Inhaltszusammenfassung zur Seite Nr. 1
OWNER'S
MANUAL
MODEL NO.
625.384650
Caution:
Read and Follow
All Safety Rules,
DELUXE DUAL-STAGE
Installation and
Operating
DRINKING WATER SYSTEM
Instructions
Before First Use
of This Product.
• Safety Guides
If you have questions
• Installation
when installing and using
• Operation
your drinking water filter
system, call this toll-free
• Cartridge Replacement
number...
• Repair Parts
1 - 800 - 426 - 9345
www.KenmoreWater.com
System tested and certified by NSF International to
ANSl/NSF Standard
Inhaltszusammenfassung zur Seite Nr. 2
SAFETY GUIDES / SPECIFICATIONS low their guides as you install the system. Follow • Read all steps and guides carefully before instal- ling and using your undersink drinking water filter your local codes if they differ with guides in this system. Follow all steps exactly to correctly install. manual. In Massachusetts, plumbing codes of Massachusetts shall be adhered to. Consult with Reading this manual will also help you to get all the benefits from the undersink drinking water filter your licen
Inhaltszusammenfassung zur Seite Nr. 3
TABLE OF CONTENTS Parts of the System / Typical Installation Drawing / Tools and Materials Needed ................................................ 4 Drinking Water Filter System Installation ........................... 5 - 7 Installing Supply Fitting ..................................... 5 Installing Faucet ............................................ 5 - 6 Making Tubing Connections .................................. 7 Using the Filtered Water System ................................... 8 Filter
Inhaltszusammenfassung zur Seite Nr. 4
PARTS OF THE SYSTEM MATERIALS AND TOOLS NEEDED • plumbers putty filter system assembly including mounting brack- • Phillips screwdrivers et and screws • pliers and adjustable jaw wrench • tubing cutter water supply fitting • pipe joint compound or Teflon tape filtered water faucet for sink or countertop mount- • electric drill and 1" drill bit if mounting hole is ing needed for the faucet, see page 6 3/8" tubing to make all needed connections CAUTION: To avoid damaging the sink, consult a qualif
Inhaltszusammenfassung zur Seite Nr. 5
INSTALLATION STEPS STEP 1 - COLD WATER SUPPLY FITTING Check and comply with local plumbing codes as you plan, then install a cold feed (supply) water fitting. The fitting must provide a leak- tight connection to the water filter 3 / 8" tubing. A typical connection using the in- cluded water supply fitting is shown in FIG.2 - A. An optional connection using standard plumbing fittings (not included), is shown in B. A. WATER SUPPLY FITTING B. OPTIONAL PIPE FITTINGS (compression type shown) 1. Close
Inhaltszusammenfassung zur Seite Nr. 6
INSTALLATION STEPS STEP 2 - MAKE HOLE FOR FILTERED in porcelain or stainless steel. Special drill bits are made for this. WATER FAUCET Select one of the following places to install the faucet. 2. Place plumbers putty around the drilled hole to Be sure there's room underneath so you can make prevent water leaks around the faucet. the needed connections. -- In an existing sink spray attachment hole. FIG. 3 .... .... 1" to 1- 1/4" -- Drill a hole in the sink top. diameter hole - - Drill a hole in t
Inhaltszusammenfassung zur Seite Nr. 7
INSTALLATION STEPS STEP 4 - MAKE TUBING CONNECTIONS To Disconnect Tubing, FIG. 5 - B: Push the collet in- ward and hold with a finger while pulling the tubing 1. Allowing some slack, measure and cut a length of out. 3/8" tubing to connect between the supply fitting and the filter system inlet, FIG. 1. Cut the ends of the tubing square. FIG. 5 - A Tubing correctly cut and connected 2. Insert tubing all the way into the supply fitting and inlet fitting. Pull on the tubing to be sure that it's held
Inhaltszusammenfassung zur Seite Nr. 8
USING THE SYSTEM The sink or countertop faucet has a hand operated knob to access drinking water. Turning the knob to faucet the left opens the faucet, turning to the fight shuts off Z filtered water the faucet. FAUCET ELECTRONICS only"AA" alkalinebatteries. Improper placement of batteries could damage electronics. Use care when The Undersink Drinking Water Filter will monitor inserting batteries to align them correctly in man- the total water flow of the unit and also length of time ifold with
Inhaltszusammenfassung zur Seite Nr. 9
FILTER CARTRIDGE REPLACEMENT CAUTION: Never remove sumps with water pres- to relieve pressure in the system. sure in the filter system. 2. Turn the sump off of the filter head, to the left or 1. Close the water supply shut-off valve (FIG. 1, clockwise 1/4 turn. Be careful, the sump is full of wa- page 4) to the filter. Open the filtered water faucet ter. Do not lose the large o-ring seal. FIG. 6 ca_ridge head S o-ring seal TURN TURN SUMP SUMP COUNTER- CLOCKWISE CLOCKWISE TO REMOVE TO TIGHTEN Fil
Inhaltszusammenfassung zur Seite Nr. 10
REPAIR PARTS Kenmore Deluxe Dual-Stage Drinking Water System, Model No. 625.384650 7 I _6 5 2 1 lO
Inhaltszusammenfassung zur Seite Nr. 11
REPAIR PARTS LIST KEY PART DESCRIPTION NO. NUMBER 1 7221128 Sump (2 req.) 2 7223633 O-Ring (2 req.) 3 42-38466 Filter, Carbon Block (2 Pack) 4 9006062 Screw (2 req.) 5 9041700 Hanger Washer (2 req.) 6 7234210 Paddlewheel & O-Ring Kit 7 7234228 Paddlewheet Cover & Screw Kit 8 7234252 Rep'l Pwa (includes screw) 9 7234286 Cover, Manifold 10 7226495 Faucet 11 7228536 Feed Supply Fitting _1, 7157280 Tubing, 3/8" x 20' - white 41, 7227467 Owners Manual _1, not illustrated 11
Inhaltszusammenfassung zur Seite Nr. 12
UNDERSINK DRINKING OWNERS WATER FILTER MANUAL SYSTEM For the repair or replacement parts you need Call 7 am - 7 pm, 7 days a week MODEL NO. 1 - 800 - 366 - PART 625.384650 (1 - 800 - 366 - 7278) For in-home major brand repair service Call 24 hours a day, 7 days a week 1 - 800 - 4 - REPAIR The model number of (1 - 800 - 473 - 7247) your drinking water filter system is found on the rating decal, located on the back of the post filter. For the location of a Sears Repair Service Center in your area
