Bedienungsanleitung HP (Hewlett-Packard) 1410-16G

Inhaltszusammenfassung zur Seite Nr. 1

QSG-1410-16G-Feb2010.fm Page 1 Thursday, February 25, 2010 7:45 PM
HP ProCurve 1410-16G Switch Quick Setup Guide
For more detailed information to set up your switch, view or download the Installation and Getting Started Guide for your
switch at www.hp.com/go/procurve/manuals.
1. Unpack and check included parts. ■ Documentation kit
•Read Me First
� Quick Setup Guide
� Safety and Regulatory information
� Software License Agreement and Hardware Warranty
information
■ Switch
■ Accessory kit

Inhaltszusammenfassung zur Seite Nr. 2

QSG-1410-16G-Feb2010.fm Page 2 Thursday, February 25, 2010 7:45 PM 4. Install the Switch Hardware (Continued) M-4 tap Wall (or Under-Table): A special kit for wall-mounting (or screws under-table mounting) is included. Use a #1 Phillips (cross- head) screwdriver and the 20-mm M4 tap screws (included). For screw positions, see the mounting template on page 4. (Under-Table: After installation, a third screw may be used to prevent switch movement.) For wall-mounting, the network ports

Inhaltszusammenfassung zur Seite Nr. 3

QSG-1410-16G-Feb2010.fm Page 3 Thursday, February 25, 2010 7:45 PM Safety Precautions To avoid personal injury or product damage when installing your switch, read the installation precautions and guidelines below. Installation Precautions Warnings ■ The rack or cabinet should be adequately secured to prevent it from becoming unstable, tilting or falling. Devices installed in a rack or cabinet should be mounted as low as possible, with the heaviest devices at the bottom and progressively li

Inhaltszusammenfassung zur Seite Nr. 4

QSG-1410-16G-Feb2010.fm Page 4 Thursday, February 25, 2010 7:45 PM Wall Mounting Template for HP ProCurve 1410-16G Switch (Under-table mounting) After installation, prevent switch movement by placing a third screw along this side. 58 mm 2.28 inch Screw-hole position for mounting 150 mm 5.91 inch 4