Bedienungsanleitung HP (Hewlett-Packard) 516733B21

Inhaltszusammenfassung zur Seite Nr. 1

HP ProCurve Overview
This card provides instructions for installing an HP ProCurve 6120XG
6120XG Blade Switch
Blade Switch for c-Class BladeSystem in an HP c-Class BladeSystem
enclosure.
Installation Instructions

for HP c-Class BladeSystem




Kit contents

 HP ProCurve 6120XG Blade Switch
 Console cable (USB A to USB mini-AB)
 Customer Support/Warranty booklet
 License documentation
 This document

IMPORTANT: Only use HP-approved pluggable SFP+ or SFP

optical t

Inhaltszusammenfassung zur Seite Nr. 2

switch CLI, accessing it via serial interface attached to OA Port 17 consists of a CX4 port multiplexed with an SFP+ port. Only and/or USB interface attached to the blade. one may be active. The SFP+ port takes precedence: if it contains a module, it is the active port and the CX4 port is inactive.  When using optional transceiver modules or direct attach cables, order the modules and cables separately. For more Ports 23 and 24 are each multiplexed with inter-switch link ports informatio

Inhaltszusammenfassung zur Seite Nr. 3

3. Install the blade switch into the interconnect bay. Installing the HP ProCurve 6120XG A green Module Status (“health”) LED indicates a Blade Switch successful installation. If the Module Status LED is amber If there is only one blade switch in the chassis, it must occupy a slot or is off, see the “Troubleshooting” section of the HP on the left-hand side of the chassis (as you face the back of the BladeSystem enclosure setup and installation guide for chassis). If there is more tha

Inhaltszusammenfassung zur Seite Nr. 4

detailed information on configuring the blade switch. The complete 1. Verify network connectivity between the blade switch and manual set for the blade switch software is available at your workstation or laptop computer using a “ping” http://www.hp.com/go/bladesystem/documentation. command. 2. Using a terminal program (such as HyperTerminal or TeraTerm), open a connection using the blade switch’s IP address, Telnet protocol, and port 23. Accessing the blade switch via the 3. Press Ente