SPEAKER SETTINGS SPEAKER MODE Select the desired speaker Adjusting the speaker settings setting. 2 This receiver is equipped with circuitry that allows the use of a wide range of speaker systems. This circuitry works by redirecting the bass frequencies or the entire channel to speakers that are Each time this button is pressed, one of 11 different capable of reproducing them. speaker settings is selected and displayed for 8 When a large or full range speaker capable of d
Inhaltszusammenfassung zur Seite Nr. 13
Adjust the level of the selected Adjusting each channel level channel as desired. 7 Select the channel to adjust. 6 POWER OSD ENTER P.SCAN 1 2 3 4 5 6 7 8 9 0 DISC CD REPEAT INTRO A B SCAN CD TUNER DECK SEL. AB AUX TAPE MON. POWER OSD ENTER P.SCAN DVD/TV VCR1 VCR2 1 2 3 4 5 CHANNEL LEVEL 6CH DIRECT DECK 6 7 8 9 0 EQ PRESET USER FILE DISPLAY T.MON DISC CD REPEAT INTRO DSP STEREO A B SCAN MODE CD TUNER DECK SEL. CHANNEL T.TONE D.TIME ADJUST AB SEL AUX TAPE MON. CHANNEL LEVEL MASTER VOLUME
Inhaltszusammenfassung zur Seite Nr. 14
ADJUSTING DELAY TIMES Check the current delay POWER OSD ENTER P.SCAN Adjusting delay times of the 1 2 3 4 5 6 7 8 9 0 time. Press the D.Time DISC CD REPEAT INTRO A B SCAN CD TUNER DECK SEL. speakers in Dolby Digital(AC-3), AB AUX TAPE MON. DVD/TV 12 VCR1 VCR2 button on the remote 6CH DIRECT EQ DECK PRESET USER FILE DISPLAY T.MON D.TIME DSP STEREO Dolby Pro Logic and the DSP modes MODE CHANNEL T.TONE D.TIME ADJUST SEL control. CHANNEL LEVEL MASTER VOLUME DISPLAY SLEEP MUTE SYS REMOTE CONTROL
Inhaltszusammenfassung zur Seite Nr. 15
LISTENING TO A PROGRAM SOURCE Select the desired input source. Before operation 3 POWER Enter the standby mode. ON/OFF INPUT SELECTOR POWER OSD ENTER P.SCAN 1 2 3 4 5 6 7 8 9 0 DISC AUDIO CD REPEAT INTRO A B SCAN CD TUNER DECK SEL. AB AUX TAPE MON. CD TUNER TAPE DVD/TV VCR1 VCR2 MONITOR 6CH DIRECT EQ DECK PRESET USER FILE DISPLAY T.MON VIDEO AUX TAPE MON. DSP STEREO MODE CHANNEL T.TONE D.TIME ADJUST The STANDBY indicator lights up. SEL CHANNEL LEVEL MASTER VOLUME or DISPLAY SLEEP MUTE SYS
Inhaltszusammenfassung zur Seite Nr. 16
The 6 CH DIRECT INPUT Operate the selected component for Use this input to listen to the audio output of an playback. external decoder or a DVD player with built-in 6 5 channel decoder. POWER OSD ENTER P.SCAN 1 2 3 4 5 6 7 8 9 0 6 CHANNEL DISC CD REPEAT INTRO A B SCAN DIRECT CD TUNER DECK SEL. When playing back the program sources with AB AUX TAPE MON. DVD/TV 6 CH DIRECT VCR1 VCR2 6CH DIRECT EQ DECK surround sound, refer to “ENJOYING SURROUND PRESET USER FILE DISPLAY T.MON DSP STEREO or MO
Inhaltszusammenfassung zur Seite Nr. 17
To compensate for edgy or shrill movie To mute the sound. sound tracks. 9 10 CINEMA EQ POWER OSD ENTER P.SCAN 1 2 3 4 5 6 7 8 9 0 DISC CD REPEAT INTRO A B SCAN CD TUNER DECK SEL. AB AUX TAPE MON. DVD/TV VCR1 VCR2 6CH DIRECT EQ DECK PRESET USER FILE DISPLAY T.MON DSP STEREO MODE CHANNEL T.TONE D.TIME ADJUST SEL CHANNEL LEVEL MASTER VOLUME MUTE DISPLAY SLEEP MUTE SYS REMOTE CONTROL RM-RVD-98H Press it again to cancel. “MUTE” will flicker. To resume the previous sound level, press it again.
Inhaltszusammenfassung zur Seite Nr. 18
SURROUND SOUND This unit incorporates a sophisticated Digital Signal Processor that allows you to create optimum sound quality and sound atmosphere in your personal Home Theater. Surround modes This unit has 6 different surround modes to allow you to enjoy surround sound with various program sources: DTS, DOLBY DIGITAL(AC-3), DOLBY PRO LOGIC, THEATER, HALL 1, HALL 2. DTS (Digital Theater System) : Allows you to enjoy 5.1(or 6) discrete channels of high quality digital audio from DTS program sou
Inhaltszusammenfassung zur Seite Nr. 19
ENJOYING SURROUND SOUND Surround sound will not work properly if the signal passes through a graphic equalizer. Please refer to your equalizer operating instructions for guidance on switching off (or defeating) the equalizer. Select the desired surround mode. When selecting the DTS or Dolby Surround mode. When selecting a surround mode between THEATER, HALL 1 and HALL 2 modes. POWER OSD ENTER P.SCAN 1 2 3 4 5 POWER OSD ENTER P.SCAN 6 7 8 9 0 1 2 3 4 5 DISC CD REPEAT INTRO A B SCAN 6 7 8 9
Inhaltszusammenfassung zur Seite Nr. 20
LISTENING TO RADIO BROADCASTS Select the desired band. Auto tuning 2 BAND Select the tuner. MHz 1 INPUT SELECTOR POWER OSD ENTER P.SCAN 1 2 3 4 5 6 7 8 9 0 BAND FREQUENCY DISC TUNER CD REPEAT INTRO A B SCAN AUDIO CD TUNER DECK SEL. AB AUX TAPE MON. DVD/TV VCR1 VCR2 6CH DIRECT DECK EQ PRESET USER FILE DISPLAY T.MON DSP STEREO or MODE CHANNEL T.TONE D.TIME ADJUST SEL CHANNEL LEVEL MASTER VOLUME Each time this button is pressed, the band is changed DISPLAY SLEEP MUTE SYS to FM or AM. REMOTE CO
