Inhaltszusammenfassung zur Seite Nr. 1
Keeping Keeping
Keeping Keeping Keeping
America Warm Since America Warm Since America Warm Since America Warm Since America Warm Since
1869 1869 1869 1869 1869
MULTIFUEL STOVE
6039, 6039I, 6039T
OWNER’S MANUAL
Installation - Operation - Maintenance Instructions - Repair Parts
READ THIS ENTIRE MANUAL, THOROUGHLY, BEFORE ATTEMPTING TO INSTALL AND/OR
BURN YOUR NEW AMERICAN HARVEST CORN AND PELLET MULTI-FUEL STOVE. FAILURE TO
FOLLOW THESE INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE, BODILY INJURIES
O
Inhaltszusammenfassung zur Seite Nr. 2
CONGRATULATIONS! You've purchased one of America's Finest Multifuel Burning Stoves. By heating with fuels such as corn and pellets, you're helping CONSERVE AMERICA'S ENERGY! NOTE: YOUR UNIT MUST BE INSTALLED BY A QUALIFIED INSTALLER, such as an NFI Certified Specialist We strongly suggest installing smoke detectors in your home if not already installed. Initial burn off may cause slight smoke and odor the first few hours of operation. Perform initial burn outside if possible SPECIFICATIONS Un
Inhaltszusammenfassung zur Seite Nr. 3
ASSEMBLY 1. The Auger is packed in the hopper or ash pan and must be installed properly as illustrated below. 2. Insert the Auger into the auger tube. Rotate the auger until it fits into the coupling that is already installed on the auger motor drive. Seat the auger firmly. The Auger cannot be turned by hand once installed properly. 6039 PEDESTAL TRIM ASSEMBLY Assemble trim pieces as shown with the screws provided in the parts bag. After trim assembly, attach to the pedestal base at the loca
Inhaltszusammenfassung zur Seite Nr. 4
4 B 6039I ASSEMBLY DISCONNECT THE POWER CORD BEFORE SERVICING THIS STOVE For the following assemblies, we suggest locating the unit near it’s desired location. Depending on installation, you may want to connect the exhaust venting before installing the facade parts. (a) Assembly - Facade (Surround) Remove contents from packaging and make sure you have all (a) (b) components: (2) Top Facade (a) (1) Left Side Facade (b) (1) Right Side Facade (c) (4 pieces)Facade Trim Kit (d) (1) Feed Door Spring
Inhaltszusammenfassung zur Seite Nr. 5
COMPONENT LOCATION USSC 5
Inhaltszusammenfassung zur Seite Nr. 6
SAFETY STEPS IMPORTANT: Proper installation of this stove is necessary for safe and efficient operation. Installing this product improperly may result in a house fire and personal injury. All applicable building codes for your location must be followed. In areas where building codes require additional steps to the installation of this product not included in this manual, the building codes will take precedent and must be followed. Contact your local building inspector to obtain any necessary
Inhaltszusammenfassung zur Seite Nr. 7
BURNING SOLID FUELS continued... SHELLED CORN (Dry, preferably corn with 11- 12% moisture content) • Corn must contain less than 14% moisture content. Wet corn will rapidly deteriorate stove components, reduce efficiency and void all warranties. Purchase a moisture tester if in doubt. • Corn must be clean and free from debris. Never burn corn right from the field. Damage caused by dirty corn is not covered by the product warranty. Ask for clean filtered bagged corn only. Stalk parts, exces
Inhaltszusammenfassung zur Seite Nr. 8
CLEARANCES TO COMBUSTIBLES 6039(T) The stove must be installed with the following minimum clearances to side and back wall combustible materials. NOTE: These are minimum clearances to combustible walls established by the testing lab. PARALLEL - A - Sidewall to Top Edge of Unit 8 in./203mm B - Sidewall to Flue 13 in./330mm C - Backwall to Flue 3 in./75mm D - Backwall to Unit 9 in./228mm CORNER - E - Adjacent Wall to Flue 3 in./75mm F - Adjacent Wall to Unit 4 in./100mm BACK WALL BACK WALL Backwa
Inhaltszusammenfassung zur Seite Nr. 9
CLEARANCES TO COMBUSTIBLES 6039I USSC 9
Inhaltszusammenfassung zur Seite Nr. 10
GUIDELINES FOR EXHAUST VENTING SYSTEMS DESIGN It is recommended that only an authorized installer install your pellet/corn stove, preferably an NFI certified specialist. The following installation guidelines must be followed to ensure conformity with both the safety listing of this stove and to local building codes. INSTALL VENT AT CLEARANCES SPECIFIED BY THE VENT MANUFACTURER. • A UL listed 3” or 4” type “PL” pellet vent exhaust system must be used for installation and attached to the pipe co
Inhaltszusammenfassung zur Seite Nr. 11
DESIGN GUIDELINES FOR OUTSIDE COMBUSTION AIR CONNECTION 1) For installations with horizontal through-the-wall exhaust, it is strongly recommended that the stove combustion air be connected to the outside. If the home is newer or has been tightly insulated, it is required to install outside combustion air. 2) Connection to outside the house is REQUIRED for mobile home installations. We strongly urge use of the 69FAK Fresh Air Kit. 90 DEGREE BEND TERMINATION WIND HOOD TERMINATION Wind Hood 2” Mi
Inhaltszusammenfassung zur Seite Nr. 12
INSTALLATION CONFIGURATIONS Note: Where passage through a wall, or partition of combustible construction is desired, the installation shall conform to CAN/CSA -B365 The American Harvest Multifuel Stove Model 6039/6039T may be installed as follows: 1) A freestanding unit The American Harvest Multifuel Stove Model 6039I insert may be installed as follows: 1) In a pre-fab firebox (Factory Built) 2) In an existing masonry fireplace 3) As a build-in MOBILE HOME INSTALLATION REQUIREMENTS IN ADDIT
Inhaltszusammenfassung zur Seite Nr. 13
Note: Always check dimensions on unit before cutting hole in wall 3" PL Vent Termination Cap 3" PL Vent 90° Elbow 3" PL Vent (12" Long) 3" PL Tee w/ Cleanout 3" PL Vent (12" Long) 3’ Minimum 3" PL Vent (12" Long) Outer Wall Thimble Vertical Pipe Inner Wall Thimble 6039 - PEDESTAL UNIT 6039T - LEG UNIT COMBUSTION EXHAUST OUTLET COMBUSTION EXHAUST OULET 10 1/16 AIR INTAKE 10 1/16 AIR INTAKE 3' DIA 3" DIA. 1 7/8" DIA. 1 7/8" DIA 12 1/8 12 11 3/4 11 5/8 Dimensional tolerance ±1/4” USSC 13
Inhaltszusammenfassung zur Seite Nr. 14
THROUGH THE WALL, VERTICAL PIPE INSTALLATION WITH TERMINATION CAP The Hearth Pad is not required under the unit if the floor is noncombustible but is required 6 inches (152mm) beyond the front of the unit and 6 inches (152mm) beyond each side of the door if the floor is a combustble floor. wood flooring, carpet, linoleum, etc. 14 USSC
Inhaltszusammenfassung zur Seite Nr. 15
DESIGN GUIDELINES FOR 6039I INSERT INSTALLATION INSTALLATION AS A BUILT-IN FIREPLACE A continuous sheet of non-combustible floor protection must be installed underneath the unit to prevent the possibility of embers falling through to the combustible floor. If the floor beneath the unit is of non-combustible material, the protector is not required. See the “Clearance to Combustibles” section of this manual for installation clearances. Alternative Exhaust Venting Depending on your installtion, yo
Inhaltszusammenfassung zur Seite Nr. 16
DESIGN GUIDELINES FOR 6039I INSERT INSTALLATION INSTALLATION INTO A MASONRY FIREPLACE When installing into a masonry fireplace, DO NOT remove any bricks or masonry, with the following exception: masonry or steel, including the damper plate, may be removed from the smoke shelf and adjacent damper frame, if necessary, to accom- modate a chimney liner. Do this only if their re- moval will not weaken the structure of the fire- place or the chimney, and will not reduce protec- tion for combustibles
Inhaltszusammenfassung zur Seite Nr. 17
GLASS MAINTENANCE, REMOVAL AND REPLACEMENT Your American Harvest Multifuel Stove comes to you with the glass door installed in place, ready for use. The glass is surrounded on the edges with a gasket and seated in a glass channel. It is held in place with two (2) clips. REMOVAL OF BROKEN OR DAMAGED CERAMIC GLASS Open the door and lift off of hinges. If the door is tight, tap gently on the bottom of the door with your hand or rubber hammer. Lay door down on newspaper with glass clips facing y
Inhaltszusammenfassung zur Seite Nr. 18
UNDERSTANDING THE CONTROL BOARD CONTROL PANEL Turning the heater OFF/ON, as well as adjustments for the fuel feed rate and room fan speed are performed by pressing the appropriate button(s) on the control panel which is located on the lower left-hand American Harvest heater. The insert model 6039I is side of your located on the left facade. This unit can be changed between an automatic operation or a manual operation. The controller comes default in the automatic mode. Pressing the “ON” butto
Inhaltszusammenfassung zur Seite Nr. 19
LIGHTING INSTRUCTIONS CAUTION: DO NOT USE CHEMICALS OR FLUIDS TO START THE FIRE HOT WHILE IN OPERATION. KEEP CHILDREN, CLOTHING AND FURNITURE AWAY. CONTACT MAY CAUSE SKIN BURNS. Before lighting your heater for the first time, make sure that all items are out of the hopper, ash pan and firebox area. Press the “On” button and allow your heater to run for at least 4 minutes, to check for proper operation. Once your heater is started, you will notice the draft fan starts immediately. If you press
Inhaltszusammenfassung zur Seite Nr. 20
DISPOSAL OF ASHES Disposal of Ashes Ashes should be placed in a metal container with a tight fitting lid. The closed container of ashes should be placed on a noncombustible floor or on the ground, well away from all combustible materials, pending final disposal. If the ashes are disposed of by burial in soil or otherwise locally dispersed, they should be retained in the closed container until all cinders have been thoroughly cooled. MAINTENANCE INSTRUCTIONS Soot and Flyash - Formation and Need
