Inhaltszusammenfassung zur Seite Nr. 1
™
Zing
USER’S GUIDE
7100 SERIES
3
Safety Instructions
4
Product View
5
Assembly
5-7
Operations
7-8
Maintenance and Care
9
Troubleshooting
10
Consumer Services
11
Replacement Parts
12
Warranty
ug110-4001_7100_507.indd 1 ug110-4001_7100_507.indd 1 5 5/22/07 5:00:58 PM /22/07 5:00:58 PM
Inhaltszusammenfassung zur Seite Nr. 2
Thanks for buying a BISSELL Zing™ Canister Vacuum We’re glad you purchased a BISSELL Zing™ canister vacuum. Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system. Your BISSELL canister vacuum is well made, and we back it with a limited one year warranty. We also stand behind it with a knowledgeable, dedicated Consumer Services department, so, should you ever have a problem, you’ll receive fast, considerate assistance. My
Inhaltszusammenfassung zur Seite Nr. 3
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic ■ Do not pick up toxic material (chlorine bleach, precautions should be observed, including ammonia, drain cleaner, etc.). the following: ■ Do not use in an enclosed space filled with vapors given off by oil base paint, paint thinner, some moth READ ALL INSTRUCTIONS proofing substances, flammable dust, or other explosive or toxic vapors. BEFORE USING YOUR ■ Do not use for any purpose other than described in CANISTE
Inhaltszusammenfassung zur Seite Nr. 4
Product view Handle Air Flow Regulator Flexible Hose Telescoping Extension Wand Swivel Hose Suction Inlet Dust Bag Compartment Full Bag Indicator Floor Nozzle Carrying Handle Automatic Cord Rewind Power Switch Variable Suction Control Carpet/Bare Floor Selector Storage Clip Final Filter Combo Crevice/ Dusting Brush Tool 4www.bissell.com 800.237.7691 u ug110-4001_7100_507.indd 4 g110-4001_7100_507.indd 4 5 5/22/07 5:01:01 PM /22/07 5:01:01 PM
Inhaltszusammenfassung zur Seite Nr. 5
C AUTION: Assembling your vacuum Do not plug in your vacuum until you 1. Connect swivel hose by squeezing both tabs are familiar with all and placing in opening on canister. instructions and operating procedures. 2. Connect telescoping wand to handle end of hose. Twist slightly to tighten. 2. 1. 3. Connect floor nozzle or combination tool to end of telescoping wand. Twist slightly to tighten. 3a. 3b. Operations Power cord The power cord is located in the rear of the unit. Pull out th
Inhaltszusammenfassung zur Seite Nr. 6
Operations 1. 2. Special tools Floor nozzle 1. Push brush down button to clean bare floors. 2. Push brush up button to clean rugs and carpets. Brush Down Brush Up Combination crevice/dusting brush tool 1. Rotate brush portion down to use as a 1. 2. crevice tool. 2. Rotate brush portion up to use as a dusting brush. Variable suction power control The variable suction power control is located on the top of the canister. Slide the control toward the wider bars for maximum suction. S
Inhaltszusammenfassung zur Seite Nr. 7
Operations Air Flow Regulator Open the air flow regulator by sliding the button in the direction of the arrow to an open position to reduce suction for fabrics such as draperies. Close the air flow regulator by sliding the button to the closed position for full suction. Bag Change Indicator If the bag change indicator turns to a red color while you are cleaning, the dust bag needs to be replaced. The bag may appear to be full or only partially full depending upon the type of debris picke
Inhaltszusammenfassung zur Seite Nr. 8
Maintenance and care Filter Maintenance or Replacement Inlet Filter Inlet Filter 1. Unplug the vacuum from electrical outlet. 2. Open the dust bag compartment by lifting up on the latch on the door at the front of the canister. Lift out the bag holder and bag. 3. Remove filter and clean by washing in warm water with a mild detergent if desired. Allow filter to dry completely before reinstalling. If filter is torn, replace with a new filter. NOTE: The filter should be placed so the thicker
Inhaltszusammenfassung zur Seite Nr. 9
Troubleshooting W ARNING: To reduce the risk of electric shock, turn power OFF and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting. Vacuum cleaner won’t run Possible causes Remedies 1. Vacuum cleaner is not plugged in 1. Check electrical plug 2. Household fuse/circuit breaker 2. Check/replace fuse or circuit breaker Decreasing suction or no suction Possible causes Remedies 1. Floor nozzle, flexible hose, or extension wand is blocked 1. Remov
Inhaltszusammenfassung zur Seite Nr. 10
BISSELL Consumer Services For information about repairs or replacement parts, or questions about your warranty, call: BISSELL Consumer Services 1-800-237-7691 Monday - Friday 8 a.m. — 10 p.m. ET Saturday 9 a.m. — 8 p.m. ET Or write: BISSELL Homecare, Inc. PO Box 3606 Grand Rapids MI 49501 ATTN: Consumer Services Or visit the BISSELL website - www.bissell.com When contacting BISSELL, have model number of cleaner available. Please record your Model Number: ___________________ Please record yo
Inhaltszusammenfassung zur Seite Nr. 11
Replacement parts - BISSELL vacuum You may purchase parts from your retailer, by calling BISSELL Consumer Services or by visiting our website. Item Part No. Part Name 1 3210 Maintenance Kit (5 bags, 1 Inlet Filter, 1 Final Filter) 2 203-7056 Combination Crevice/Dusting Brush Tool 3 203-7059 Floor Nozzle 4 203-7057 Flexible Hose 5 203-7058 Telescoping Extension Wand 1 2 3 4 5 www.bissell.com 800.237.7691 11 ug110-4001_7100_507.indd 11 ug110-4001_7100_507.indd 11 5 5/22/07 5:01:23 PM /22/0
Inhaltszusammenfassung zur Seite Nr. 12
Warranty - BISSELL Zing™ Canister Vacuum This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact BISSELL Consumer Services by E-mail, telephone, or regular mail as described below. Limited One Year Warranty Subject to the *EXCEPTIONS AND EXCLUSIONS identified below, upon receipt of the product BISSELL Homecare,
