Inhaltszusammenfassung zur Seite Nr. 1
800
REAR MOUNTED BLADE
Published 01/11 Part No. 00762259C
OPERATOR’S MANUAL
This Operator's Manual is an integral part of the safe operation of this machine and must
be maintained with the unit at all times. READ, UNDERSTAND, and FOLLOW the Safety
and Operation Instructions contained in this manual before operating the equipment. C01-
Cover
®
RHINO
1020 S. Sangamon Ave.
Gibson City, IL 60936
800-446-5158
Email: parts@servis-rhino.com
© 2011 Alamo Group Inc.
$0.00
Inhaltszusammenfassung zur Seite Nr. 2
To the Owner/Operator/Dealer All implements with moving parts are potentially hazardous. There is no substitute for a cautious, safe-minded operator who recognizes the potential hazards and follows reasonable safety practices. The manufacturer has designed this implement to be used with all its safety equipment properly attached to minimize the chance of accidents. BEFORE YOU START! Read the safety messages on the implement and shown in your manual. Observe the rules of safety and common sense
Inhaltszusammenfassung zur Seite Nr. 3
TABLE OF CONTENTS SAFETY SECTION ............................................................................................................ 1-1 Safety Messages .............................................................................................................................................1-2 Decal Location .................................................................................................................................................1-9 Decal Description............
Inhaltszusammenfassung zur Seite Nr. 4
Inhaltszusammenfassung zur Seite Nr. 5
SAFETY SECTION Safety Section 1-1
Inhaltszusammenfassung zur Seite Nr. 6
SAFETY Safety Messages A careful operator is the best operator. Safety is of primary importance to the manufacturer and should be to the owner/operator. Most accidents can be avoided by being aware of your equipment, your surroundings, and observing certain precautions. The first section of this manual includes a list of Safety Messages that, if followed, will help protect the operator and bystanders from injury or death. Read and understand these Safety Messages before assembling, operating or
Inhaltszusammenfassung zur Seite Nr. 7
SAFETY SAFETY Never operate the Tractor or Implement until you have read and completely understand this Manual, the Tractor Operator’s Manual, and each of the Safety Messages found in the Manual or on the Tractor and Implement. Learn how to stop the tractor engine suddenly in an emergency. Never allow inexperienced or untrained personnel to operate the Tractor or Implement without supervision. Make sure the operator has fully read and understood the manuals prior to operation. (SG-4) Always
Inhaltszusammenfassung zur Seite Nr. 8
SAFETY Never allow children to operate, ride on, or come close to the Tractor or Implement. Usually, 16-17 year-old children who are mature and responsible can operate the implement with adult supervision, if they have read and understand the Operator’s Manuals, been trained in proper operation of the tractor and Implement, and are physically large enough to reach and operate the controls easily. (SG-11) Do not mount or dismount the Tractor while the tractor is moving. Mount the Tractor only w
Inhaltszusammenfassung zur Seite Nr. 9
SAFETY SAFETY PROLONGED EXPOSURE TO LOUD NOISE MAY CAUSE PERMANENT HEARING LOSS! Tractors with or without an Implement attached can often be noisy enough to cause permanent hearing loss. We recommend that you always wear hearing protection if the noise in the Operator’s position exceeds 80db. Noise over 85db over an extended period of time will cause severe hearing loss. Noise over 90db adjacent to the Operator over an extended period of time will cause permanent or total hearing loss. NOTE:
Inhaltszusammenfassung zur Seite Nr. 10
SAFETY Periodically inspect all moving parts for wear and replace when necessary with authorized service parts. Look for loose fasteners, worn or broken parts, and leaky or loose fittings. Make sure all pins have cotter pins and washers. Serious injury may occur from not maintaining this machine in good working order. (SG-21) Always read carefully and comply fully with the manufacturer’s instructions when handling oil, solvents, cleansers, and any other chemical agent. (SG-22) Never run the
Inhaltszusammenfassung zur Seite Nr. 11
SAFETY SAFETY Operate the Tractor and/or Implement controls only while properly seated in the Tractor seat with the seat belt securely fastened around you. Inadvertent movement of the Tractor or Implement may cause serious injury or death. (SG-29) Be particularly careful when transporting the Implement with the Tractor. Turn curves or go up hills only at a low speed and using a gradual steering angle. Rear mounted implements move the center of gravity to the rear and remove weight from the
Inhaltszusammenfassung zur Seite Nr. 12
SAFETY Rear Blades can fall down if not properly supported. Always use the stand on the front hitch or block up securely to prevent falling and possible crushing injury and/or back injury from lifting heavy components. (SBL-5) PARTS INFORMATION Rhino products are designed utilizing specifically matched system components to ensure optimum equipment performance. These parts are made and tested to Rhino specifications. Non-genuine "will fit" parts do not consistently meet these specifications. T
Inhaltszusammenfassung zur Seite Nr. 13
SAFETY SAFETY Decal Location NOTE: Rhino supplies safety decals on this product to promote safe operation. Damage to the decals may occur while in shipping, use, or reconditioning. Rhino cares about the safety of its customers, operators, and bystanders, and will replace the safety decals on this product in the field, free of charge (Some shipping and handling charges may apply). Contact your Rhino dealer to order replacement decals. 800 01/11 Safety Section 1-9 © 2011 Alamo Group Inc.
Inhaltszusammenfassung zur Seite Nr. 14
SAFETY ITEM PART NO. QTY LEVEL DESCRIPTION 1. 00725746 1 PELIGRO Translate Safety Material 2. 00760657 1 IMPORTANT Genuine Rhino Parts 3. 999000 1 WARNING Multi-Hazard, Blades 4. 999200 1 WARNING Multi-Hazard, General 5. 000678 1 INSTRUCT Grease Fitting Inside 6. 00763977 1 INSTRUCT Notice to Owner 7. D303 3 LOGO Rhino (4-3/8 x 16-3/4) 8. 00762256 1 NAME 800 Blade 9. nfs 1 SERIAL PLT Serial Plate 800 10. 03200347 * REFLECT SMV Emblem 11. 1458392 2 REFLECT Red Reflector (7’ & 8’) 12. 1458393 1 RE
Inhaltszusammenfassung zur Seite Nr. 15
SAFETY SAFETY Decal Description Peligro Translation, If you do not know how to read English, please find someone who knows how to read English. P/N 00725746 For safety and to guarantee optimum product reliability always use genuine RHINO replacement parts. P/N 00760657 WARNING!-Multi-Hazard for blades P/N 999000 WARNING!- Multiple Hazard and General Safety P/N 999200 800 01/11 Safety Section 1-11 © 2011 Alamo Group Inc.
Inhaltszusammenfassung zur Seite Nr. 16
SAFETY Slow Moving Vehicle Decal. Keep SMV reflector clean and visible. DO NOT transport or operate without the SMV. P/N 03200347 Information that Grease Fitting is present and must apply grease P/N 000678 Operator's Manual (with repair parts) and warranty was attached to this implement during final inspection. P/N 00763977 Logo Product Name: Rhino P/N D303 800 01/11 Safety Section 1-12 © 2011 Alamo Group Inc. SAFETY
Inhaltszusammenfassung zur Seite Nr. 17
SAFETY SAFETY NAME LOGO - 800 00762256 Red Reflector. Keep reflectors clean and visible. P/N 1458392 Amber Reflector. Keep reflectors clean and visible. P/N 1458393 7 FT Logo - Moldboard Dimension P/N 00785885 800 01/11 Safety Section 1-13 © 2011 Alamo Group Inc.
Inhaltszusammenfassung zur Seite Nr. 18
SAFETY 8 FT Logo - Moldboard Dimension P/N 00785886 Read Operator’s Manual! The operator’s manual is located inside this canister. If the manual is missing order one from your dealer. P/N 00776031 800 01/11 Safety Section 1-14 © 2011 Alamo Group Inc. SAFETY
Inhaltszusammenfassung zur Seite Nr. 19
SAFETY SAFETY Federal Laws and Regulations This section is intended to explain in broad terms the concept and effect of federal laws and regulations concerning employer and employee equipment operators. This section is not intended as a legal interpretation of the law and should not be considered as such. Employer-Employee Operator Regulations U.S. Public Law 91-596 (The Williams-Steiger Occupational and Health Act of 1970) OSHA This Act Seeks: “...to assure so far as possible every working man
Inhaltszusammenfassung zur Seite Nr. 20
