Inhaltszusammenfassung zur Seite Nr. 1
2-9291
12 Number Memory FM/AM Clock
Radio Telephone User’s Guide
We bring good things to life.
Inhaltszusammenfassung zur Seite Nr. 2
FCC REGISTRATION INFORMATION Your GE telephone equipment is registered with the Federal Communications Commission and is in compliance with parts 15 and 68, FCC Rules and Regulations. 1 Notification to the Local Telephone Company On the bottom of this equipment is a label indicating, among other information, the FCC Registration number and Ringer Equivalence Number (REN) for the equipment. You must, upon request, provide this information to your telephone company. The REN is useful in determinin
Inhaltszusammenfassung zur Seite Nr. 3
INTRODUCTION Your GE 2-9291 12 Number Memory FM/AM Clock Radio Telephone is designed to give you flexibility in use and high quality performance. To get the most from your new clock radio telephone, we suggest that you take a few minutes right now to read through this instruction manual. TABLE OF CONTENTS FCC REGISTRATION INFORMATION ........... 2 NUMBERS ....................................... 10 INTERFERENCE INFORMATION ................... 2 OPERATE THE RADIO ............................. 11 H
Inhaltszusammenfassung zur Seite Nr. 4
F M A 8 M 5 3 0 8 92 6 5 0 96 1 800 GETTING STARTED Make sure your package contains the following items: QUICK DIAL A B C ABC DEF 1 2 3 QUICK DIAL GHI JKL MNO A 4 5 6 B C PQRS TUV WXYZ 7 8 9 ABC DEF 1 2 3 OPER 0 # FLAS STOREMEM DIAL REDIAL HI LO OFF PULSE TONE GHI JKL MNO 4 5 6 PQRS TUV WXYZ 7 8 9 OPER 0 # FLAS STOREMEM DIAL REDIAL Telephone handset cord AC power cord HI LO OFF PULSE TONE line cord Handset HOUR MIN OFF MUSIC VOLUME ON ALARM SNOOZE SLEEP
Inhaltszusammenfassung zur Seite Nr. 5
POWERING UP “NO WORRY” BATTERY BACKUP This clock radio is equipped with a memory holding system that can be powered with a customer-installed 9-volt alkaline battery (not in- cluded). When power is interrupted, or AC line cord is unplugged, the battery will power the clock radio to keep track of time and alarm settings programmed into memory. When on battery power, the digital display will not light; however, should WAKE time occur during the power interruption, the radio will operate or the ala
Inhaltszusammenfassung zur Seite Nr. 6
F A M 8 M 5 3 0 8 92 6 5 0 96 1 800 INSTALLATION 2 QUICK DIAL A B C 1. Plug the telephone cord into the 1 ABC2 DEF3 4 GHI JKL MNO 4 5 6 PQRS TUV WXYZ 7 8 9 modular wall jack. OPER0 # FLAS STOREMEM DIAL REDIAL HI LO OFF PULSE TONE 2. Connect the handset to the base unit. 1 3. Set the PULSE/TONE switch (located on the handset) to TONE if you have touch-tone service, or to PULSE if you have rotary dial service. 4. Plug the power cord into any 120V AC wall outlet. HOUR MIN OFF M
Inhaltszusammenfassung zur Seite Nr. 7
TELEPHONE OPERATION SETTING RINGER VOLUME The ringer volume switch is located on the handset. Set it to HI, LO, or OFF. QUICK DIAL Remember that the RINGER switch A B C must be set to HI or LO or the phone ABC DEF 1 2 3 will not ring for incoming calls. GHI JKL MNO 4 5 6 TEMPORARY TONE FEATURE Use the Temporary Tone feature if PQRS TUV WXYZ 7 8 9 you have Pulse (rotary) service, and want to access custom calling OPER 0 # services that require touch-tone FLAS STOREMEM DIAL REDIAL dialing, such as
Inhaltszusammenfassung zur Seite Nr. 8
FLASH BUTTON Press the FLASH button instead of using the hook switch to activate custom calling services such as call waiting or call transfer, which may be provided by your local phone company. REDIAL BUTTON QUICK DIAL Redial the last number you called A BC by pressing the REDIAL button after you get a dial tone. The Redial feature holds in memory ABC DEF 1 2 3 the last phone number you dialed manually. If you pressed any numbers after dialing the phone GHI JKL MNO 4 5 6 number, (for example,
Inhaltszusammenfassung zur Seite Nr. 9
MEMORY DIALING Store as many as 12 numbers in memory for easy dialing. Three can be stored in the Emergency Quick Dial locations, and nine additional numbers can be stored in the numbered keys (1-9). STORING A NUMBER IN MEMORY 1. Pick up the handset. QUICK DIAL 2. Press the STORE button. A BC 3. Dial the number to be stored. 4. Press the STORE button. ABC DEF 1 2 3 5. Press a memory location (1-9 on the keypad), or an EMERGENCY QUICK DIAL button (A, B, or C). GHI JKL MNO 4 5 6 6. Hang up the han
Inhaltszusammenfassung zur Seite Nr. 10
4. Press REDIAL to add a pause, and then dial the number. 5. Press the STORE button. 6. Press an EMERGENCY QUICK DIAL button, or press MEM DIAL followed by a memory location (1-9 on the keypad). CHANGING A STORED NUMBER Change a stored number by replacing it with a different number. DIALING A NUMBER FROM MEMORY You can dial numbers from memory when using the handset. When you get a dial tone, press the MEM DIAL button followed by the memory IMPORTANT: If you make test location (1-9) for the numb
Inhaltszusammenfassung zur Seite Nr. 11
OPERATE THE RADIO OFF MUSIC 1. Slide function selector to ON. ON ALARM 2. Slide the AM/FM BAND switch (located on the right side of the unit) to the desired broadcast band. 3. Turn TUNING knob to select a station. TUNER AM FM 4. Adjust the VOLUME control to your preferred listening level. 5. To turn the radio off, slide the VOLUME function selector to OFF. BUILT-IN AFC The Built-In Automatic Frequency Control (AFC) works only on FM. It helps keep the radio locked in on the FM station to which i
Inhaltszusammenfassung zur Seite Nr. 12
FM Antenna - The power cord acts as your FM antenna. The power cord picks up moderate to strong stations and eliminates the need for an external antenna in most strong signal areas. Be sure the power cord is stretched out to its full length. Do not coil or bunch the cord together. Changing position of the power cord may improve reception. SET THE TIME Your digital clock timer operates on AM a 24-hour cycle. The AM indicator on the left of the display will light WAKE up to let you know if the di
Inhaltszusammenfassung zur Seite Nr. 13
WAKE TO MUSIC 1. Select an AM or FM station 2. Set the wake time. 3. Set function selector to MUSIC position. (The WAKE indicator in the display will light.) The radio will turn on at the wake time you set and will turn itself off after approximately 2 hours. To turn the radio off sooner, set OFF MUSIC ON ALARM function selector to OFF. WAKE TO ALARM 1. Set the wake time. 2. Place the function selector in the ALARM position. (The WAKE indicator in the display will light.) The tone alarm will sou
Inhaltszusammenfassung zur Seite Nr. 14
SLEEP TO MUSIC You can drift off to sleep to music knowing that the radio will turn itself off automatically. Simply: OFF MUSIC 1. Set the function selector to the ON ALARM OFF position. 2. Press and hold the SLEEP button. The time display will exhibit 0:59. The radio will turn on automati- cally. 3. While holding SLEEP button, press the MIN button and time will start HOUR MIN to count down. Select any sleep time between 59 minutes and 1 minute. For sleep time of more than 59 minutes, up to 1 h
Inhaltszusammenfassung zur Seite Nr. 15
SLEEP TO MUSIC AND WAKE TO MUSIC OR ALARM You can set your clock radio to lull you to sleep, turn itself off, then awaken you at a preset time - all automatically. 1. Set the wake time. 2. Follow the steps under WAKE TO MUSIC or WAKE TO ALARM. HOUR MIN 3. Then, proceed with Steps 2 through 4 under SLEEP TO MUSIC. NOTE: Be sure the function SLEEP WAKE selector is in the correct WAKE position. USING SNOOZE ALARM After the wake mode has activated, you can silence it for another 9 minutes by pressin
Inhaltszusammenfassung zur Seite Nr. 16
MINUTES AND SECONDS TIME DISPLAY For a display of time in minutes and HOUR MIN seconds: 1. Press and hold the WAKE button. 2. While holding down WAKE button, momentarily press the SLEEP WAKE SLEEP button. The hour digits will display minutes; the minute digits will display seconds and start to increment. Release WAKE button to return to the hour and minute display. 16
Inhaltszusammenfassung zur Seite Nr. 17
TROUBLESHOOTING TIPS TELEPHONE Problem Solution No dial tone. • Check hook switch to make Won't dial out sure it pops up. • Make sure TONE/PULSE is set to correct position. • Unplug the phone, wait 30 seconds, and plug the phone back in. Phone doesn’t ring • Check RINGER VOLUME. • Could have too many phones on one line. (See FCC registration information regarding REN). Light and tone • This is normal as power is fluctuating feedback flutter when with phone outpulsing. dialing in PULSE mode. Can’
Inhaltszusammenfassung zur Seite Nr. 18
GENERAL PRODUCT CARE To keep your phone working and looking good, follow these guidelines: • Avoid putting it near heating appliances and devices that generate electrical noise (for example, motors or fluorescent lamps). • DO NOT expose to direct sunlight or moisture. • Avoid dropping and other rough treatment of the unit. • Clean with a soft cloth. • Never use a strong cleaning agent or abrasive powder because this will damage the finish. • Retain the original packaging in case you need to shi
Inhaltszusammenfassung zur Seite Nr. 19
INDEX A N Adding a Pause to Dialing Sequence 9 “No Worry” Battery Backup 5 Antennas 11 O B Operate the Radio 11 Before You Begin 4 P Built-in afc 11 Power failure indicator 6 C Powering Up 5 Changing a Stored Number 10 R D Redial Button 8 Dialing a Number from Memory 10 S Dialing the Emergency Quick Dial Numbers 10 Service 18 Display Brightness 6 Set the Time 12 Set the wake time 12 F Setting Ringer Volume 7 FCC Registration Information 2 Sleep to music 14 Flash Button 8 Slee
Inhaltszusammenfassung zur Seite Nr. 20
LIMITED WARRANTY What your warranty covers: • Any defect in materials or workmanship. For how long after your purchase: • One year. (The warranty for rental units begins with the first rental or 45 days from date of shipment to the rental firm, whichever comes first.) What we will do: • Provide you with a new, or at our option, a refurbished unit. • The exchange unit is under warranty for the remainder of the original product’s warranty period. How to make a warranty claim: • Properly pack your
