Inhaltszusammenfassung zur Seite Nr. 1
REFRIGERATOR
ZQS 6140
INSTRUCTION BOOKLET
2222 683-27
Inhaltszusammenfassung zur Seite Nr. 2
IMPORTANT SAFETY INFORMATION It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of safety.You MUST read it care
Inhaltszusammenfassung zur Seite Nr. 3
Disposal of old Appliances At the end of the Appliance Life The symbol on the product or on its packaging indicates that this product may not be treated as When disposing of your appliance, use an household waste. Instead it should be taken to the authorised disposal site. appropriate collection point for the recycling of Remove the plug and ensure that any locks or electrical and electronic equipment. By ensuring this catches are removed, to prevent young children product is disposed of cor
Inhaltszusammenfassung zur Seite Nr. 4
Operation Before use Fresh food refrigeration Remove all securing tapes. Wash inside the To obtain the best performance, do not store warm appliance with lukewarm water and bicarbonate of food or evaporating liquids in the refrigerator; do soda (5 ml to 0.5 litre of water). Do not use soap or cover or wrap the food, particularly if it has a strong detergent as the smell may linger. Dry thoroughly. flavour. Do not cover the shelves with any protective material, such as paper, cardboard or plastic
Inhaltszusammenfassung zur Seite Nr. 5
The door shelves Normal Operating Sounds To permit storage of food packages of various sizes You may hear faint gurgling or bubbling sounds when the half tray can be adjusted in horizontal. the refrigerant is pumped through the coils or tubing To do this proceed as figure. at the rear, to the cooling plate. When the compressor is on, the refrigerant is being pumped round, and you will hear a whirring sound or pulsating noise from the compressor. A thermostat controls the compressor, and you will
Inhaltszusammenfassung zur Seite Nr. 6
Defrosting The refrigerator automatically defrosts every time the compressor stops. The water is discharged, via the pipe, into a tray located below the appliance, where it evaporates. Important To avoid defrost water overflowing and dripping onto the food in the fridge, periodically P F clean the water discharge hole (F) situated under the salad drawers. Use the special cleaner provided (P) which you will find already inserted into the discharge hole. S.I.011 Maintenance and Cleaning 1. Remove
Inhaltszusammenfassung zur Seite Nr. 7
When the appliance is not in use When the appliance is not in use for long periods, disconnect from the electricity supply, empty all foods and clean the appliance, leaving the door ajar to prevent unpleasant smells. Something not Working? Before contacting your local Service Force Centre check the following points. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under gua
Inhaltszusammenfassung zur Seite Nr. 8
Service and Spare Parts In the event of your appliance requiring service, or if For Customer Service in Ireland please contact us at you wish to purchase spare parts, please contact the address below: your local Service Force Centre by telephoning:- Zanussi 08705 929929 Electrolux Group (Irl) Ltd Long Mile Road Dublin 12 Your telephone call will be automatically routed to the Republic of Ireland Service Force Centre covering your post code area. Tel: + 353 1 4090751 For the address of your loca
Inhaltszusammenfassung zur Seite Nr. 9
Guarantee Conditions Standard guarantee conditions We, Zanussi, undertake that if within 12 months of the date of the purchase this Zanussi appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: The appliance has been correctly installed and used only on the electricity supply stated on the rating plate. The appliance has been u
Inhaltszusammenfassung zur Seite Nr. 10
Technical Specifications DIMENSIONS Height 81,5 cm Width 59,6 cm Depth 55 cm POWER SUPPLY VOLTAGE AND FREQUENCY 230-240 V / 50 Hz TOTAL POWER ABSORBED 0,8 A AVERAGE DAILY UNITS ELECTRICITY (*) 0,40 kWh GROSS CAPACITY 142 l NET CAPACITY 138 l (*) This figure is based on standard test results in accordance with European Standard EN153. Actual consumption will depend on how the appliance is used and where it is located. Installation Warning Important IF YOU ARE DISCARDING AN OLD It must be possible
Inhaltszusammenfassung zur Seite Nr. 11
Door reversal To reverse the opening direction of the door, proceed as shown in the figures: 6 6 4 1 7 8 5 6 2 3 1 2 Attention 6 10 After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is 13 cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting. 9 6
Inhaltszusammenfassung zur Seite Nr. 12
Electrical Connection If you fit your own plug, the colours of the wires in the WARNING mains lead of your appliance, may not correspond THIS APPLIANCE MUST BE EARTHED. with the markings identifying the terminals in your The manufacturer declines any liability plug, proceed as follows: should this safety measure not be Connect the Green and the Yellow (earth) wire to the observed. terminal in the plug which is marked with the letter If the plug that is fitted to your appliance is not «E» or the
Inhaltszusammenfassung zur Seite Nr. 13
600 550 min. Building-in instructions Before carrying out any work, remove the plug from Building in the appliance under a the power socket. worktop The dimensions of the recessed installation area Grid preparation must correspond with those indicated in the figure. Left door opening: Remove the left side (A) of the grid cutting it from the rear (see figure). A B DO013 DO002/2 Installation kit Right door opening: Remove the right side (B) of the grid cutting it from 1xB 2xC the rear (see figure)
Inhaltszusammenfassung zur Seite Nr. 14
596 Left hand bracket Right hand bracket 2 2. Push the appliance into place. The plug socket necessary for connection of the appliance to the electricity supply should be positioned, so that the plug is not placed in the recess. 5. Screw appliance into place and retain the cabinet with screws (I) through the securing brackets into the worktop or adjacent woodwork as necessary. + - - + max. 890 mm 3 3. To adjust the height proceed as follows: - Loosen or tighten the two front feet.
Inhaltszusammenfassung zur Seite Nr. 15
! "
Upper part of kitchen furniture panel
!
15
Inhaltszusammenfassung zur Seite Nr. 16
25 - 80 Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to an opening height dimension B=890 mm and a plinth height dimension b=170 mm. For plinth heights greater than a=100 mm, b=170 mm, a cut should be made in the plinth, 580 mm wide, in the centre of the
Inhaltszusammenfassung zur Seite Nr. 17
Inhaltszusammenfassung zur Seite Nr. 18
Inhaltszusammenfassung zur Seite Nr. 19
Inhaltszusammenfassung zur Seite Nr. 20
www.electrolux.com www.zanussi-electrolux.co.uk © Electrolux plc 2008
