Inhaltszusammenfassung zur Seite Nr. 1
Use and Care & Installation Guide
30″ Vented Hood
Installation.....................................4–6
Safety Instructions...Front Cover, 2
Damper/Duct Connector .........................5
Electrical Wiring .......................................6
Filter Panel.............................................3, 5
Operating Instructions.........2, 3
Mounting Brackets...................................5
Automatic Heat Sensor ...........................3
Controls ........................................
Inhaltszusammenfassung zur Seite Nr. 2
IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING. SAFETY PRECAUTIONS CAUTION – For general ventilating use only. Do not WARNING – TO REDUCE THE RISK OF FIRE, use to exhaust hazardous or explosive materials and vapors. ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: WARNING – TO REDUCE THE RISK OF INJURY TO A. Installation work and electrical wiring must be done by PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, qualified person(s) in accordance with all applicable OB
Inhaltszusammenfassung zur Seite Nr. 3
Important Safety Instructions Operating Instructions Cleaning Automatic Heat Sensor Your hood is equipped with an automatic thermostat. If your blower is not on, or if it is running at low speed, This thermostat is a device that will turn on or speed the thermostat will sense excessive cooking heat, up the blower if it senses excessive heat above the override the normal blower control and turn the blower cooking surface. on to high speed. The blower will run until the temperature drops to normal
Inhaltszusammenfassung zur Seite Nr. 4
INSTALLATION INSTRUCTIONS This hood can easily be installed by following these TOOLS YOU WILL NEED basic steps: • Mark and cut out the cabinet bottom. Flat blade and Phillips Pencil • Secure the hood to the cabinet. screwdrivers • Mount the cabinet on the wall. • Connect the ductwork and the power cable. Duct tape Saw (saber or keyhole) Electric Drill Metal Snips (in some applications) Pliers Tape measure Wire stripper Flashlight Caulking Level PLAN THE INSTALLATION Caution: Remove the house fus
Inhaltszusammenfassung zur Seite Nr. 5
INSTALLATION INSTRUCTIONS 2. Attach the damper/duct connector. 7. Install the mounting brackets. FRONT OF HOOD Insert the bent end of the installation rod into the Use two (2) screws (provided) to attach the connector access hole in the housing. to the housing. The damper flap should open in the direction indicated by the arrow. 3. Remove the electrical knockout. Choose either the top or side of the housing for the electrical cable entrance. Remove the appropriate knockout. 4. Set the housing in
Inhaltszusammenfassung zur Seite Nr. 6
INSTALLATION INSTRUCTIONS 12. Connect the electrical wiring. Remove the wire box cover. Attach the power cable to the hood using the proper connector. Connect black to black, white to white and green or bare wire to ground screw. Replace the wire box cover. Insert two (2) screws, short or long as appropriate, through the control box and into the other mounting CAUTION: DO NOT TURN THE BREAKER bracket. Do not tighten the screws completely. ON OR INSERT THE HOUSE FUSE AT 8. Secure the hood to the
Inhaltszusammenfassung zur Seite Nr. 7
The Problem Solver Consumer Services We’ll Be There With the purchase of your new GE appliance, receive the assurance that if you ever need information or assistance from GE, we’ll be there. All you have to do is call—toll-free! ® GE Answer Center 800.626.2000 ® Whatever your question about any GE major appliance, GE Answer Center information service is available to help. Your call—and your question— will be answered promptly and courteously. And you can call any time. GE Answer ® Center servic
Inhaltszusammenfassung zur Seite Nr. 8
Staple sales slip or cancelled check YOUR 30″ HOOD here. Proof of original purchase date WARRANTY is needed to obtain service under warranty. FULL ONE-YEAR WARRANTY WHAT IS COVERED ******************************* This warranty is extended to the For one year from date of original original purchaser and any purchase, we will provide, free of succeeding owner for products charge, parts and service labor in purchased for ordinary home use in your home to repair or replace the 48 mainland states,
