Bedienungsanleitung Link electronic 101/201

Inhaltszusammenfassung zur Seite Nr. 1

User ’ s Manual
1
AcerRouter 101/201

Inhaltszusammenfassung zur Seite Nr. 2

The Federal Communications Commission Statement 2 may cause undesired operation. (2)This device must accept any interference received, including interference that (1)This device may not cause harmful interference, and Operation is subject to the following two conditions: This device complies with part 15 the FCC Rules. equipment party responsible for compliance could void your authority to operate the You are cautioned that changes or modifications not expressly approved by the an experienced ra

Inhaltszusammenfassung zur Seite Nr. 3

Table of Contents 2 CHAPTER 1 INTRODUCTION 4 4 BOUT A R OUTER . 5 EATURES AND B 5 5 CHAPTER 2 BEFORE YOU START 7 ACKAGE C ONTENTS 7 ARDWARE D 8 8 9 R CHAPTER 3 QUICK ARDWARE I NSTALLATION - N ETWORK S R OUTER SETTINGS EST CHAPTER 4 ADVANCED W EB M T ELNET T P C ONSOLE C ABLE CHAPTER 5 TROUBLESHOOTING SPECIFICATIONS . GLOSSARY 3 40 ........... ................................ ................................ APPENDIX B 38 ..................

Inhaltszusammenfassung zur Seite Nr. 4

Chapter 1 Introduction ’ ’ ’ 4 Glossary Explains words and phrases in this manual. Appendix B Specifications specifications as a quick reference. s technical AcerRouter 101/201 Lists Appendix A AcerRouter 101/201. when using the Lists problems and solutions one may encounter Troubleshooting password. back to defaults, and changing the server procedures such as resetting the server, setting contains a command reference section for modems and ISP accounts. This chapter also AcerRouter 101/201, in

Inhaltszusammenfassung zur Seite Nr. 5

Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ 5 AcerRouter 101/201 can hook up and drop With proper configuration, the surfing the Net, using two modems would be faster and more efficient. for is more economical to use one modem. Yet, if you require more bandwidth choose to link either one or two modems based on their needs. Normally, it The series supports one or two modem Internet accesses. Users can Internet Access users on your network can have access to Internet simultaneously. users by sharing net

Inhaltszusammenfassung zur Seite Nr. 6

Ÿ Ÿ Ÿ 6 administrator does not wish to serve. from internal resources. It also can filter internal Internet requests that the AcerRouter 101/201 supports firewall security that can deny Internet users Security Virtual Host function provided by the unit. Internet users can access the target host to get the information by using If you have a fixed IP address, you can setup a virtual host environment. Virtual Server the sake of security. through modem connection. Optional callback function is al

Inhaltszusammenfassung zur Seite Nr. 7

Chapter 2 Before You Start Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ ¡ ] ¡ ^ Ÿ Ÿ 1 1 ’ 1 1 1 1 2 1 0 1 7 AcerRouter 101 2.2.1 2.2 Hardware Description RJ-11 Phone Cable RS-232 Modem Cable (shielded) (shielded) RS-232 Configuration Cable s Manual User 1(AC9V,1A) 1(AC9V,1A) Power Adapter Router 201 101 AcerRouter AcerRouter In this package, you should find: 2.1 Package Contents properly. Please verify whether your computer is installed and configured with TCP/IP A dedica

Inhaltszusammenfassung zur Seite Nr. 8

Ÿ ¡ ] ¡ ^ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ COM1 st 1 Ÿ COM2 2 Ÿ 8 Node RS-232 port connecting with external modem or ISDN-TA nd RS-232 port connecting with external modem or ISDN-TA Figure 2. Rear Panel Description Indicates the data input activity of 10/100Mbps LAN port LAN-Rx (green) Indicates the data output activity of 10/100Mbps LAN port Tx (green) LAN- Indicates the collision status of 10/100Mbps LAN port Col (yellow) LAN- Indicates the data input activity of COM2 port COM2-RxD (green) Indicates

Inhaltszusammenfassung zur Seite Nr. 9

Ÿ Ÿ Ÿ Ÿ ¡ ] ¡ ^ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ 9 Indicates the data input activity of 10/100Mbps LAN port LAN-Rx (green) Indicates the data output activity of 10/100Mbps LAN port Tx (green) LAN- Indicates the data input activity of COM2 port COM2-RxD (green) Indicates the data output activity of COM2 port COM2-TxD (green) Indicates the hook status of V.90 modem V.90-OH (green) Indicates the data input activity of V.90 modem V.90-RxD (green) Indicates the data output activity of V.90 modem V.90-TxD (gre

Inhaltszusammenfassung zur Seite Nr. 10

Ÿ Ÿ PHONE Ÿ COM2 2 Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ ¡ ] ¡ ^ Ÿ Ÿ 10 A dedicated phone line or ISDN line At least one modem or ISDN terminal adapter For Web configuration later browser Microsoft Internet Explorer 4.0 or later, or Netscape Communicator 4.0 or UTP network cable with RJ-45 connector At least one computer for configuration TCP/IP network protocol for each PC 16-bit, small-font monitor settings or above are suggested 10/100Base-T Ethernet card A 80486 or greater processor computer equi

Inhaltszusammenfassung zur Seite Nr. 11

2.4 ISP Requirements Ÿ Ÿ Ÿ Ÿ ’ Ÿ 11 Subnet mask (optional, for fixed IP users only.) IP Address and s Domain Name Server IP address Your ISP ISP dial-up phone number An ISP account which includes ISP dial-up username and password ISP authentication type or script (if not PAP/CHAP) Please collect the following information from your ISP before setup:

Inhaltszusammenfassung zur Seite Nr. 12

Chapter 3 Quick Installation ¡ G ¡ G ¡ G ¡ G ¡ G LAN. 3.1 Hardware Installation . 12 101/201 AcerRouter illustration below and follow the simple steps to quickly install your . Refer to the 201 AcerRouter 101/ The followings are instructions for setting up the To set up all other client stations in the same Setting up other clients 5. correct. Use browser to access external web site to check if all settings are Test 4. using Java compatible web browser or Telnet program. AcerRouter 101/2

Inhaltszusammenfassung zur Seite Nr. 13

13 AcerRouter 201 Hardware Installation Figure 6. AcerRouter 101 Hardware Installation Figure 5.

Inhaltszusammenfassung zur Seite Nr. 14

¡ ] ¡ ^ to COM 1 – “ ” “ ” – Only “ ” “ ” “ ” Windows 95 desktop, double click “ ” . Ÿ Ÿ 14 My Computer . On AcerRouter 101/201 Choose a computer in LAN to configure the 1. below to configure the units: After installing the AcerRouter 101/201 hardware, please follow the procedures 3.2 Client-side Network Settings Power LED should be lit immediately. supply output cable into the power connector on the rear of the unit. The power adapter outlet, then plug the power /201 AcerRouter 101

Inhaltszusammenfassung zur Seite Nr. 15

Ÿ “ ” . Double click “ ” “ TCP/IP ” “ ” 15 , otherwise, go to Step 6. Add component is installed or not. If not, click card which you installed. Please check out if the network interface . This window appears the related information about Network 3. Control Panel 2. Double click

Inhaltszusammenfassung zur Seite Nr. 16

Double click “ ” . “ ” “ TCP/IP ” click “ OK ” . 16 component on the right side. After TCP/IP component is completely installed, , and then select Microsoft On the left side of the window, choose 5. Protocol 4.

Inhaltszusammenfassung zur Seite Nr. 17

Double click “ TCP/IP ” same Network, click “ ” “ ” 17 the system will configure them automatically. item. Meantime, ignore the Gateway and DNS settings because automatically Obtain IP address and select IP Address The TCP/IP Properties window appears. If there is no DHCP server in the 7. component. 6.

Inhaltszusammenfassung zur Seite Nr. 18

¡ G “ ” “ ”¡ ] ¡ ^ “ ” “ ” 3.3 “ ENTER ” “ ” “ ” . Then click “ OK ” 18 The Quick Setup window pops up consequently. to enter Web Management. admin window will pop up. Leave the User Name blank and fill in the Password Username and Password Required key on your keyboard. The in the address and press 192.168.1.1 other Java compatible browser) and type Start your web browser (Netscape Navigator 4.0 or Microsoft Explorer4.0 later or 1. settings AcerRouter 101/201 procedures. . Afterwards,

Inhaltszusammenfassung zur Seite Nr. 19

“ ” ’ ’ ISP “ ” 19 to save the data and logout setup. Save Check all the values and click 6. , or select one applicable from the drop-down box. 255.255.255.0 Subnet Mask and 192.168.1.1 In Intranet Setting, enter the default value 5. should be provided by ISP as soon as you applied the account. respectively. The information phone number, DNS IP, User ID and Password For most PPP dial-up account, below 4 parameters are needed. Fill the 4. drop-down box. s ok to select PPP. Select the appl

Inhaltszusammenfassung zur Seite Nr. 20

3.5 Setting 20 fixed IP configuration, be careful not to assign the same IP to different computers. Follow the 3.2 Client-Side Network Settings to set up other client stations. If you use Up Other Client Stations Otherwise, refer the Troubleshooting section for further instructions. Once the Link LED is on, the Internet connection is successfully established. to see if the modem dials properly. www.yahoo.com external web site address like setup, run another browser and key in any AcerRouter