Inhaltszusammenfassung zur Seite Nr. 1
A 7 A
o n l a ) 4 2 s l a ,7 sa a l
semana d a d a hora Cliente LG(Atenci Servici
SERVICE CUSTOMER LG FOR WEEK DAYS DAY, HOURS 24
Inhaltszusammenfassung zur Seite Nr. 2
Table of Contents Introduction Entry 3 Important Safety Instruction 3 Identification of Parts 6 Where to Locate 7 Installation Door Removal 8 Door Replacement 9 Water Pipe Installation 9 Water Connection Instruction Guide 10 Operation Instruction Guide 12 Height Adjustment 14 Starting 15 Operation Adjusting the Temperatures and functions 15 (Dispenser/Automatic Icemaker) 21 Shelf 21 Wine Holder (Applicable to some models only) Egg Bin (Applicable to some models only) 22 22 Humidity Control in th
Inhaltszusammenfassung zur Seite Nr. 3
Introduction 3
Inhaltszusammenfassung zur Seite Nr. 4
4
Inhaltszusammenfassung zur Seite Nr. 5
Introduction 5
Inhaltszusammenfassung zur Seite Nr. 6
Introduction Identification of Parts Freezer Refrigerator Compartment Compartment Dairy Corner Water Filter Lamp Shelf Door Rack Automatic Icemaker Wine holder Lamp Shelf Snack Drawer Shelf Egg Box (steel or glass) Lamp Jet Freezing Door Rack Vegetable Drawer Door Rack Drawer Optichill Door Rack Lower Cover NOTE • If you find some parts missing from your unit, they may be parts only used in other models. (i.c. the Optichill is not included in all models) 6 6
Inhaltszusammenfassung zur Seite Nr. 7
Introduction Where to Locate 1. Place your appliance where it is easy to use. Select a Good Location 2. Avoid placing the unit near heat sources, direct sunlight, or moisture. 3. To avoid vibrations, the appliance must be leveled. 4. Do not install this refrigerator in areas where the ambient temperature is below 41°F. It will have an adverse effect on performance. 5. Allow the clearance of at least 2 inch from the ceiling and 1 inch from the side walls for better cooling efficiency, ease of ins
Inhaltszusammenfassung zur Seite Nr. 8
Installation Door removal Warning Electric Shock Hazard Disconnect electrical supply to refrigerator before installing. Failure to do so could result in death or serious injury. If your entrance door is too narrow for the refrigerator to pass through, remove the Lower Cover refrigerator door and pass the refrigerator laterally. Remove Lower Remove the lower cover by lifting upward, and Cover and then pull up the water feed tube while pressing Water Feed Tube area shown in the figure to the
Inhaltszusammenfassung zur Seite Nr. 9
Installation Move the Push the refrigerator sideways through the Refrigerator entrance door as shown in the right picture. 5 4 3 2 T FR E M 1 Z P M i n T R 1 EF 2 3 4 5 E M P Door replacement Mount the doors in the reverse order of removal after the refrigerator is brought to the installation area. Feed water tube installation 2 Before Automatic icemaker operation needs water pressure of 21.3~121psi(lb/inch ) (That Installation is, a 7oz. paper cup will be filled within 3 sec.). 2 If water p
Inhaltszusammenfassung zur Seite Nr. 10
Installation Water Connection Instruction Guide Connecting Read all directions carefully before you begin. the Refrigerator to a Water Source Warning Connect to potable water supply only. IMPORTANT • If operating the refrigerator before installing the water connection, turn icemaker to the OFF position to prevent operation without water. • All installations must be in accordance with local plumbing code requirements. • Use copper tubing and check for leaks. • Install copper tubing only in area
Inhaltszusammenfassung zur Seite Nr. 11
Installation Connect 1. Unplug refrigerator or disconnect power. the Tubing to 2. Turn OFF main water supply. Turn on the nearest faucet to relieve the pressure Water Line on the line. It may help to open an outside faucet to allow the water to drain from the line in the house. 3. Find a 1/2-inch to 1-1/4-inch vertical COLD water pipe near the refrigerator. NOTE • Horizontal pipe will work, but the following precaution must be taken: Drill on the top of the pipe, not the bottom. This will help
Inhaltszusammenfassung zur Seite Nr. 12
Installation Operation Instruction Guide Connect the Tubing Before making the connection to the refrigerator, be sure the refrigerator to the Refrigerator power cord is not plugged into the wall outlet. • If your refrigerator does not have a water filter, we " recommend installing one. If your water supply has sand or particles that could clog the " screen of the refrigerator’s water valve. Install the filter in the water line near the refrigerator. 1. Remove the plastic flexible cap from the w
Inhaltszusammenfassung zur Seite Nr. 13
Installation When Icemaker Ice is clumped together Does Not Operate When ice is clumped together, take the ice clumps out of the ice storage bin, Smoothly break them into small pieces, and then place them into the ice storage bin again. When the icemaker produces too small or clumped ice, the amount of water supplied to the ice maker must be adjusted. Contact the service center. If ice is not used frequently, it may clump together. Power failure Water may drop into the freezer compartme
Inhaltszusammenfassung zur Seite Nr. 14
Installation Height Adjustment If the freezer Level the door by inserting flat ( - type) driver into the groove of the left height adjusting screw and rotating it clockwise . compartment door is lower than the refrigerator compartment door If the freezer Level the door by inserting flat ( - type) driver into the groove of the right height compartment door adjusting screw and rotating it clockwise . is higher than the refrigerator compartment door After leveling the The refrigerator doors w
Inhaltszusammenfassung zur Seite Nr. 15
Operation Starting When your refrigerator is first installed, allow it to stabilize at normal operating temperatures for 2-3 hours prior to filling it with fresh or frozen foods. If operation is interrupted, wait 5 minutes before restarting. Adjusting The Temperatures and Functions AL DIGIT CONTROL CUBE TER FIL RESET HOLD 3 SECS TER A W LOCK 3 SECS (JET) FRZ TEMP REF TEMP CRUSH ON DISPENSER & ON BUTT DISPENSER FREEZER OR T REFRIGERA TER/LIGHT FIL LOCK 155 Mode Centigrade to Mode saving Fahr
Inhaltszusammenfassung zur Seite Nr. 16
Operation 1. Buzzer sound mute Mode The buzzer sound is set to OFF. It activates by sounding the recognition sound of “Ding~” after pressing and holding “ICE PLUS” button more than 5 seconds. It inactivates when resetting the mode power. 2. Display Power saving Mode It places display in standby mode until door is opened. Press “Freezer” and “ICE PLUS” buttons simultaneously to turn all leds ON and then OFF with the recognition sound of “Ding~” after 5 seconds. Once the mode activates, the di
Inhaltszusammenfassung zur Seite Nr. 17
Operation Operation You can adjust temperature of freezer compartment and refrigerator Compartment. Freezer Compartment temperature adjustment How to adjust the temperature in Setting the freezer temperature compartment COLDEST COLDEST COLDEST COLDEST COLDEST BAR Indication COLD COLD COLD COLD COLD How to adjust the Refrigerator Compartment temperature adjustment temperature in Setting the refrigerator temperature compartment COLDEST COLDEST COLDEST COLDEST COLDEST BAR Indication COLD COLD COL
Inhaltszusammenfassung zur Seite Nr. 18
Operation The automatic icemaker can automatically make 8 cubes at a time, Automatic Icemaker 120~150 pieces per day. This quantity may vary by circumstance, including ambient temperature, door opening, freezer load. etc. Icemaking stops when the ice storage bin is full. If you don't want to use automatic icemaker, turn the icemaker switch to OFF. If you want to use automatic ice-maker again, change the switch to ON. NOTE • It is normal that a noise is produced when ice drops into the i
Inhaltszusammenfassung zur Seite Nr. 19
Operation The Other Ambient Temperature Display Window. Functions Temperature is displayed only between 16°F ~ 120°F. ROOM TEMP Temperature less than 15°F is indicated with LO and temperature more than 121°F is indicated with HI. Door open warning A warning tone will sound 3 times at thirty-second intervals if the refrigerator or freezer door is left open for more than sixty seconds. Please contact with the local service center if warning continue to sound even after closing the door
Inhaltszusammenfassung zur Seite Nr. 20
Operation 6 Filter Condition LED There is a replacement indicator light for the (filter replacement / water filter cartridge on the dispenser. cycle) Display FILTER FILTER Water filter needs replacement once every six Function months. FILTER RESET HOLD 3SECS Filter light comes on to let you know when to replace filter. After replace the filter, press and hold the lock button more than 3seconds. FILTER RESET, HOLD 3 SECS text turn off filter light. Throw away the ice (about 20 pieces
