Inhaltszusammenfassung zur Seite Nr. 1
GEAppliances.com
Safety Instructions . . . . . . . . . . .2, 3
Owner’s Manual and
Installation Instructions
Operating Instructions
Additional Features . . . . . . . . . . . . . . . . .8
Models 21 and 25
Automatic Icemaker . . . . . . . . . . . . . . .11
Care and Cleaning . . . . . . . . . . . . .12, 13
Controls . . . . . . . . . . . . . . . . . . . . . . . . . .4, 5
Congélateur inférieur
Crispers and Pans . . . . . . . . . . . . . . . . . . .9
Freezer . . . . . . . . . . . . . . . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 2
IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING. WARNING! Use this appliance only for its intended purpose as described in this Owner’s Manual. SAFETY PRECAUTIONS When using electrical appliances, basic safety precautions should be followed, including the following: n This refrigerator must be properly installed n In refrigerators with automatic icemakers, avoid n n and located in accordance with the Installation contact with the moving parts of the ejector Instructions before i
Inhaltszusammenfassung zur Seite Nr. 3
Installation Safety Instructions Operating Instructions Troubleshooting Tips Consumer Support Instructions GEAppliances.com WARNING! HOW TO CONNECT ELECTRICITY Do not, under any circumstances, cut or remove the third (ground) prong from the power cord. For personal safety, this appliance must be properly grounded. The power cord of this appliance is equipped This provides the best performance and also prevents with a 3-prong (grounding) plug which mates overloading house wiring circuits which c
Inhaltszusammenfassung zur Seite Nr. 4
About the controls with temperature settings. (on some models) (on some models) NOTE: The refrigerator is shipped with protective film covering the temperature controls. If this film was not removed during installation, remove it now. The temperature controls are preset in the factory at 37°F for the refrigerator compartment and 0°F for the freezer compartment. Allow 24 hours for the temperature to stabilize to the preset recommended settings. The temperature controls can display both the SET t
Inhaltszusammenfassung zur Seite Nr. 5
Installation Safety Instructions Operating Instructions Troubleshooting Tips Consumer Support Instructions ™ About TurboCool. (on some models) GEAppliances.com How it Works TurboCool rapidly cools the refrigerator How to Use compartment in order to more quickly Press TurboCool. The refrigerator cool foods. Use TurboCool when adding a temperature display will show . large amount of food to the refrigerator After TurboCool is complete, the compartment, putting away foods after they refrigerator
Inhaltszusammenfassung zur Seite Nr. 6
About the water filter. (on some models) Water Filter Cartridge Filter Bypass Plug The water filter cartridge is located in the You must use the filter bypass plug when a back upper right corner of the refrigerator replacement filter cartridge is not available. compartment. The icemaker will not operate without the filter or filter bypass plug. When to Replace the Filter Replacement Filters: There is a replacement indicator light for the To order additional filter cartridges water filter cartri
Inhaltszusammenfassung zur Seite Nr. 7
Installation Safety Instructions Operating Instructions Troubleshooting Tips Consumer Support Instructions About the shelves and bins. GEAppliances.com Not all features are on all models. Rearranging the Shelves Shelves in the refrigerator compartment are adjustable. Refrigerator Compartment To remove: Remove all items from the shelf. Tilt the shelf up at the front. Lift the shelf up at the back and bring the shelf out. Some models have wire shelves that can be adjusted in the same manner. To r
Inhaltszusammenfassung zur Seite Nr. 8
About the shelves and bins. Adjustable Bins on the Door Adjustable bins can easily be carried from The snugger helps prevent tipping, spilling refrigerator to work area. or sliding of small items stored on the door shelf. Grip the finger hold near the rear of the To remove: Lift bin straight up, then snugger and move it to fit your needs. pull out. To replace or relocate: Slide in the bin just above the molded door supports, and push down. The bin will lock in place. Non-Adjustable Bins on the
Inhaltszusammenfassung zur Seite Nr. 9
Installation Safety Instructions Operating Instructions Troubleshooting Tips Consumer Support Instructions About the crispers and pans. GEAppliances.com Not all features are on all models. Fruit and Vegetable Crisper Excess water that may accumulate in the bottom of the drawers or under the drawers should be wiped dry. Adjustable Humidity Crisper (on some models) Slide the control all the way to the Slide the control all the way to the LOW HIGH setting to provide high humidity setting to provide
Inhaltszusammenfassung zur Seite Nr. 10
About the freezer. Not all features are on all models. Freezer Shelves and Baskets A shelf above the ice storage bin A half-width basket A deep full-width basket with divider Appearance and features may vary Basket Removal To remove the deep full-width basket: When replacing the deep full-width basket: Open the freezer drawer until it stops. Tilt the basket toward you and lower it into the drawer. Lift the freezer caddy up. Place the basket onto the metal slide Pull the divider forward until t
Inhaltszusammenfassung zur Seite Nr. 11
Installation Safety Instructions Operating Instructions Troubleshooting Tips Consumer Support Instructions About the automatic icemaker. GEAppliances.com A newly installed refrigerator may take 12 to 24 hours to begin making ice. Power Automatic Icemaker (on some models) Switch Icemaker The icemaker will produce seven cubes You will hear a buzzing sound each time per cycle—approximately 100–130 cubes the icemaker fills with water. in a 24-hour period, depending on freezer Throw away the first f
Inhaltszusammenfassung zur Seite Nr. 12
Care and cleaning of the refrigerator. Cleaning the Outside The door handles and trim. Clean with a The stainless steel panels and door cloth dampened with soapy water. Dry with handles. a soft cloth. Do not use wax on the door Stainless steel (on some models) can be handles and trim. cleaned with a commercially available stainless steel cleaner. A spray-on stainless Keep the outside clean. Wipe with a clean steel cleaner works best. cloth lightly dampened with kitchen appliance wax or mild liq
Inhaltszusammenfassung zur Seite Nr. 13
Installation Safety Instructions Operating Instructions Troubleshooting Tips Consumer Support Instructions GEAppliances.com Behind the Refrigerator Be careful when moving the refrigerator Lower the leveling legs until they touch away from the wall. All types of floor the floor. coverings can be damaged, particularly When pushing the refrigerator back, make cushioned coverings and those with sure you don’t roll over the power cord or embossed surfaces. icemaker supply line (on some models) and
Inhaltszusammenfassung zur Seite Nr. 14
Replacing the light bulbs. Turning the control to the 0 (off) position does not remove power to the light circuit. Refrigerator Lights After replacing with an appliance bulb CAUTION: Light bulbs may of the same or lower wattage, replace be hot. the shield. Unplug the refrigerator. Plug the refrigerator back in. To remove the light shield, grasp the NOTE: Appliance bulbs may be ordered from shield at the back and pull out to release GE Parts and Accessories, 800.626.2002. the tabs at the back.
Inhaltszusammenfassung zur Seite Nr. 15
Installation Safety Instructions Operating Instructions Troubleshooting Tips Consumer Support Instructions Trim kits and decorator panels. For panel required models Read these instructions completely and carefully. Before You Begin Some models are equipped with trim kits that allow you to install door panels. You can order pre-cut black or white decorator panels from GE Parts and Accessories, 800.626.2002, or you can add wood panels to match your kitchen cabinets. Panels less than 1/4 (6 mm)
Inhaltszusammenfassung zur Seite Nr. 16
Trim kits and decorator panels. 3/4 (19 mm) or Raised Panel A raised panel design screwed or glued to a 1/4 (6 mm) thick backing, or a 3/4 (19 mm) routed board can be used. The raised portion of the panel must be fabricated to permit clearances of at least 2 (5.1 cm) from the handle side for fingertip clearance. Panels thicker than 1/4 (6 mm), up to 3/4 (19 mm) max., will require that the outer 5/16 (8 mm) of panel perimeter be no thicker than 1/4 (6 mm). Weight limitations for custom pa
Inhaltszusammenfassung zur Seite Nr. 17
Installation Refrigerator Instructions Models 21 and 25 Questions? Call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com In Canada, call 1.800.561.3344 or visit our Website at: www.GEAppliances.ca BEFORE YOU BEGIN MATERIALS YOU MAY NEED (not included) Read these instructions completely and carefully. • IMPORTANT — Save these instructions for local inspector’s use. Lag Bolts Anchor Sleeves • IMPORTANT — Observe all governing codes and ordinances. Drill Bit Appropriate for Anc
Inhaltszusammenfassung zur Seite Nr. 18
Installation Instructions INSTALLING THE ANTI-TIP FLOOR BRACKET (on 21 ft. models) LOCATING THE ANTI-TIP 2 WARNING FLOOR BRACKET Place the anti-tip floor bracket locator template A (included inside the anti-tip kit) onto the floor up against the rear wall, within W, and in line with the desired location of the RH side of the Under certain circumstances, this refrigerator refrigerator (see Figure 1). can tip forward. Injury to persons can result. Figure 1 – Installation Overview Install Anti-Ti
Inhaltszusammenfassung zur Seite Nr. 19
Installation Instructions 2 LOCATING THE ANTI-TIP CONCRETE Wall and Floor Construction: B • Anchors required (not provided): FLOOR BRACKET (cont.) 4 each 1/4” x 1 1/2” lag bolts Figure 2 – Acceptable Screw Placement 4 each 1/2” O.D. sleeve anchors Locations • Drill the recommended size holes for the anchors into the concrete at the center of the Preferred Installation – Preferred Installation – holes marked in Step 2. Wood Concrete • Install the sleeve anchors into the drilled holes. Place th
Inhaltszusammenfassung zur Seite Nr. 20
Installation Instructions INSTALLING THE REFRIGERATOR REMOVE TOP CAP (cont.) (on some models) REFRIGERATOR LOCATION • Do not install the refrigerator where the temperature will REINSTALL DOORS, DRAWERS AND TOP CAP go below 60°F (16°C) because it will not run often enough Carefully lower the door onto the center hinge. Reinstall E to maintain proper temperatures. top hinge. NOTE: Ensure the door is properly aligned to • Do not install the refrigerator where the temperature will the case top to av
