Inhaltszusammenfassung zur Seite Nr. 1
1
Remote Vehicle Control System
TM
CA-630
Owner's Manual
Car Start, Security and
Convenience System
IMPORTANT NOTE: The operation of the IV-F65 as described in this manual is applicable
to most vehicles. However, due to the engine type and configuration of some vehicles (i.e.
diesel engines), some functions AND/OR SAFETY PRECAUTIONS may not apply. Please
see your installing dealer for more information.
Inhaltszusammenfassung zur Seite Nr. 2
2 Table of Contents Features and Benefits of the CODE ALARM CA-630 ............... 3 Note: Any feature or function noted with “optional” requires additional installation labor, components and installation cost. See your dealer for details. Using the Security features ................................................... 4/5 Arming the Security System Pre-arm Mode Disarming the Security System Attempted Intrusion Identification Two-Stage Door Unlock Activating the Tru
Inhaltszusammenfassung zur Seite Nr. 3
3 Features and Benefits of the Code Alarm CA-630 Two Easy-to-Use Weather-Resistant Remote Controls The remote controls included with the Code Alarm CA-630 utilize durable, moisture resistant cases and sealed rubber buttons for reliability and long life. Rolling code technology prevents the transmitter signals from being duplicated. The button functions are clearly labeled to make the CA-630 simple to operate. All Entrances Protected Opening any door or entrance protected by the security syst
Inhaltszusammenfassung zur Seite Nr. 4
4 Using the Security and Keyless Entry features UNLOCK Button Press to Disarm Security System and Unlock Doors LOCK Button Press Twice for Two- Press to Arm Security Stage Door Unlock* System and Lock Press and Hold to Open Doors Trunk FIND/PANIC Button START Button Press for Car Finder Press and Hold for Press and Hold for Remote Start / Stop Panic Alarm Press to Activate Rear Defroster Arming the Security System To arm the system, exit the vehicle, close all doors, then press* the † LOCK
Inhaltszusammenfassung zur Seite Nr. 5
5 Using the Security and Keyless Entry features (cont.) Activating Trunk Release Feature (vehicle must have power trunk/hatch) Press and hold the UNLOCK button for 2 seconds to open the vehicle trunk or hatch. Using the Progressive Car Finder Feature Press the FIND/PANIC button on the remote control to locate your vehicle. The horn will emit five short chirps at low volume, increasing in volume each of three times the button is pressed. Personal Protection Alarm (Panic) Press and hold the FIND/P
Inhaltszusammenfassung zur Seite Nr. 6
6 Using Valet / Service Mode You can turn off all remote start and Security functions by engaging the Valet/Service Mode: To engage Valet/Service mode, turn the ignition key to the ON position (last position before start) and press the LOCK and UNLOCK buttons on the remote control simultaneouly. If installed, the blue status light will blink to indicate Valet mode To disengage Valet/Service mode, turn the ignition key to the ON position (last position before start) and press the LOCK and UN
Inhaltszusammenfassung zur Seite Nr. 7
7 Using Your Remote Starter (cont’d) Entering the Vehicle While It is Running via Remote Start 1.Press the UNLOCK button on the remote control to unlock the vehicle’s door(s) and turn off the alarm system (if it is not already off). 2.Enter the vehicle. Do not press the brake pedal. 3. Insert the key into the ignition and turn to the ON position. 4. Press the brake pedal. The remote starter disengages and the vehicle will operate normally. Remote Start Safety Features TM For safety and sec
Inhaltszusammenfassung zur Seite Nr. 8
8 Automatic Convenience Options The CA-630 performs a variety of automatic functions to enhance security and comfort. Some of these features are programmable at the time of installation. Please see your installer for further details. Illuminated Entry When the alarm system is disarmed, the vehicle courtesy lights will turn on for 1 minute, or until the vehicle is started or the system is re-armed. Illuminated Exit When removing the key from the ignition, the vehicle courtesy lights will turn on
Inhaltszusammenfassung zur Seite Nr. 9
9 System Maintenance Changing the Remote Control Battery The 12-volt alkaline battery supplied in your remote transmitter should last approximately one year, depending on usage. When the battery begins to weaken, you will notice a decrease in range, or the distance from your vehicle that your remote transmitter will operate. Follow the instructions below to change the remote transmitter battery. Open Back of Remote Transmitter 1. Using a coin pry off the back of the transmitter (the transmitter
Inhaltszusammenfassung zur Seite Nr. 10
10 System Maintenance (cont.) Deleting Lost or Stolen Remote Controls from Your System If one of your remote controls is lost or stolen, follow these instructions IMMEDIATELY to remove the control code from your system. 1. Have all remaining remote controls available. 2. Enter the control programming mode by following steps 1 - 5 of Adding Remote Controls to Your System (page 8). 3a. If you have only one remaining remote control, press the LOCK button on that remote control eight (8) times, paus
Inhaltszusammenfassung zur Seite Nr. 11
11 Emergency Disarm Procedure If your remote control is lost or fails to function, use this procedure to disarm the CA-630 and start your vehicle. 1. Use the keys to enter the vehicle. The alarm will sound once the door is opened. 2. Insert the key into the ignition and turn to the ON position. 3. Locate and press the emergency override button. The alarm will turn off and then you will be able to start your vehicle. Your Emergency Disarm Button is located: Installer Programmed Options Ignition O
Inhaltszusammenfassung zur Seite Nr. 12
12 Code Systems, Inc. Limited Lifetime Warranty Code Systems Inc. (“CODE”) warrants to the ORIGINAL PURCHASER of this CODE vehicle security product (the “Product”), purchased from an authorized CODE dealer, that (except as provided below) should this Product under normal use and conditions, be proven defective in material or workmanship DURING THE LIFETIME OF THE VEHICLE IN WHICH IT WAS ORIGINALLY INSTALLED, such defect(s) will be repaired or replaced (at CODE’s option) without charge for parts
Inhaltszusammenfassung zur Seite Nr. 13
13 Code Systems, Inc. Theft Protection Guarantee The Theft Protection Program is designed to provide the retail pur- chaser of a security system provided by CODE-ALARM, INC. (“CODE”) an additional benefit, at no additional cost to the purchaser, should their vehicle be stolen while protected by a CODE-ALARM security system. While CODE has created this program as a way of showing appreciation to its customers, CODE RESERVES THE RIGHT TO UNILATERALLY CHANGE, ALTER, MODIFY, OR DISCONTINUE ALL OR PA
Inhaltszusammenfassung zur Seite Nr. 14
14
