Bedienungsanleitung Metra Electronics 99-7500

Inhaltszusammenfassung zur Seite Nr. 1

INST 7500
KIT COMPONENTS
6
Radio
Fig. A
Housing #1
Fig. C
99-7500
DW-7501
INSTALLATION
Radio
Housing #2
INSTRUCTIONS
Trimplate
APPLICATIONS
Fig. B
CAR PAGE
Filler Bar
MAZDA
Fig. E
323 1986-89*...............................................................................1
(8) 3/8" Phillips
323 1990-94*...............................................................................1
Screws
Fig. D
626 (models w/factory receiver/tape deck/eq/pocket) 1986-9

Inhaltszusammenfassung zur Seite Nr. 2

3b MAZDA 323 1986-89 Fig. A 1 2 "E" "E" DIN HEAD UNITS: For models using Radio Housing #1, cut and remove the shaft supports. Slide the DIN cage into the Housing and secure by bending the metal locking tabs down. Slide Disconnect the negative battery terminal to Cut and remove all mounting tabs on Radio the aftermarket head unit into the cage until secure. (see Fig. A) prevent an accidental short circuit. Remove Housing #2 EXCEPT tabs "E". The the ashtray and (2) screws exposed in t

Inhaltszusammenfassung zur Seite Nr. 3

MAZDA RX-7 1986-91 MAZDA 626 / MX6 1986-92 (models equipped with factory receiver/pocket) 1 2 "A" 1 2 "A" "A" "A" "E" "E" "A" "A" Disconnect the negative battery terminal to prevent an accidental short circuit. Remove Cut and remove all mounting tabs on Radio the ashtray and (2) screws exposed in the Housing #1 EXCEPT tabs "A". The mounting tabs can be identified by the Disconnect the negative battery terminal to Cut and remove all mounting tabs on Radio ashtray cavity. Unsnap the gear

Inhaltszusammenfassung zur Seite Nr. 4

MAZDA 929 1988-91 MAZDA Miata 1990-99 1 2 1 2 "A" "A" "A" "A" "A" "A" "A" "A" "A" "A" "A" "A" Disconnect the negative battery terminal to Cut and remove all mounting tabs on Radio Disconnect the negative battery terminal to Cut and remove all mounting tabs on Radio prevent an accidental short circuit. Reach Housing #1 EXCEPT tabs "A". The prevent an accidental short circuit. Remove Housing #1 EXCEPT tabs "A". The behind the console and remove (2) nuts mounting tabs can be identified by