Bedienungsanleitung Kenwood KDC-U546BT

Inhaltszusammenfassung zur Seite Nr. 1

KDC-U546BT
CD-RECEIVER
INSTRUCTION MANUAL


© B64-4540-00/00 (MW/M0)

Inhaltszusammenfassung zur Seite Nr. 2

Contents Before Use 3 Other Functions 18 Clock Adjustment Component names and functions 4 Demonstration Mode Setting Initial Setting General operation 5 Removing the Faceplate Before Using How to Reset Your Unit Common Operation Bluetooth Setup 20 Function Setting Operation Bluetooth Setup Music Disc/Audio File/iPod Operation 6 Registering Bluetooth Device (Pairing) Basic Operation Deleting a Registered Bluetooth Device Play function Registering PIN Code All Random Displaying the Firmware Versio

Inhaltszusammenfassung zur Seite Nr. 3

Before Use 2WARNING Notes • If you experience problems during installation, To prevent injury or fire, take the following consult your Kenwood dealer. precautions: • When you purchase optional accessories, check with To prevent a short circuit, never put or leave any your Kenwood dealer to make sure that they work metallic objects (such as coins or metal tools) inside with your model and in your area. the unit. • The characters which can be displayed by this unit are A-Z 0-9 @ “ ‘ ` % & *

Inhaltszusammenfassung zur Seite Nr. 4

Component names and functions 1 2 3 4 5 15 14 13 12 11 10 9 8 7 6 1 Release button p [4] / [¢] button The faceplate of the unit can be detached and To select a station, song and setting items. taken with you, helping to deter theft. Refer to q Microphone (page 19). The microphone for the hands free phone is built 2 [SRC] button in. When your voice cannot be recognized due To turn on this unit and select the Source. to the low microphone volume, noises or echo To tur

Inhaltszusammenfassung zur Seite Nr. 5

General operation Before Using Function Setting Operation The basic operating procedure for using this Exit of the Demonstration Mode function is described below. The individual function Turn off the demonstration mode when you use it items are covered in the operating procedures. for the first time after installation. 1 Select the source 1 Press the [VOL] knob to quit the demonstration Press the [SRC] button. mode when the messages “CANCEL DEMO” and Function items vary from source to sourc

Inhaltszusammenfassung zur Seite Nr. 6

Music Disc/Audio File/iPod Operation [SRC] [VOL] Disc slot [ ] CA-U1EX • CA-U1EX (optional accessory) is required to connect a USB device. • KCA-iP101 (optional accessory) is required to connect an iPod. [ ] [ ][BAND] [ ] / [ ] [1] — [6] USB Terminal Basic Operation Play function Playing Disc Scan play Insert a disc into the disc slot (label side up). Press the [2] button. When inserted, the source is switched Successively plays the intro of the music in the disc automatically and

Inhaltszusammenfassung zur Seite Nr. 7

Function of iPod Cancelling the Music Search mode Press the [ ] button for at least 1 second. All Random ⁄ All songs in iPod are played at random. • Skip Search: The number of songs to be skipped is Press the [3] button for at least 1 second. determined by the ratio of the total number of songs in Pressing the button toggles the setting between the list which is selected. Set the ratio with “SKIP SEARCH” All random play on (“ALL RANDOM”) and off of

Inhaltszusammenfassung zur Seite Nr. 8

Music Disc/Audio File/iPod Operation Function of iPod You can select the song to play by referring to (page 7). Alphabet Search 2 Register the song You can select a song by alphabet. This function Press the [5] button for at least 2 seconds. searches songs whose name contain the specified “## STORED (Registration number)” is displayed. character(s) in the list of the selected browse item You can register up to 10 songs. (artist, album, etc.). ⁄ 1 Enter Music Search

Inhaltszusammenfassung zur Seite Nr. 9

Function of remote control Audio File/ iPod Setting Direct Music Search You can select following setting items. Searching the music by entering the track number. 1 Enter Function Setting mode Press the [VOL] knob for at least 1 second. 1 Enter Direct Music Search mode “FUNCTION” is displayed. Press the [DIRECT] button. 2 Select the function item 2 Enter the music number Turn the [VOL] knob and press it when the Press the number buttons. desired item is displayed. 3 Search the music Select “SETT

Inhaltszusammenfassung zur Seite Nr. 10

Tuner Operation Tuner Setting [SRC] [VOL] You can select following Tuner Setting items. 1 Select the TUNER source Press the [SRC] button. Select the “TUNER” display. 2 Enter Function Setting mode Press the [VOL] knob for at least 1 second. [BAND] [ ] / [ ] — [ ] [1] [6] “FUNCTION” is displayed. 3 Select the function item Basic Operation Turn the [VOL] knob and press it when the desired item is displayed. Selecting Tuner source Select “SETTINGS” > Function item. Press the [SRC] button.

Inhaltszusammenfassung zur Seite Nr. 11

Function of remote control Direct Access Tuning Tuning in a desired radio station by entering the frequency. 1 Enter Direct Access Tuning mode Press the [DIRECT] button. “– – – –” is displayed. 2 Enter the frequency Press the number buttons. Example: Desired frequency Press button 92.1 MHz (FM) [9], [2], [1] 810 kHz (AM) [8], [1], [0] 3 Tune in to entered the frequency Press the [4] or [¢] button. Cancelling Direct Access Tuning Press the [ ] button. ⁄ • You can enter the FM band frequency in

Inhaltszusammenfassung zur Seite Nr. 12

Operation of Hands-Free Phoning ⁄ [SRC] [VOL] • When registering from this unit. Refer to (page 21). • For details on the Bluetooth cell-phone with the hands- free function, see (page 29). Making a Call [1] — [6] [ ] [ ][BAND] [ ] / [ ][VOICE] You can select following dialing method. Connecting a Bluetooth Device 1 Enter Bluetooth mode Press the [VOL] knob. Before use the Bluetooth device, you need to “BT MODE” is displayed. c

Inhaltszusammenfassung zur Seite Nr. 13

3 Select the name 3 Make a call • Press the [VOL] knob. Operation type Operation • Press the [OK] button on the remote Move to the next phone Turn the [VOL] knob. controller. number. Move to the next name. Press the [4] or [¢] button. ⁄ • You can input max 25 digits. 4 Make a call Press the [VOL] knob. ⁄ Make a Voice Dialing Call • To use the Phone Book, it must be downloaded to this unit in advance. Refer to (page 22). Press the [

Inhaltszusammenfassung zur Seite Nr. 14

Operation of Hands-Free Phoning Speed Dialing (Preset Dial) Call Waiting 1 Select the number you want to recall from the Answering Another Incoming Call with the memory Current Call Suspended Press the [1] – [6] button. 1 Press the [VOL] knob. 2 Make a call 2 Turn the [VOL] knob and press it when the Press the [VOL] knob. desired item is displayed. Select “ANSWER” . ⁄ • You need to register the preset dial number. Answering another Incoming Call after Terminating the Current Call Press the [S

Inhaltszusammenfassung zur Seite Nr. 15

Audio Adjustments “SUB-W LEVEL” You can set subwoofer level. [SRC] [VOL] –15 — 0 — +15 “DETAILED SET” Move to detailed item “LPF SUBWOOFER” Selects cut off frequency of subwoofer output. 85/120/160/THROUGH (OFF) Hz “SUB-W PHASE” Selects the phase of subwoofer output. REVERSE (180°)/ NORMAL (0°) “SUPREME SET” Turns on/off the supreme function. OFF/ON [ ] “VOLUME OFFSET” Sets each source’s volume as a difference from the basic volume. –8 — 0 (AUX: –8 —0 — +8) Audio Control (Factory settin

Inhaltszusammenfassung zur Seite Nr. 16

Display Settings 4 Exit Function Setting mode [SRC] [VOL] Press the [ ] button for at least 1 second. ⁄ • When you select the clock display, the display setting of each source will be changed to the clock display. • If the selected display item does not have any information, alternative information is displayed. • When selecting “FOLDER NAME” while playing with [ ] [VOICE] iPod, names will be displayed depending on currently selected browsing items. • If the iPod Control by Hand Mode i

Inhaltszusammenfassung zur Seite Nr. 17

Display Setting Auxiliary Input Display Setting You can select following Display Setting items. Selecting the display when changing to Auxiliary input source. 1 Enter Function Setting mode Press the [VOL] knob for at least 1 second. 1 Select the AUX source “FUNCTION” is displayed. Press the [SRC] button. Select the “AUX” display. 2 Select the function item Turn the [VOL] knob and press it when the 2 Enter Function Setting mode desired item is displayed. Press the [VOL] knob for at least 1 secon

Inhaltszusammenfassung zur Seite Nr. 18

Other Functions Release button 3 Set the Demonstration mode [SRC] [VOL] Turn the [VOL] knob and press it when the desired item is displayed. Select “ON” or “OFF” . 4 Exit Function Setting mode Press the [ ] button for at least 1 second. [ ] Initial Setting You can select following Initial Setting items. Clock Adjustment 1 Select the Standby source 1 Select the source Press the [SRC] button. Press the [SRC] button. Select the “STANDBY” display. 2 Enter Function Setting mode 2 Enter Func

Inhaltszusammenfassung zur Seite Nr. 19

“CD READ” Sets the method for reading CD. Removing the Faceplate 1: Automatically distinguishes between audio file The faceplate of the unit can be detached and taken disc and music CD when playing disc. with you, helping to deter theft. 2: Forces playing as music CD. “SWITCH PREOUT” Switches the preout between rear output (“REAR”) Detach the faceplate and subwoofer output (“SUB-W”) REAR/SUB-W Press the Release button. “SP SELECT” Fine-tuning so that the System Q value is optimal Reattachi

Inhaltszusammenfassung zur Seite Nr. 20

Bluetooth Setup “AUTO ANSWER” This function automatically answers (responds [SRC] [VOL] to) a call after lapse of the preset time interval for automatic answer. OFF: Does not answer the phone call automatically. 0: Automatically answers the phone call at once. 1 – 8 –99: Automatically answers the phone call after lapse of 1 – 99 seconds. “BT SP SELECT” You can specify the audio output speakers. [ ] / [ ] [ ] [ ] Select the speaker which is further from the microphone in or