Bedienungsanleitung JVC KD- KD-R210

Inhaltszusammenfassung zur Seite Nr. 1

Thank you for purchasing a JVC product.
KD-R210
Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best
possible performance from the unit.
CD RECEIVER: INSTRUCTIONS/INSTALLATION
Installation/connection are explained at the last section of this manual (reverse page, indicated with
symbol).
For customer Use:
Enter below the Model No. and Serial No. which
are located on the top or bottom of the cabinet.
Retain this information for

Inhaltszusammenfassung zur Seite Nr. 2

OPERATIONS Disc operations Basic operations Remote sensor Check the current clock time/other information. Control panel DO NOT expose to strong light. See also “CLK DISP“ of “General settings—PSM.” • Turn on the power. • Turn off the power [Hold]. • Attenuate the sound (if the Eject disc. power is on). • Press SRC to listen to another playback source. Detach the panel. Select the source. Volume control. • 4 / ¢ [Press] Select track (for CD) or folder* (for MP3/ [Press] Go to the next or pr

Inhaltszusammenfassung zur Seite Nr. 3

SETTINGS TROUBLESHOOTING Sound adjustments Symptoms Remedies/Causes • Sound cannot be heard from the speakers. • Adjust the volume to the optimum level. • Check the cords and connections. Preset values BAS MID TRE LOUD • The buttons on the unit do not work as you If you press M MODE, some buttons work differently from it Indication (For) (bass) (mid-range) (treble) (loudness) intended. original function. Wait for 5 seconds or press M MODE again. USER (Flat sound) 00 00 00 OFF • This unit does

Inhaltszusammenfassung zur Seite Nr. 4

PREPARATION WARNINGS TROUBLESHOOTING • The fuse blows. This unit is designed to operate on 12 V DC, NEGATIVE ground electrical To prevent short circuits, we recommend that you disconnect the battery’s * Are the red and black leads connected correctly? systems. If your vehicle does not have this system, a voltage inverter is required, negative terminal and make all electrical connections before installing the unit. • Be sure to ground this unit to the car’s chassis again after installation. • Po