Bedienungsanleitung Canon Water Pump ip6000

Inhaltszusammenfassung zur Seite Nr. 1

AT Canon ip6000 CISS Instruction

Thank you for purchasing AT Continuous Ink Supply System. We appreciate your support and
will try our best to make your experience with our products a pleasant one. Printing has been a
different experience ever since you installed AT Continuous Ink Supply system on your own
printer. Just imagining being able to print without regard to the ink level in those expensive little
cartridges.

Please take your time installing AT Continuous Ink Supply system. Do

Inhaltszusammenfassung zur Seite Nr. 2

2. Installation Procedure: st 1) 1 Step: Pull the rubber plug out of the bottom tray (Picture 9). Keep the Ink Filling Hole of the ink tank opened (Picture 10). Insert it into the bottom tray as following: 1) let Point 2 slide into the tray (Picture 11). 2) Tear the other side of the tray to let the Point 1 clip into the tray (Picture 12). Make sure that the ink tank fit into the tray well (Picture 13/14). (9) (10) (11) (12) (13) (14)

Inhaltszusammenfassung zur Seite Nr. 3

After that: Put the CISS at the right side of Pull out the rubber plug from Insert the Air Filter. the printer. the Air Hole. nd 2) 2 Step: Remove the Original cartridge Open the cover and move the cartridge carriage to the below position, and then take off the Power Cord. Then take out the original cartridge. 3) 3rd step: Place the CISS cartridge Take off the cover from the CISS cartridge, and then install the CISS cartridge inside the

Inhaltszusammenfassung zur Seite Nr. 4

Clip the tube on the support arm. Take off the label on the shortest arm, and stick it on the right side of the printer. Then clip the tube through it. 5) 5th Step: Adjust the Tube length Adjust the tube length and move the cartridge carriage to the leftmost and rightmost. Make sure that there will be no block and collision when the cartridge moves. Notice: If the tube is excessive long, It is not ok. In this situation ,it is ok

Inhaltszusammenfassung zur Seite Nr. 5

6) 6th Step: Insert the power cord. Put something in the Sensor. Then turn on the power button. 7) 7th step: Check the Printer Head OK Everything is in normal You can work your print Broken lines

Inhaltszusammenfassung zur Seite Nr. 6

(Please keep the printer and the ink tank at the same horizontal level during the process of refilling ink.) Attention for maintenance: If the printer needs maintenance, pls take out the CISS including the inner cartridges and other components. Then remove support arm from printer. Then place the original cartridges in. Please inquire local dealer before sending to maintenance. Notice: 1. Please don’t take out cartridge at random after installing the CIS system. Keep the reservoir